ページ1に含まれる内容の要旨
Amoladora Angular
Amoladora Angular
A An ng glle e G Gr riin nd de er r
MANUAL DE INSTRUCCIONES
INSTRUCTION MANUAL
Cat. N° KG2001
Español 4
English 8
Advertencia: Léase este instructivo antes de usar el producto.
Warning: Read instruction manual before using product.
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
ESPAÑOL
ページ5に含まれる内容の要旨
ESPAÑOL
ページ6に含まれる内容の要旨
ESPAÑOL
ページ7に含まれる内容の要旨
ESPAÑOL / 5/8"-11/M14 Pueden consultar la dirección de su servicio en la lista de Centros de Servicio en Latinoamérica incluída con esta herramienta o poniéndose en contacto con la oficina local de Black & Decker en la dirección que se indica al final de este manual.
ページ8に含まれる内容の要旨
ENGLISH Intended use Remove adjusting keys and wrenches Your Black & Decker angle grinder has been designed for Always check that adjusting keys and wrenches are removed cutting metal and masonry using the appropriate type of cutting from the tool before operating the tool. or grinding disc.This tool is intended for consumer use only. Extension cables Before use, inspect the extension cable and replace if Safety instructions damaged. When using the tool outdoors, only use extension Warning! When
ページ9に含まれる内容の要旨
ENGLISH Electrical safety Beware that after switching off the tool the wheel This tool is double insulated; therefore no earth wire continues to rotate for a short period. is required. Always check that the power supply Ensure that ventilation slots are kept clear when working corresponds to the voltage on the rating plate. in dusty conditions. If it should become necessary to clear dust, first disconnect the tool from the mains supply. Additional safety instructions for angle grinders Avoid dam
ページ10に含まれる内容の要旨
ENGLISH Fitting and removing grinding or cutting discs (fig. C - F) Maintenance Always use the correct type of disc for your application. Your tool has been designed to operate over a long period of Always use discs with the correct diameter and bore size time with a minimum of maintenance. Continuous satisfactory (see technical data). The maximum thickness for grinding discs operation depends upon proper tool care and regular cleaning. is 6 mm, for cutting discs 3.5 mm. Regularly clean the vent
ページ11に含まれる内容の要旨
ENGLISH Solamente para propósito de Argentina: Importado por: Black & Decker Argentina S.A. Pacheco Trade Center Colectora Este de Ruta Panamericana Km. 32.0 El Talar de Pacheco Partido de Tigre Buenos Aires (B1618FBQ) República de Argentina No. de Importador: 1146/66 Tel. (011) 4726-4400 Imported by/Importado por: Black & Decker do Brasil Ltda. Rod. BR 050, s/n° - Km 167 Dist. Industrial II Uberaba ˆ MG ˆ Cep: 38064-750 CNPJ: 53.296.273/0001-91 Insc. Est.: 701.948.711.00-98 S.A.C.: 0800-
