ページ1に含まれる内容の要旨
bahia · cayman · lagunas · palermo
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Table of Contents 1.0 Important Spa Owner Information ..........................................1 2.0 FCC Notice......................................................................................1 3.0 Important Safety Instructions...................................................2 3.1 Important CSA Safety Instructions (Canada Only)............................3 3.2 Hyperthermia....................................................................................................4 3.3 Cautions...
ページ4に含まれる内容の要旨
11.0 Spa Maintenance .......................................................................20 1 1.1Cleaning The Filter.......................................................................................20 1 1.2Draining and Refilling..................................................................................21 1 1.3Cleaning The Spa Interior.........................................................................22 1 1.4 Pillow Care .......................................................
ページ5に含まれる内容の要旨
1.0 Important Spa Owner Information Your new Sundance 780 Series Spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for efficient operation, an uncovered acrylic spa surface directly exposed to sunlight and high tem- peratures for an extended period is subject to permanent damage. Damage caused by exposing the spa to this abuse is not covered by warranty. We rec- ommend
ページ6に含まれる内容の要旨
3.0 Important Safety Instructions When installing and using this electrical equipment, basic safety pre- cautions should always be followed, including: 1. READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THE SPA! 2. WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. 3. WARNING: A grounding wire connector is provided on this unit to con- 2 nect a minimum No. 8 AWG (8.4mm ) solid copper conductor between this unit an
ページ7に含まれる内容の要旨
B. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possibly preg- nant women should limit spa water temperatures to 100 °F (38 °C). If pregnant, please consult your physician before using a spa. C. Before entering the spa, the user should measure the water temperature with an accurate thermometer since the tolerance of water temperature- regulating devices may vary as much as +/- 5 °F (2 °C). D. The use of alcoho
ページ8に含まれる内容の要旨
C. WARNING: People with infectious diseases should not use a spa. D. WARNING: To avoid injury, exercise care when entering or exiting the spa. E. WARNING: Do not use drugs or alcohol before or during the use of a spa to avoid unconsciousness and possible drowning. F. WARNING: Pregnant or possibly pregnant women should consult a physician before using a spa. G. WARNING: Water temperature in excess of 38 °C (104 °F) may be injurious to your health. H. WARNING: Before entering the spa, measure
ページ9に含まれる内容の要旨
2. The Consumer Products Safety Commission has stated that the water temperature in a spa should not exceed 104 °F (40 °C). Immersion in water in excess of 104 °F (40 °C) can be hazardous to your health. 3. Observe a reasonable time limit when using the spa. Long exposures at higher temperatures can cause high body temperature. Symptoms may include dizziness, nausea, fainting, drowsiness, and reduced awareness. These effects could possibly result in drowning. 4. Do not use the spa under the inf
ページ10に含まれる内容の要旨
120/240 Volt Lagunas Convertible Models A spa connected to a 120 VAC electrical service must be located close enough to a grounded, grounding-type electrical outlet so that the included power cord can be plugged directly into it. DO NOT USE AN EXTENSION CORD as this could cause damage to the spa’s equipment due to insufficient voltage. The power supplied to this spa must be a dedicated circuit with no other appliances or lights sharing the power provided by the circuit. 4.0 Choosing A Locati
ページ11に含まれる内容の要旨
3. The closeness to trees and shrubbery (remember that leaves and birds could create extra work in keeping the spa clean). 4. A sheltered environment (less wind and weather exposure can result in lowered operation and maintenance costs). 5. The overall enhancement of your environment. It is preferable not to place the spa under an unguttered roof overhang since run-off water will shorten the life expectancy of the spa cover. 4.2 Indoor Location For indoor installations, be certain to make pr
ページ12に含まれる内容の要旨
5.0 Power Requirements Sundance spas are designed to provide optimum performance and flexibility of use when connected to the maximum electrical service listed in the tables below. If you prefer, your dealer can perform a minor circuit board modification to allow your spa to accept an electrical service other than the factory setting. US/Canada Lagunas Convertible Models (60Hz) 120V/15A* 240V/30A* 240V/40A** Voltage: 120 VAC 240 VAC 240 VAC # of Wires: 3 (15A GFCI Cord) 4 4 Frequency: 60Hz 60Hz
ページ13に含まれる内容の要旨
US/Canada 2-Pump Palermo / Bahia Models (60Hz) 240V/50A* 240V/30A** 240V/60A*** Voltage: 240 VAC 240 VAC 240 VAC # of Wires: 3 3 3 Frequency: 60Hz 60Hz 60Hz Current Draw: 36A 24A 43A Circuit Breaker: 50A, 2-Pole 30A, 2-Pole 60A, 2-Pole * In 50A configuration, the heater will not operate while both jets pumps are running in high speed. Note: pump 2 runs only in high speed. This is the factory setting. ** In 30A configuration, the heater will not operate while either jets pump is running in hig
ページ14に含まれる内容の要旨
6.0 Electrical Wiring Instructions IMPORTANT NOTICE: The electrical wiring of this spa must meet the requirements of the National Electrical Code (NEC) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local build- ing/electrical inspection authority. 1. Convertible 120/240V Power Lagunas Models Only: A. 120V “Plug-in” Operation: This spa must operate on the supplied 120V GFCI cord at its original length or must be har
ページ15に含まれる内容の要旨
securing the cabinet panel on the side of the spa under the controls. Then remove the four control box door screws and door (Figure B). 8. Select the power supply inlet you want to use (Figure A). Feed power cable to control box, then install it through the large opening provided in the bottom side of the box. 9. Connect wires, color to color, on terminal blocks TB1 and TB3 (Figures C-F, Page 12). TIGHTEN SECURELY! All wires must be hooked up secure- ly or damage could result. 10. Install c
ページ16に含まれる内容の要旨
7.0 Start-Up Instructions Congratulations! You are now all set to get your new spa ready to use. Simply follow this step-by-step procedure and, before long, you will be enjoying your first glorious experience in your Sundance 780 Series Spa. For best results, read each step in its entirety before proceeding with that step. 7.1 Filling the Spa Clear all debris from the spa. Although the spa shell has been polished at the factory, you may want to treat it with a specially formulated spa clean
ページ17に含まれる内容の要旨
may fill entirely with hard water if you use a special water additive available from your Sundance dealer. Always refill with garden hose in filter compartment. This helps to purge trapped air from pump intakes. Failure to do so may cause air to be trapped in either pump 1 or the circulation pump’s intake (air lock), preventing either pump from circulating water. After filling, make sure the filter is installed properly before applying power to the spa. Refer to section 1 1.1 (Page 20-2
ページ18に含まれる内容の要旨
8.0 Control Functions 8.1 Control Panel A. LED Display: can display current water temperature (default display), water temperature setpoint, E selected skimming/heating mode, A B C D F and error messages. G B. Heat Indicator: lit when heater is on. C. Warmer ( + ) Button: increases water temperature setpoint. D. Cooler ( - ) Button: decreases water temperature setpoint. E. Jets 1 Button: turns jets pump #1 on and off. Press once for low speed; press a second time for high speed; press a t
ページ19に含まれる内容の要旨
8.2 General Spa Features And Controls 4a 3b 4b 5 4c 6 6 6 3a 3c 11 8 6 11 9 12 10 7 6 2 4d 1 3d 13 Palermo model illustrated - Jet Locations and Features Will Vary by Model 1. Control Panel 9. Heater Return Fitting 2. Filter 10. Spa Light 3. Air Controls (3a-3d) 1 1. Suction Fittings and 4. Pillows (4a-4d) Filters. 5 Diverter Valve 12. Floor Gravity Drain 6. Therapy Jets (Outer ring 13.Optional Audio System adjusts volume, nozzle (Palermo* & Bahia** Only) adjusts flow stream angle) 7. Vertical
ページ20に含まれる内容の要旨
9.0 Operating Instructions The spa control system has automatic functions that operate 1. upon startup and normal operation to protect the system. Upon power up, the readout displays the following information: 2. 1. Control panel displays current software release (e.g. 3.56), then; 3. 2. Control panel displays “888” and all indicator LEDs are lit, permitting visual inspection of all display segments and indicator lights for proper operation. 3. After the initial start-up sequence ends, the ac
