ページ1に含まれる内容の要旨
TM
2003+ ProTech LCD Series Owner’s Manual
ページ2に含まれる内容の要旨
Attention New Spa Owner! Congratulations on the purchase of your new Jacuzzi Premium spa! The following is a list of automated functions performed by your spa. These functions are listed below in an attempt to suppress any operational con- cerns you may have during the first 24-hours of ownership! Also listed below are important maintenance recommendations you should observe on a regular basis to protect your new investment. Automated Operations Your new spa is equipped with an automated “blo
ページ3に含まれる内容の要旨
Table of Contents 1.0 Important Spa Owner Information ..........................................1 2.0 FCC Notice......................................................................................1 3.0 Important Safety Instructions...................................................2 3.1 Important CSA Safety Instructions (Canada Only) ..........................3 3.2 Hyperthermia....................................................................................................4 3.3 Cautions....
ページ4に含まれる内容の要旨
9.10 Air Controls......................................................................................................19 9.11 Optional Jacuzzi Premium Audio System ..........................................19 10.0 Automatic Filtration Cycles.....................................................28 10.1 Standard Skimming/Heating Mode.....................................................28 10.2 Economy Skimming/Heating Mode.....................................................28 10.3 Selecting Standa
ページ5に含まれる内容の要旨
1.0 Important Spa Owner Information Your Jacuzzi® Premium spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for efficient operation, an uncovered spa surface directly exposed to sunlight and high temperatures for an extended period is subject to permanent damage. Damage caused by exposing the spa to this abuse is not covered by warranty. We recommend that you always k
ページ6に含まれる内容の要旨
3.0 IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety pre- cautions should always be followed, including: 1. READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THE SPA! 2. WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. 3. WARNING: A grounding wire connector is provided on this unit to con- 2 nect a minimum No. 8 AWG (8.4mm ) solid copper conductor between this unit a
ページ7に含まれる内容の要旨
B. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possibly preg- nant women should limit spa water temperatures to 100 °F (38 °C). If pregnant, please consult your physician before using a spa. C. Before entering the spa, the user should measure the water temperature with an accurate thermometer since the tolerance of water temperature- regulating devices may vary as much as ±5 °F (±2 °C). D. The use of alcohol,
ページ8に含まれる内容の要旨
C. WARNING: People with infectious diseases should not use a spa. D. WARNING: To avoid injury, exercise care when entering or exiting the spa. E. WARNING: Do not use drugs or alcohol before or during the use of a spa to avoid unconsciousness and possible drowning. F. WARNING: Pregnant or possibly pregnant women should consult a physician before using a spa. G. WARNING: Water temperature in excess of 38 °C (104 °F) may be injurious to your health. H. WARNING: Before entering the spa, measure
ページ9に含まれる内容の要旨
2. The Consumer Products Safety Commission has stated that the water temperature in a spa should not exceed 104 °F (40 °C). Immersion in water in excess of 104 °F (40 °C) can be hazardous to your health. 3. Observe a reasonable time limit when using the spa. Long exposures at higher temperatures can cause high body temperature. Symptoms may include dizziness, nausea, fainting, drowsiness, and reduced awareness. These effects could possibly result in drowning. 4. Do not use the spa under the inf
ページ10に含まれる内容の要旨
4.0 Choosing A Location IMPORTANT: Because of the combined weight of the spa, water and users, it is extremely important that the base upon which the spa rests be smooth, flat, level and capable of uniformly supporting this weight, without shifting or settling, for the entire time the spa is in place. If the spa is placed on a surface which does not meet these requirements, dam- age to the skirt and/or the spa shell may result. Damage caused by improp- er support is not covered under warranty.
ページ11に含まれる内容の要旨
5.0 Power Requirements Jacuzzi Premium spas are designed to provide optimum performance and flexibility of use when connected to the maximum electrical service as listed in the tables below. If you prefer, your Jacuzzi Premium dealer can perform a minor circuit board modification to allow the spa to accept different electri- cal service. The operational considerations of these modifications are listed in the footnotes below. US/Canada J-350/J-360/J-370 Models (60Hz) 240V/50A* 240V/60A** 240V/
ページ12に含まれる内容の要旨
Export J-350/J-360/J-370 Models (50Hz) 230V/20A* 230V/30A** 230V/40A*** Voltage: 230 VAC 230 VAC 230 VAC Number of Wires 3 3 3 Frequency: 50Hz 50Hz 50Hz Current Draw: 15A 23A 29A Circuit Breaker: 20A 30A 40A Important Information: * In 20A configuration, the heater will not operate while either jets pump is running in high speed. Note: jets pump 2 runs only in high speed. This is the factory setting. ** In 30A configuration, the heater will not operate when both jets pumps are running in h
ページ13に含まれる内容の要旨
6.0 Electrical Wiring Instructions IMPORTANT NOTICE: The electrical wiring of this spa must meet the requirements of the National Electrical Code (NEC) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local build- ing/electrical inspection authority. 1. This spa must be permanently connected (hard-wired) to the power supply. No plug-in connections or extension cords are to be used in conjunction with the operation of
ページ14に含まれる内容の要旨
Figure-A Equipment Area Note: Pump Locations Vary by Model 9 4 10 1 Flow 7 3 5 6 6 2 2 Circulation Pump 8 1. Control Box Behind Load Box 7. 1-Speed Pump #2 2. Power Supply Entrance(s) 3. 2-Speed Pump #1 8. Circulation Pump 9. Optional CD Ozonator (Purchased Separately) 4. Heater 10.Optional Mazzei Injector (Required for CD Ozonator 5. Spa Drain Valve Use - Purchased Separately) 6. Pump Drain Plug(s) Figure-B - Control Box 2 TB1 1 1. Terminal Block 2. Bonding Lug 3. Grounding Terminal 3 RED
ページ15に含まれる内容の要旨
7.0 Start-Up Instructions Congratulations! You are now all set to get your new spa ready to use. Simply follow this step-by-step procedure and, before long, you will be enjoying your first glorious experience in your Jacuzzi Premium spa. For best results, read each step in its entirety before proceeding with that step. 7.1 Filling the Spa Clear all debris from the spa. Although the spa shell has been polished at the factory, you may want to treat it with a specially formulated spa cleaner
ページ16に含まれる内容の要旨
7.5 Add Start-Up Chemicals Add the spa water chemicals as recommended by your Jacuzzi Premium Dealer. Refer to section 13.0 (Page 39) for general guidance. 7.6 Place Cover On Spa Keeping the insulating cover in place anytime the spa is not in use will reduce the time required for heating, thereby minimizing operating costs. The time required for initial heat-up will vary depending on the starting water temperature and the capacity of your spa. Smaller spas heat at a rate of approximately 8 to
ページ17に含まれる内容の要旨
8.2 LCD Display A B C D E CHANGE F J FILTER G H I A. Lock Symbol indicates panel, set temperature, or filter cycle programming is locked. B. Heat Symbol: indicates heater is on (Sec. 9.1, Page 17). C. Ozone Symbol indicates the optional CD Ozonator is on Sec. 13.3, Page 40). D. General Indicators: show which skimming/heating cycle is in progress or display selected skimming/heating cycle programming features (Sec. 1 1.2, Page 30). E. Set Indicators: these characters identify what is being show
ページ18に含まれる内容の要旨
8.3 Spa Features And Controls 8 17 2 13 6 9 2 4 7 15 5 11 14 6 3 12 11 2 16 6 5 10 17 1 18 J-370 model illustrated - Location of Features Varies by Model 1. Control Panel 1 1. Vertical Jets (Foot Jets) 2. Air Controls 12. Footwell Suction Fittings and 3. Filter/Skimmer Bag Filters. Filters protect pump 2 Cover (and J-380 pump 3) plumbing 4. Diverter Valve #2 network from debris buildup. 5. Maxx PowerPro Jets 13.Waterfall Feature 6. PowerPro Jets/Mini- 14. Mini PowerPro Jets (Calf Jets) PowerPr
ページ19に含まれる内容の要旨
8.4 Jet/Air Controls Diagram (J-380 & J-370) Air Control Operation Air Control Operation Depress Air Controls A-E to Open or Depress Air Controls A-E to Open or Close Air Inlet to Designated Jet Groups. Close Air Inlet to Designated Jet Groups. Page 15
ページ20に含まれる内容の要旨
8.5 Jet/Air Controls Diagram (J-360 & J-350) Air Control Operation Air Control Operation Depress Air Controls A-D to Open or Depress Air Controls A-D to Open or Close Air Inlet to Designated Jet Groups. Close Air Inlet to Designated Jet Groups. Page 16
