ページ1に含まれる内容の要旨
Snapshot
LX10™
OK on Dimmer
Outdoor OK
Sound Activated
DMX512
Master/Slave
115V/230V Switch
Replaceable Fuse
User Serviceable
Duty Cycle
USER MANUAL
Chauvet, 5200 NW 108th Avenue, Sunrise, FL 33351 U.S.A.
(800) 762-1084 – (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
ページ2に含まれる内容の要旨
TABLE OF CONTENTS 1. BEFORE YOU BEGIN............................................................................................................................................................ 3 WHAT IS INCLUDED ...................................................................................................................................................................... 3 UNPACKING INSTRUCTIONS ..........................................................................................
ページ3に含まれる内容の要旨
1. BEFORE YOU BEGIN What is included Ø 1 x LX10™ Ø Power Cord Ø Warranty Card Ø User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materia
ページ4に含まれる内容の要旨
Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. · Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. · Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel
ページ5に含まれる内容の要旨
2. INTRODUCTION Features · LED moonflower effect · Mirror scans 180° · Selectable functions: sound, rotating, static · Additional power output for daisy chaining units (max 50 units) · Sound sensitivity knob · Ultra bright LEDs · Low power consumption Product Overview M ounting Bracket Scanning Mirror Lens Connection Panel (rear) 110/230V Selector Switch Sound Sensitivity Mode Adjustment Knob Selector Swit
ページ6に含まれる内容の要旨
3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement With a flat head screwdriver wedge the fuse The fuse is located holder out of its housing. Remove the damaged inside this compartment. fuse from its holder and replace with exact Remove using a flat same type fuse. Insert the fuse holder back in head screwdriver. its place and reconnect power. Mounting ORIENTATION This fixture may be mounte
ページ7に含まれる内容の要旨
4. OPERATING INSTRUCTIONS The LX10 can operate in Sound-Active, Auto, or static mode. The mode is determined by the position of the switch located on the rear of the unit. To switch between the three modes, place the switch in either the “I” or “II” position for movement or “O” for static operation. In the “II” position, the fixture operates in Sound-Active mode, the sensitivity of which can be adjusted by the knob also located on the rear of the unit. To increase the sensitivity o
ページ8に含まれる内容の要旨
General Troubleshooting Applies to Foggers Dimmers Symptom Solution(s) Lights & Snow Controllers & Chaser Auto shut off Check fan thermal switch reset ü Beam is very dim or not Clean optical system or replace lamp ü bright Check 220/110v switch for proper setting Breaker/Fuse keeps Check total load placed on device ü blowing Chase is too slow Check users manual for speed adjustment ü ü ü Device has no power Check for power on Mains. ü ü ü Check device’s fuse. (internal
ページ9に含まれる内容の要旨
General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power. Use a vacuum o
ページ10に含まれる内容の要旨
Technical Specifications WEIGHT & DIMENSIONS Length .............................................................................................................................. 15.5 in (394 mm) Width .................................................................................................................................. 5.3 in (135 mm) Height ................................................................................................................................. 8.5 in (21
