ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Contents Getting Started ......................1 Calendar .............................. 41 Fitting and removing the battery 1 New event ............................... 41 Fitting and removing the SIM ....3 View event............................... 42 Charging the battery..................3 Key Guard ........................... 43 Battery level indicator ................4 Messages Menu .................. 44 Low battery power warning .......4 Create ..................................... 45 Your p
ページ3に含まれる内容の要旨
ii Contents
ページ4に含まれる内容の要旨
Getting Started Fitting and removing the battery Before removing the battery, ensure that the phone is switched off and the charger is disconnected from the phone. Fitting the battery — A100 1 2 1 2 Remove the battery compartment cover. Insert the battery ensuring the 3 gold contacts align with the 3 gold pins in the phone. When replacing the cover, ensure to slide upward to the top of the phone. Removing the battery — A100 1 2 Push and hold the release latch ➊ towards the top of the phone us
ページ5に含まれる内容の要旨
Fitting the battery — A101 Remove the battery compartment cover. Insert the battery ensuring the 3 gold contacts align with the 3 gold pins in the phone. When replacing the cover, ensure to slide upward to the top of the phone. Removing the battery — A101 1 Push and hold the release latch ➊ towards the top of the phone using the cover clip, then lift the battery out ➋. 2 Getting Started
ページ6に含まれる内容の要旨
Fitting and removing the SIM The SIM is located under the battery. Fitting the SIM — A100 Removing the SIM — A100 Ensure the gold contacts are facing While holding the tab down, slide downwards before sliding the SIM the SIM out. into the SIM holder. Fitting the SIM — A101 Removing the SIM — A101 Ensure the gold contacts are facing While holding the tab down, slide downwards before sliding the SIM the SIM out. into the SIM holder. Charging the battery Connecting and disconnecting the Travel Ch
ページ7に含まれる内容の要旨
charger to the mains outlet. Once connected, the Battery level indicator will start scrolling (see “Battery level indicator” on page 4). It is recommended to charge the battery for a minimum of 4 hours before first use. NOTE: DO NOT force the connector as this may damage the phone and/or the charger. If the battery has been deeply discharged, it may take several minutes before the Battery level indicator is displayed. When charging is complete, disconnect the charger from the outlet before
ページ8に含まれる内容の要旨
Your phone — A100 Earpiece Personal Hands Free Connector Display Navigation Key Scroll/move through menus Right Soft Key Left Soft Key Cancel/exit Perform functions Perform functions indicated in the left indicated in the right display corner display corner Send Key Power/End Key Answer/make a call Press and hold to switch your phone on/off Silent Mode Key Press and hold to switch Charging Connector Silent Mode on/off Getting Started 5
ページ9に含まれる内容の要旨
Your phone — A101 Earpiece Personal Hands Free Connector Display Navigation Key Scroll/move through menus Right Soft Key Left Soft Key Cancel/exit Perform functions Perform functions indicated in the left indicated in the right display corner display corner Send Key Power/End Key Answer/make a call Press and hold to switch your phone on/off Silent Mode Key Press and hold to switch Silent Mode on/off Charging Connector 6 Getting Started
ページ10に含まれる内容の要旨
Key functions A100 Key A101 Key Function Navigation Key: Scroll or move through menus, text and 4 phone numbers. 4 In idle mode, press to display the “Contacts” menu. Left Soft Key: Perform the functions displayed in the lower left corner. A A In idle mode, press to activate the “Menu” display, or press and hold to activate the “Profiles” menu. Right Soft Key/Cancel or Exit Key: Perform the functions displayed in the lower right corner. Mainly used to cancel and return to the previous men
ページ11に含まれる内容の要旨
During a call Minimal menu options are available during a call by pressing the following key options. A100 Key A101 Key Function Activate Hands free, Conference call, Call transfer, A A Contacts list, Messages menu, Call status. Swap between two calls. Put the call on hold. @ @ Increase the volume while on a call. 1 1 Decrease the volume while on a call. 5 5 Display the last dialled records list. Answer another call. If C C a phone number is entered, hold the active call and call the numbe
ページ12に含まれる内容の要旨
Displays Idle display The clock appears on the display one minute after you press the last key. The clock position changes every minute. NOTE: All screen images in this manual are simulated. NOTE: Some services described in this manual are network dependent or may only be available on a subscription basis. Some functions are SIM dependent. For more information, contact your service provider. Getting Started 9
ページ13に含まれる内容の要旨
Status icons The status icons are displayed or animated according to the currently activated functions. The Antenna, Signal and Battery icons are displayed when the handset is switched on and connected to a network. If there is no connection with the network, the Signal icon will not be displayed. Icon Meaning Antenna and signal strength OP Registered to a non-home network – roaming Call Diverts is on G Key Guard is enabled L Message area is full Unread message is stored (Flashing) Voice mail
ページ14に含まれる内容の要旨
Symbols in the Manual A100 A101 Meaning Symbols Symbols 154 Press the Navigation Key in the direction indicated by 154 the arrow A Press Left Soft Key A @ Press Right Soft Key @ #~, #~, Press numeric Keys C Press Send Key C D D Press Power/End Key " Press Asterisk Key " ! Press Silent Mode Key ! Symbols used throughout the manual are based on the A100. Getting Started 11
ページ15に含まれる内容の要旨
Basic Operations Switching the phone on/off 1. Press and hold D for 2 to 3 seconds 2. The phone starts in idle mode 3. Press and hold D again to switch the power off Making a call Ensure that the signal strength meter shows network coverage is available in the current area. To make a call, start in idle mode. Standard dialling 1. Enter the area code and phone number C The dialled number is displayed 2. When the other party answers, talk into the Microphone Earpiece Volume: During a call, 4 t
ページ16に含まれる内容の要旨
International dialling The international access code (+) and the destination country/region code should be entered, followed by the area code and phone number. 1. Press and hold # until “+” is displayed, then enter the country / region code 2. Enter the area code and phone number C NOTE: Many countries/regions include an initial “0” in the area code. This should, in most cases, be omitted when dialling international numbers. If you have difficulties making international calls, contact your
ページ17に含まれる内容の要旨
Answering a call C OR If “Any key answer” is on, From idle mode press any key except D. (See “Any key answer” on page 30.) Volume: From My Phone 1.4 Sounds >Volume A(Select) 2.4 Adjust the volume level A(OK) Quick touch silent mode: To quickly set the ringtone off ( ) and the vibrator on ( ), press and hold !. To resume, press and hold ! again. One click mute on incoming call: To set the ring tone off, @(Mute) •If you want to reply to the call, A(Reply) •If you want to reject the call, @(R
ページ18に含まれる内容の要旨
In-call operations During a call, the following options are available by pressing A(Menu) or @(Hold) Hands free/Hand held You can switch the phone between hands free and hand held. During a call: 1.A(Menu) 2.4 Hands free / Hand held A(Select) Contacts You can access your Contacts list that is stored in SIM in your phone. During a call: 1.A(Menu) 2.4 Contacts A(Select) Messages You can create, check, or send a message while on a call. See “Messages Menu” on page 44. During a call: 1.A(Menu) 2
ページ19に含まれる内容の要旨
Hold You can put a call on hold. During a call: @(Hold) To resume: A(Back) NOTE: This function is network dependent. Making a second call During a call: 1. Enter the second phone number or select a phone number from the Contacts list (see “Contacts” on page 15). 2.C The first call is put on hold NOTE: This function is network dependent. 16 Basic Operations
ページ20に含まれる内容の要旨
Incoming call while on a call NOTE: Call waiting must be on – see “Call waiting” on page 56 This function is network dependent. During a call, you may receive another call. 1. To answer another call, C (First call is placed on hold.) To disconnect another call, A(Reject) 2. During a conversation with a second caller, @(Swap) or A(Menu) and select one of the following options: Conference You can make a conference call with up to 5 parties During a call: 1.A(Menu) 2.4 Conference A(Select) NOTE:
