ページ1に含まれる内容の要旨
*P3PC-1582-01XA* P3PC- P3PC- P3PC- P3PC- P3PC-11111102-01DE 102-01EN 102-01ES 102-01FR 102-01AL
P3PC-1592-05ENZ0 P3PC-1582-01XA_EM
fi-5015C Image Scanner fi-5015C
fi-60F Image Scanner
Operator's Guide
Getting Started
Instructions Préliminaires
Los Geht's
Avvio Rapido
Comenzando
ページ2に含まれる内容の要旨
CONTENTS ■ Regulatory Information ........................................................ iii ■ Note, Liability ......................................................................... v ■ Safety Precautions ............................................................. viii Chapter 1 NAME OF PARTS.................................................... 1 1.1 Units..................................................................................... 2 1.2 Operator Panel.............................
ページ3に含まれる内容の要旨
Chapter 4 TROUBLESHOOTING........................................... 53 4.1 Error Indications in the Function Number Display........ 54 4.2 Troubleshooting............................................................... 56 APPENDIX A SCANNER SPECIFICATIONS..................................... AP-1 APPENDIX B Using [Scan] or [Send to] button .............................. AP-3 APPENDIX C GLOSSARY OF TERMS.............................................. AP-7 INDEX ..............................
ページ4に含まれる内容の要旨
INTRODUCTION Thank you for purchasing the fi-5015C Color Scanner. This document describes how to handle fi-5015C and basic operation methods. Before you start using fi- 5015C be sure to thoroughly read this manual to ensure correct use. This document describes the basic operation methods to perform scanning by using ScandAll PRO. The version of ScandAll PRO bundled with this product is subject to change without notice, in which case the screenshots captured in this document may differ from t
ページ5に含まれる内容の要旨
Canadian DOC Regulations This digital apparatus does not exceed the Class B limit for radio noise emissions from digital apparatus set out in the Radio interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. Le présent appareil numérique n'émet pas de parasites radioélectriques dépassant les limites applicables aux appareils numériques de la classe B et prescrites dans le Règlement sur le brouillage radioélectriqu
ページ6に含まれる内容の要旨
■Note, Liability READ ALL OF THIS MANUAL CAREFULLY BEFORE USING THIS PRODUCT. IF THIS PRODUCT IS NOT USED CORRECTLY, UNEXPECTED INJURY MAY BE CAUSED TO USERS OR BYSTANDERS. Also, keep this manual in a safe place so that it can be easily referred to during use of this product. While all efforts have been made to ensure the accuracy of all information in this manual, PFU assumes no liability to any party for any damage caused by errors or omissions or by statements of any kind in this manual,
ページ7に含まれる内容の要旨
How Trademarks Are Indicated In This Manual References to operating systems (OS) are indicated as follows: ® Windows 2000 Windows 2000 Professional operating system ® Windows XP Windows XP Home Edition operating system, ® Windows XP Professional operating system (32/64-bit) ® Windows Server Windows Server 2003, Standard Edition (32/64-bit), 2003 ® Windows Server 2003 R2, Standard Edition (32/64-bit) ® Windows Vista Windows Vista Home Basic operating system (32/64-bit), ® Windows Vista Home Premi
ページ8に含まれる内容の要旨
Warning Indications Used In This Manual This indication alerts operators to an operation that, if not strictly observed, may result in severe injury or death. This indication alerts operators to an operation that, if not strictly observed, may result in safety hazards to personnel or damage to equipment. Symbols Used In This Manual This symbol alerts operators to particularly important information. Be ATTENTION sure to read this information. This symbol alerts operators to helpful advice reg
ページ9に含まれる内容の要旨
■Safety Precautions In the following warnings, "power cable" may refer to the AC cable connected to the AC adapter collectively. Do not damage the AC cable. A damaged AC cable may cause fire or electric shock. Be careful of the following when handling the power cable: • Do not moisten, modify, tie, bundle, or wind the cable. • Do not place heavy objects on the cable, trap the cable in a doorway, drop or damage the cable in any other way. • Do not pull or forcibly bend or twist the cable. • D
ページ10に含まれる内容の要旨
Do not install the device in locations that has oil smoke, steam, humidity, and dust. Do not install the scanner in locations subject to oil smoke, steam, humidity, and dust. Doing so might cause a fire or electric shock. Turn the scanner OFF if it is damaged. If the scanner is damaged for any reason, disconnect immediately the power plug in order to turn out the scanner. Contact the store where you purchased the scanner. Do not put liquids inside the scanner. Do not insert or drop metal
ページ11に含まれる内容の要旨
Do not install the scanner on unstable surfaces. Make sure that the scanner is installed on a flat, level surface and that none of its parts extend beyond the surface top, such as a desk or table. Do not install the scanner on unstable surfaces. Install the scanner on a level surface that is free of vibration to prevent it from falling. Install the scanner on a strong surface that will support the weight of the scanner and other devices. Do not block the ventilation ports. Do not block th
ページ12に含まれる内容の要旨
Before moving the scanner, disconnect the power plug from the power outlet. Do not move the scanner with the power and interface cables connected as this might damage the cables, causing fire, electric shock or injuries. Before moving the scanner, be sure to disconnect the power plug from the power outlet, and all other data cables. Make sure that the floor is free of any obstruction. Protect the scanner from static electricity. Install the scanner away from strong magnetic fields and other
ページ13に含まれる内容の要旨
xii
ページ14に含まれる内容の要旨
Chapter 1 1 NAME OF PARTS This chapter shows the exterior view and the name of each part to descrive its function. 1.1 Units ......................................................................................................................... 2 1.2 Operator Panel ........................................................................................................ 5 fi-5015C Image Scanner Operator’s Guide 1
ページ15に含まれる内容の要旨
1.1 Units 1. Front side 2 3 4 5 1 6 7 8 Part Function 1. Automatic docu- Automatically feeds documents one by one to the reading position in the ment feeder (ADF) scanner. 2. Side guides Holds the documents straight. 3. ADF paper chute Holds the documents to be fed by the automatic document feeder (ADF). 4. Extension Extended when long documents are set. 5. Document cover Stacks the documents after being scanned by ADF. Holds the document to be scanned on Flatbed. 6. Document stopper Prevents
ページ16に含まれる内容の要旨
NAME OF PARTS 1.1 Units 2. Flatbed 1 1 2 Part Function 1. Document holding Holds the document on Flatbed. pad 2. Document bed On which the document is set face down. 3. Backside 1 2 3 4 Part Function 1. USB connector Connects USB cable to PC. 2. ADF cable connector Connects the cable from ADF. 3. DC inlet Connects the cable from AC adaptor 4. Main Power switch Turns the power ON or OFF to the scanner fi-5015C Image Scanner Operator’s Guide 3
ページ17に含まれる内容の要旨
4. Side (ADF side) 1 Part Function 1. Shipping lock Locks the scanning head to prevent the scanner damaged when moving or transporting. Unlocked Locked 4
ページ18に含まれる内容の要旨
NAME OF PARTS 1.2 Operator Panel 1.2 Operator Panel 1 3 2 4 6 1 5 Part Function 1. Function button Changes the function activated by [Send to] button. 2. Function number Indicates the function number or error status. For detail refer "4.1Error display Indications in the Function Number Display" on page 54 3. [Send to] button Launches an application software which is linked by the value of Function number display. 4. [Scan] button Launches an application software linked. 5. Power LED
ページ19に含まれる内容の要旨
6
ページ20に含まれる内容の要旨
Chapter 2 BASIC SCANNER OPERATIONS 2 This chapter describes how to turn On/Off the scanner, and how to load/scan the documents. In this chapter Windows XP screenshots are illustrated. The screens and operations may differ slightly if the OS you are using is not Windows XP. Also, when TWAIN is updated the screens and operations noted in this chapter will differ slightly. 2.1 Turning ON/OFF the Scanner ................................................................................ 8 2.2 Load
