ページ1に含まれる内容の要旨
FREEZER
ZBF 6114
INSTRUCTION BOOKLET
2222 753-66
ページ2に含まれる内容の要旨
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety Check the appliance for transport damage. Under This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
ページ3に含まれる内容の要旨
Servicing At the end of the Appliance Life This product should be serviced by an authorised When disposing of your appliance use an engineer and only genuine spare parts should be authorised disposal site. used. The symbol on the product or on its packaging Under no circumstances should you attempt to indicates that this product may not be treated as repair the appliance yourself. Repairs carried out household waste. Instead it shall be handed over by inexperienced persons may cause injury
ページ4に含まれる内容の要旨
Operation Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Freezer controls ➀➀ ➁➁ ➂➂ ➃➃ ➄➄ 1 Pilot light (green) 4 Push button for fast-freezing and for stopping the audible signal (warning light on) 2 Thermostat control knob 5 Warning light (red) 3 Fast-freezing indicator light (yellow) Starting your appliance Insert the plug
ページ5に含まれる内容の要旨
Warning light (red) Frozen food storage If the temperature warning light (5) lights up, it When you first start the freezer or if the freezer has indicates that the temperature within the freezer has been out of use for some time, we advise you to run reached a level where safe food storage is no longer your appliance for at least two hours in the «fast ensured (warmer than -12°C). freeze» mode before storing frozen food. When the freezer is first switched on, the warning To obtain the best perf
ページ6に含まれる内容の要旨
Freezing calendar Normal Operating Sounds The symbols on the drawers show different types of You may hear faint gurgling or bubbling sounds when frozen goods. the refrigerant is pumped through the coils or tubing The numbers indicate storage times in months for at the rear, to the fixed freezer shelves. the appropriate types of frozen goods. Whether the When the compressor is on, the refrigerant is being upper or lower value of the indicated storage time is pumped round, and you will hear a whir
ページ7に含まれる内容の要旨
Health and Safety Guidelines Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. Keep the freezer door closed as much as possible. The size of each pack should be small enough to ensure that it i
ページ8に含まれる内容の要旨
Defrosting The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out complete
ページ9に含まれる内容の要旨
Maintenance and Cleaning Warning Internal cleaning Before any maintenance or cleaning work Clean the inside and accessories with warm water is carried out, DISCONNECT the appliance and bicarbonate of soda (5ml to 0.5 litre of water). from the ELECTRICITY supply. Rinse and dry thoroughly. Important NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING This appliance contains hydrocarbons in PRODUCTS OR WAX POLISHES, TO CLEAN THE its cooling unit maintenance and INTERIOR AS THESE WILL D
ページ10に含まれる内容の要旨
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown. The temperature in the freezer is
ページ11に含まれる内容の要旨
Service and Spare Parts In the event of your appliance requiring service, or if For Customer Service in Ireland please contact us at you wish to purchase spare parts, please contact the address below: your local Service Force Centre by telephoning:- Zanussi 08705 929929 Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Your telephone call will be automatically routed to the Republic of Ireland Service Force Centre covering your post code area. Tel: + 353 1 4090751 For the address of your loca
ページ12に含まれる内容の要旨
Guarantee Conditions Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been u
ページ13に含まれる内容の要旨
Technical specifications POWER SUPPLY VOLTAGE AND FREQUENCY _ 230-240 V / 50 Hz TOTAL POWER ABSORBED _ 0,8 A AVERAGE DAILY UNITS ELECTRICITY(*) _ 0,57 kWh GROSS CAPACITY 110 l NET CAPACITY 94 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153 (Actual consumption will depend on how the appliance is used and where it is located). Installation The appliance should be located in a dry Warning atmosphere, out of direct sunlight and away from IF Y
ページ14に含まれる内容の要旨
Door reversal The appliances door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins A at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process
ページ15に含まれる内容の要旨
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the observed. terminal in the plug which is marked with the letter If the plug that is fitted to your appliance is not «E» or the
ページ16に含まれる内容の要旨
50 Building in Dimensions of the recess Height of housing (1) mm 880 Depth of housing (2) mm 550 1 Width of housing (3) mm 560 2 3 D022 1. Fit the appliance in the niche by making sure that 1 2 it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). PR0 It is necessary that the cabinet h
ページ17に含まれる内容の要旨
21 mm 21 mm Ha C D Hc E PR33 B 7. Fix cover (Hc) on guide (Ha) until it clips into place. 4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. 8mm Hb Ha Ha Hc Hb PR167 Hd 8. Open the appliance door and the furniture door at PR266 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture 5. Separate parts Ha, Hb, Hc, Hd as shown in the door and mark the holes as indicated in the figure. figure. ca. 50 mm 90
ページ18に含まれる内容の要旨
Hb PR168 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly. Hb Hd PR167/1 11. Fix cover (Hd) on the small square (Hb) until it clips into place. 18
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
© Electrolux plc 2007
