ページ1に含まれる内容の要旨
Optima SO218/318
OWNER'S MANUAL
Manual No. 513571 Aug. 2001, Rev. 2
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Need Parts or Service? We stock the parts you need. Our Technicians are factory trained and are certified in the Stoelting Technicare program. CALL Distributor: _________________________ Phone No.: _________________________ (fill in or affix label) Model No.: _______________________ Serial No.: _______________________ Purchase Date: ____________________ Start-Up Date:____________________
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
OWNER'S MANUAL FOR MODEL SO218/318 STOELTING FLOOR MODEL FREEZER This manual provides basic information about the freezer. Instructions and suggestions are given covering its operation and care. The illustrations and specifications are not binding in detail. We reserve the right to make changes to the freezer without notice, and without incurring any obligation to modify or provide new parts for freezers built prior to date of change. DO NOT ATTEMPT to operate the freezer until instructions and
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
TABLE OF CONTENTS SECTION DESCRIPTION PAGE 1. INTRODUCTION 1.1 Remote Possibilities .......................................................................................... 1 1.2 Features ............................................................................................................ 1 1.3 Dispenser Specifications ................................................................................... 2 2. INSTALLATION INSTRUCTIONS 2.1 Safety Precautions ................................
ページ8に含まれる内容の要旨
LIST OF ILLUSTRATIONS FIGURE TITLE PAGE 1 Model SO218/318 ............................................................................ 1 2 Dispenser Specifications .................................................................. 2 3 Leveling Unit ..................................................................................... 3 4 Controls ............................................................................................ 5 5 Disassembling Freezer..................................
ページ9に含まれる内容の要旨
SECTION 1 INTRODUCTION 1.1 REMOTE POSSIBILITIES The Stoelting Optima delivers frozen drink profits by the pitcher. The Model SO218/318 is a high-volume producer of ready-to-serve frozen cocktails or frozen neutral base for those special drink recipes. From an extra-small space, the Optima’s compact design and high capacity output will give you extra-large profits. Figure 1. Model SO218/318 1.2 FEATURES High Capacity Consistency Control Dispensing Head Door - 15-18 gallons per hour output - Adju
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
SECTION 2 INSTALLATION INSTRUCTIONS 2.1 SAFETY PRECAUTIONS Do not attempt to operate the freezer until the safety If danger, warning or caution labels are needed, indicate precautions and operating instructions in this manual are the part number, type of label, location of label, and read completely and are thoroughly understood. quantity required along with your address and mail to: Take notice of all warning labels on the freezer. The labels have been put there to help maintain a safe STOELTIN
ページ12に含まれる内容の要旨
E. Connect the power cord. The plug is designed for 208/ 230 volt/20 amp duty. The unit must be connected to a properly grounded receptacle. The electrical cord furnished as part of the freezer has a three prong grounding type plug. The use of an extension cord is not recommended. If one must be used, use one with a size 12 gauge or heavier with a ground wire. Do not use an adaptor to get around grounding requirements. CAUTION DO NOT ALTER OR DEFORM PLUG IN ANY WAY! F. Install the drip tray, cov
ページ13に含まれる内容の要旨
SECTION 3 INITIAL SETUP AND OPERATION C. Mix Low Light 3.1 OPERATOR'S SAFETY PRECAUTIONS The Mix Low light will illuminate when you are low on SAFE OPERATION IS NO ACCIDENT; Observe these mix. rules: A. Know the freezer. Read and understand the CAUTION Operating Instructions. DO NOT OPERATE FREEZER WHEN THE LOW MIX LIGHT IS ILLUMINATED OR DAMAGE TO B. Notice all warning labels on the freezer. THE FREEZER COULD RESULT. C. Wear proper clothing. Avoid loose fitting garments, and remove watches, rin
ページ14に含まれる内容の要旨
HARD CARBON SOFT RUBBER SURFACE SURFACE Figure 7. Rear Seal Assembly 3.4 CLEANING THE FREEZER PARTS Figure 5. Disassembling Freezer Place all loose parts in a pan or container and take to the wash sink for cleaning. To clean freezer parts refer E. Remove the spigot body from the front door bypulling to the following steps: the retaining pin out of the spigot handle. Push the spigot body thru the bottom of the front door. A. Place all parts in warm mild detergent water and clean with brushes prov
ページ15に含まれる内容の要旨
NOTE K. Install hopper cover. The United Sates Department of Agriculture and the L. Connect mix hose to hopper cover (Model SO318 Food and Drug Administration require that lubricants only). used on food processing equipment be certified for this use. Use lubricants only in accordance with 3.7 SANITIZING the manufacturer’s instructions. Sanitizing must be done after the freezer is clean and just before filling with mix. Sanitizing the night before A. Assemble spigot “O” Rings onto parts dry, with
ページ16に含まれる内容の要旨
3.8 CLEANING & SANITIZING OF S0318 WITH 3.9 INITIAL FREEZE DOWN AND OPERATION FILL-O-MATIC II AND FILL-O-MATIC III This section covers the recommended operating procedures to be followed for the safe operation of the A. Empty freezer & mix container of product. freezer. A. Sanitize just prior to use. B. Mix 4 gallons of warm detergent water and pour into mix container, brush mix container, pick up hose and B. Place the CLEAN/OFF/SERVE switch in the OFF draw tube. Pump detergent water into freez
ページ17に含まれる内容の要旨
3.11 SO218/318 OPERATION INFORMATION FOR SERVICE PERSONNEL The SO218/318 is a cocktail/slush freezer. It is available in 208-230 volt, either air-cooled or water-cooled. The air-cooled version has front-to-back airflow requiring three inches of air space in the front and back for proper refrigeration. This unit is not supplied with a pump, however, Stoelting does offer the Fill-O-Matic II (electric) and Fill-O-Matic III (gas) pumps FOR THE SO318. This freezer is intended for use with non-dairy p
ページ18に含まれる内容の要旨
10
ページ19に含まれる内容の要旨
SECTION 4 PREVENTIVE MAINTENANCE 4.1 ROUTINE CLEANING 2. If the condenser is dirty, using compressed air or To remove spilled or dried mix from the freezer exterior, CO2 tank, blow out the dirt from the fan side of the simply wash in the direction of the finish with warm condenser. soapy water and wipe dry. Do not use highly abrasive materials as they will mar the finish. 3. An alternative method of cleaning the condenser is to use a condenser brush and vacuum. 4.2PREVENTATIVE MAINTENANCE It is
ページ20に含まれる内容の要旨
12
