ページ1に含まれる内容の要旨
M3 STROLLERS
Keep this manual for future reference. If you sell this stroller or
give it away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
Operating Instructions
Important:Read and follow these Safety Rules and Assembly Instructions before operating stroller. If
you have any questions concerning the safe use of this product, contact Pacific Cycle LLC at
1-800-242-6110, M-F, 8:00 a.m. – 5:00 p.m. C.T. or visit our website at
ページ2に含まれる内容の要旨
Model M3 Strollers Assembly Instructions Parts List Description Qty Frame Assembly 1 Fender 1 Fender screws # 8 x 3/4" 4 Parent Console 1 Front Wheel Assembly 16" 1 Rear Wheels 16" 2 Stroller Assembly Instructions Step 1. Unfold Stroller Grasp frame as shown and open until both side latches engage (Figure A). Step 2. Rear
ページ3に含まれる内容の要旨
Step 4. Front Wheel Assembly While stroller is still tipped back, attach the front wheel by loosening the wheel’s quick release (Q/R) lever on the front wheel far enough to allow the axle to slide into the front fork (Figure D1). The front caliper brake Q/R lever should be in the open position so the front wheel can be inserted easily Into the front fork . With wheel’s Q/R lever in open position, hand tighten the cone nut until almost tight, then close the wheel’s Q/R lever to lock wheel
ページ4に含まれる内容の要旨
Step 5. Installing Parent’s Convenience Tray Parent Tray Snap the parent tray onto the handle bar aligning the tray’s Hole holes with the handlebar’s knobs (Figure E). Step 6. Installing optional Child Tray (sold separately) Handle Knob Align the child tray onto the frame just below side latches, Fig. E Step 7. Installing optional Child booty cover (sold separately) Undo the shoulder and waist straps from the stroller seat center buckle. Place the booty into the seat and inser
ページ5に含まれる内容の要旨
Use Instructions WARNING: Always remove child from stroller before folding. To fold stroller: IMPORTANT Pull the seatback forward toward the front fender prior to folding! Pull the one hand fold handle located between the tray and handle of the stroller. The stroller will automatically begin to fold. (Figure H). Continue folding/pushing frame together. To engage rear brakes: Step lightly on the center brake bar to engage brakes. To disengage, lift up on brake bar (Figure I).
ページ6に含まれる内容の要旨
To adjust handle height: While pushing the handle buttons in rotate handle to the desired height (Figure L). Fig. L Care and Maintenance Check fasteners After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary. Periodically check the stroller and fasteners to ensure that it is in good operating condition. To clean seat and canopy: If light cleaning is required, use a soft cloth with warm water and mild soap, then air dry. Do not put into washin
