ページ1に含まれる内容の要旨
Module No. 2196
2196-1
GETTING ACQUAINTED GENERAL GUIDE
Congratulations upon your selection of this CASIO Blood Pressure
Infrared port
Monitor Watch (BP-1B, Module No. 2196). To get the most out of your
purchase, be sure to carefully read this manual and keep it on hand for
later reference when necessary.
Digital display
Sensor
Introduction
Simply place your finger on the Watch’s
sensor for instant blood pressure readings
while on the go. Data can be stored in
• The illustration below shows
ページ2に含まれる内容の要旨
2196-2 3. While a setting is flashing, press B to To input basic data increase it. 1. With your arm resting on a table or desk, attach the cuff of the Base • When the 12/24-hour setting is Unit to your arm and buckle the Watch to your wrist as shown below. selected, press B to toggle between • The Watch should be on the outside of the left wrist. 12-hour (BCL) and 24-hour (C@L) timekeeping. Base Unit 4. Press A to exit the setting screen. • The day of the week is automatically displayed in accor
ページ3に含まれる内容の要旨
2196-3 • When you press D, the message appears on the Message Cause Action display of the Watch, indicating the Measurement Mode. The A pulse wave cannot be Apply less pressure with your message starts to flash after about six or seven detected because you are finger. If your fingertip is cold, seconds. Make sure you place your finger onto the sensor before pressing down on the sensor warm it up. the flashing starts. too hard, your fingertip is • A few seconds after you place your finger onto
ページ4に含まれる内容の要旨
2196-4 To measure blood pressure and pulse BLOOD PRESSURE MEASUREMENT DATA 1. Strap the Watch onto your left wrist. MEMORY You can store up to 30 measurement data records in memory. Each 2. Press D to enter the Measurement record includes the pulse rate, systolic blood pressure and diastolic Mode. blood pressure, and the month, day, day of the week, and the time that the measurement was taken. If memory is already full when you perform the measurement procedure, the oldest record is deleted to
ページ5に含まれる内容の要旨
2196-5 Blood pressure value Setting basic data Reading by Watch High blood Blood Blood Fast pulse wave velocity pressure pressure pressure Calculate High blood pressure (input) (calculated) Determine blood Slow pulse wave velocity relationship pressure Low blood pressure Low blood Pulse wave Pulse wave pressure transit time transit time (detected) (detected) Velocity Slow Fast Note = Takes = Takes • It is important to remember that correct blood pressure measurements
ページ6に含まれる内容の要旨
2196-6 Place your finger on the sensor so that the Timekeeping Correct pad of the finger (not the fingertip) is • The year can be set in the range of 2000 to 2039. covering the photosensor. If your fingernail • The Watch’s built-in full automatic calendar automatically makes turns white, it means you are pressing too allowances for different month lengths and leap years. Once you set hard. Your fingertip should be resting lightly the date, there should be no reason to change it except after you
ページ7に含まれる内容の要旨
2196-7 • Make extra copies for future use Basic Data Setting Date--- Time--- BLOOD PRESSURE RECORD Systolic--- Diastolic--- Pulse--- Date 1 2 3 4 5 6 7 8 9 10 11 1213 1415 1617 1819 20 212223 2425 262728 29 3031 Name: Time Date: 250 240 Notes: 230 220 210 200 190 180 170 160 150 140 130 120 110 100 90 80 70 60 50 Example 40 Pulse Systolic Notes Values Diastolic Values BLOOD PRESSURE
