ページ1に含まれる内容の要旨
Photometric Analyzer
OPERATING INSTRUCTIONS
Model 5000B
Photometric Analyzer
DANGER
HIGHLY TOXIC AND OR FLAMMABLE LIQUIDS OR GASES MAY BE PRESENT IN THIS MONITORING SYSTEM.
PERSONAL PROTECTIVE EQUIPMENT MAY BE REQUIRED WHEN SERVICING THIS SYSTEM.
M5000B
HAZARDOUS VOLTAGES EXIST ON CERTAIN COMPONENTS INTERNALLY WHICH MAY PERSIST FOR A
TIME EVEN AFTER THE POWER IS TURNED OFF AND DISCONNECTED.
ONLY AUTHORIZED PERSONNEL SHOULD CONDUCT MAINTENANCE AND/OR SERVICING. BEFORE
CONDUCTING ANY MAINTENANCE O
ページ2に含まれる内容の要旨
Model 5000B Copyright © 1999 Teledyne Analytical Instruments All Rights Reserved. No part of this manual may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any other language or computer language in whole or in part, in any form or by any means, whether it be electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written consent of Teledyne Analytical Instruments, 16830 Chestnut Street, City of Industry, CA 91749- 1580. War
ページ3に含まれる内容の要旨
Photometric Analyzer Table of Contents Part I: Control Unit ................................Part I: 1-1 Part II: Analysis Unit ............................Part II: 4-1 Appendix......................................................... A-1 Teledyne Analytical Instruments iii
ページ4に含まれる内容の要旨
Model 5000B iv Teledyne Analytical Instruments
ページ5に含まれる内容の要旨
Part I: Control Unit OPERATING INSTRUCTIONS Model 5000B Photometric Analyzer Part I: Control Unit NEMA 4 Bulkhead Mount Teledyne Analytical Instruments Part I: i
ページ6に含まれる内容の要旨
Model 5000B Photometric Analyzer Table of Contents 1 Introduction 1.1 Overview ........................................................................ 1-1 1.2 Typical Applications ....................................................... 1-1 1.3 Main Features of the Analyzer ....................................... 1-5 1.4 Operator Interface .......................................................... 1-6 1.4.1 Up/Down Switch .................................................... 1-6 1.4.2 Escape/Ente
ページ7に含まれる内容の要旨
Part I: Control Unit 3.3.12 Model ..................................................................... 3-15 3.3.13 Show Negative ...................................................... 3-15 3.4 The Zero and Span Functions ....................................... 3-16 3.4.1 Zero Cal ................................................................. 3-16 3.4.1.1 Auto Mode Zeroing ........................................ 3-16 3.4.1.2 Manual Mode Zeroing .................................... 3-17 3.4.
ページ8に含まれる内容の要旨
Model 5000B Photometric Analyzer iv: Part I Teledyne Analytical Instruments
ページ9に含まれる内容の要旨
Photometric Analyzer Part I: Control Unit Introduction 1.1 Overview The Teledyne Analytical Instruments Model 5000B Control Unit, together with a 5000B Analysis Unit, is versatile microprocessor-based instrument. Part I, of this manual covers the Model 5000B General Purpose NEMA 4 Bulkhead Mount Control Unit. (The Analysis Unit is covered in Part II of this manual.) The Control Unit is for indoor/outdoor use in a nonhazardous environment only. The Control or Analysis Unit in the folded optics
ページ10に含まれる内容の要旨
1 Introduction Model 5000B Ethanol Isopropanol Methanol Alkanes, including: 0–500 ppm Heptane Hexane Ammonia 0–1000 ppm and up Aromatics, including: 0–500 ppm Benzene Cumene Toluene Xylene Chlorinated Hydrocarbons including: 0–200 ppm Carbon Tetrachloride Ethyl Chloride Ethylene Dichloride Methyl Chloride Perchloroethylene Propylene Dichloride Trichloroethylene Vinyl Chloride Chloroprene 0–200 ppm Chloropicrin 0–200 ppm Deuterium Oxide 0–200 ppm Epichlorohydrin 0–2000 ppm Ethylene Glycol 0–500
ページ11に含まれる内容の要旨
Photometric Analyzer Part I: Control Unit Hydrogen Fluoride 0–10% Hydroperoxides 0–5% Kerosene 0–500 ppm Ketones 0–1000 ppm Methyl Acetate 0–1000 ppm Methyl Methacrylate 0–1000 ppm Oils 0–1% Olefins 0–500 ppm Pentane 0–300 ppm α-Picolene 0–300 ppm Phenol 0–1000 ppm Polyols 0–500 ppm Propylene Glycol 0–500 ppm Propylene Oxide 0–200 ppm Sulfinol 0–15% Sulfur Dioxide 0–1000 ppm Vinyl Acetate 0–2% NOTE:Range may be higher or lower per application. OTHER NIR ABSORBERS (that can be measured) (consult
ページ12に含まれる内容の要旨
1 Introduction Model 5000B Hydroxyl Value Hydrocarbons Hydrogen Chloride Hydrogen Fluoride Hydroxyl Value Ketones Olefins Oximes Epoxides Methylene Ketones 1-4: Part I Teledyne Analytical Instruments
ページ13に含まれる内容の要旨
Photometric Analyzer Part I: Control Unit 1.3 Main Features of the Analyzer The Model 5000B Photometric Analyzer is sophisticated yet simple to use. The main features of the analyzer include: • A 2-line alphanumeric display screen, driven by microprocessor electronics, that continuously prompts and informs the operator. • High resolution, accurate readings of concentration from low ppm levels through to 100%. Large, bright, meter readout. • Versatile analysis over a wide range of applications. •
ページ14に含まれる内容の要旨
1 Introduction Model 5000B 1.4 Operator Interface All controls and displays on the standard 5000B are accessible from outside the housing. The instrument has two simple operator controls. The operator has constant feedback from the instrument through an alphanumeric display, and a digital LED meter. The displays and controls are described briefly here and in greater detail in chapter 3. See Figure 1-1. 1.4.1 UP/DOWN Switch The UP/DOWN switch is used to select between any subfunctions displayed
ページ15に含まれる内容の要旨
Photometric Analyzer Part I: Control Unit -Range This function selects whether analyzer is autoranging or locked on one range. -Standby Places the analyzer in a sleep mode. WARNING: The power cable must be disconnected to fully remove power from the instrument. Figure 1-1: Model 5000B Controls, Indicators, and Connectors Digital Meter Display: The meter display is a Light Emitting Diode LED device that produces large, bright, 7-segment numbers that are legible in any lighting. It is accurate a
ページ16に含まれる内容の要旨
1 Introduction Model 5000B Alphanumeric Interface Screen: The backlit VFD screen is an easy- to-use interface between operator and analyzer. It displays values, options, and messages for immediate feedback to the operator. 1.5 Control Section Interface Panel The Control Section interface panel, shown in Figure 1-2, contains the electrical terminal blocks for external inputs and outputs. The input/output functions are described briefly here and in detail in the Installation chapter of this manu
ページ17に含まれる内容の要旨
Photometric Analyzer Part I: Control Unit Figure 1-2: Model 5000B Interface Panel Teledyne Analytical Instruments Part I: 1-9
ページ18に含まれる内容の要旨
1 Introduction Model 5000B 1-10: Part I Teledyne Analytical Instruments
ページ19に含まれる内容の要旨
15.5” Photometric Analyzer Part I: Control Unit Installation Installation of Model 5000B Analyzers includes: 1. Unpacking, mounting, and interconnecting the Control/Analysis Section 2. Making gas connections to the system 3. Making electrical connections to the system 4. Testing the system. This chapter covers installation of the Control Section. (Installation of the Analysis Section is covered in Part II of this manual.) 2.1 Unpacking the Control/Analysis Unit The analyzer is shipped with all t
ページ20に含まれる内容の要旨
1 Introduction Model 5000B Figure 2-3: Interface Panel of the Model 6600 Control Section For safe connections, ensure that no uninsulated wire extends outside of the terminal blocks. Stripped wire ends must insert completely into terminal blocks. No uninsulated wiring should come in contact with fingers, tools or clothing during normal operation. Primary Input Power: The power supply in the Model 6600 will accept a 115 Vac, 50/60 Hz power source. See Figure 2-4 for detailed connections. DA
