ページ1に含まれる内容の要旨
1
INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER U.S. ENVIRONMENTAL PROTECTION AGENCY (E.P.A.) JULY 1990 AND THE OREGON DEPARTMENT OF ENVIRONMENTAL QUALITY (D.E.Q.) PARTICULATE
EMISSION STANDARDS BY E.E.M.C. THESE STOVES HAVE BEEN TESTED AND LISTED BY WARNOCK HERSEY LTD. TO STANDARDS: CSA B366.2 , ULCS627, ULC S628, UL 1482.
MODEL 1100 HAS BEEN TESTED AND LISTED FOR INSTALLATION IN MOBILE HOMES.
INSTALLATION AND OPERATION INSTRUCTIONS FOR
HI-TECH
ページ2に含まれる内容の要旨
2 NAPOLEON wood fireplaces are manufactured under the strict Standard of the World Recognized ISO 9001 : 2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work. The complete fireplace is thoroughly inspected by a qualified technician before packaging to ensure that you, the customer, receives the quality product that you expect from NAPOLEON. NAPOLEON WOOD FIREPLACE PRESIDENT'S L
ページ3に含まれる内容の要旨
3 PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE TABLE of CONTENTS PG 2-4 INTRODUCTION 10-11 FINISHING Warranty Brick Installation General Information Ornamental Trivet Installation Care of Plated & Enamelled Parts Door and Handles Installation Care of Glass Pedestal Trim Installation 5-6 INSTALLATION 11-13 OPERATING INSTRUCTIONS Installing the Legs Achieving Proper Draft Alcove Installation Fire Extinguishers and Smoke Detectors Stove Installation Fuel Loading and Burn Cycle Chimney Connection
ページ4に含まれる内容の要旨
4 CALIFORNIA PROP 65 WARNING: Use of this product may produce smoke which INTRODUCTION contains chemicals known to the State of GENERAL INFORMATION California to cause cancer, birth defects, or other Except for their different depths, models 1100, 1400, reproductive harm. 1900 and the fireplace inserts 1101 and 1401 are iden- PEDESTAL MODELS ONLY tical and use the same burning principles. They were If the outside air feature of the stove is utilized, you will specifically designed over many mont
ページ5に含まれる内容の要旨
5 STOVE INSTALLATION INSTALLING THE LEGS STOVE INSTALLATION To avoid being damaged during shipping, the stove If the stove is to be installed has been bolted to the pallet and must be unbolted on a combustible floor, it must be before the stove can be installed. placed on a approved non-com- FIGURE 2A 1. Remove the 4 nuts and bustible hearth pad, that extends washers from the underside 8" (200mm) beyond the stove of the pallet. sides and back, and 18" (455mm) 2. Lift the stove up and to the fron
ページ6に含まれる内容の要旨
6 DO NOT USE ANY MAKESHIFT MATERIALS DURING INSTALLATION. MOBILE HOME 1. Move the stove into position with the flue centered, midpoint between two joists to prevent having to cut them. INSTALLATION Use a plumb bob to line up the centre. 2. Cut and frame an opening in the roof to provide a 2" PEDESTAL MODEL 1100 IS APPROVED FOR IN- clearance between the outside of the chimney and any STALLATION IN MOBILE HOMES IN BOTH combustible material. CANADA AND THE UNITED STATES. DO NOT FILL THIS SPACE WITH
ページ7に含まれる内容の要旨
7 Do NOT remove bricks or mortar from the fireplace. In OUTSIDE AIR case of an outside air inlet or ash dump, fill with fiberglass Connection from the stove's air intake to the outside is insulation. Adhere to minimum clearances as shown in mandatory in mobile homes only, either through a hole FIGURE 10. in the wall to line up with the knockout in the pedestal Do NOT place any back, or through a hole in the floor to line up with the combustible materi- hole in the pedestal base. Use a fresh air
ページ8に含まれる内容の要旨
8 In the United States, continued: If a continuous liner is not installed, a "direct flue con- OPTIONAL FAN nection" must be made. The direct flue connection re- quires a non-combustible connector that extends from INSTALLATION the insert into the chimney flue liner and also that the installed flue cover be sealed below the entry point of Drywall dust will penetrate into the fan bearings, the connector to prevent dilution of combustion prod- causing irreparable damage. Care must be taken ucts i
ページ9に含まれる内容の要旨
9 1101 FAN SERVICE OR REPLACEMENT 1401 FAN SERVICE OR REPLACEMENT 1. Turn off all electrical power to the insert. Remove the 1. Turn off all electrical power to the insert. Remove the glass door and set aside in a safe place. glass door and set aside in a safe place. 2. Remove the top right 2. Remove the two screws from the outer edge of the GASKET side bricks from inside side panel(s). the firebox, 4-#7's and 2- 3. Push the side panel toward the door and pull away #2's. Then remove the from the
ページ10に含まれる内容の要旨
10 FINISHING SIZES 1100/1100C 1101/1100L 1400 1401/1400L 1900 4-#1 4-#1 4-#1 4-#1 4-#7* #1. 1-1/4" x 4"-1/2 x 9" BACK 2-#4 2-#4 2-#4 2-#4 2-#2 #2. 1-1/4" x 3" x 9" #3. 1-1/4" x 4-1/2" x 4-1/2" 8-#1 8-#1 12-#1 12-#1 12-#7* SIDES 2-#3 2-#3 2-#3 #4. 1-1/4" x 4-1/2" x 9" 2-#4 #5. 1-1/4" x 2-1/2" x 4-1/2" (notched) #6. 1-1/4" x 1-1/2" x 4-1/2" TOP 2-#102-#10 2-#11 2-#11 2-#12 #7. 1-1/4" x 4-1/2" x 9" * (light weight) 3-#1 4-#1 5-#1 6-#1 7-#7* 2-#2 2-#2 2-#2 2-#2 2-#2 #8. 1-1/4" x 2-1/4" x 9" FLOOR
ページ11に含まれる内容の要旨
11 BRICK and BAFFLE INSTALLATION With stove and chimney installation completed, move o per at ing the bricks into place by working as illustrated for your unit on page 10. 1. Install two or three courses of brick on both sides of inst r uc t io ns the unit. Install two courses on the back wall. Install the WARNING: Remove all sources of gasoline final course of bricks on the back wall. These bricks or other flammable vapours and liquids in the are held in place by a brick retainer. Before inst
ページ12に含まれる内容の要旨
12 You can now add larger pieces of wood and operate the FIRE EXTINGUISHERS / SMOKE DETECTORS stove normally. Once the stove/insert is entirely hot, it All homes with a solid fuel burning fireplace should will burn very efficiently with little smoke from the chim- have at least one fire extinguisher in a central loca- ney. There will be a bed of orange coals in the firebox tion known to all, and at least one smoke detector in and secondary flames flickering just below the top fire- the room cont
ページ13に含まれる内容の要旨
13 DO NOT OVERFIRE THE STOVE! Overfiring can occur by: maint enanc e a) burning large amounts of smaller wood pieces such as Check your chimney and chimney connector for creosote and furniture scraps, skids or treated wood; soot buildup weekly until a safe frequency for cleaning is es- b) vigorously burning large loads of wood with the draft tablished. If accumulation is excessive, disconnect the stove control on "HIGH" (fully open) for long periods of time and clean both the chimney and the sto
ページ14に含まれる内容の要旨
14 WOOD PILE MAINTENANCE Burn only dry, clean unpainted wood that has been seasoned. It produces more heat and less soot or creosote. Freshly cut wood contains about 50% moisture while after proper seasoning only about 20% of the water remains. As wood is burned, this water boils off consuming energy that should be used in heating. The wetter the wood, the less heat is given off and the more creosote is produced. Both hardwood and softwood burn equally well in this stove but hardwood is denser,
ページ15に含まれる内容の要旨
15 ORDERING PROCEDURES Contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normally all parts can be ordered through your Napoleon dealer or distributor. When ordering replacement parts always give the following information: 1. Model & Serial Number of fireplace 2. Installation date 3. Part Number 4. Description of part 5. Finish REPLACEMENT PARTS ACCESSORIES / OPTIONS # PART NO. DESCRIPTION # PART NO. DESCRIPTION 1 W325-0002 SPRING HANDLE - SMAL
ページ16に含まれる内容の要旨
16 35 39 34 1 38 17 35 37 36 15 19 43 32 28 49 44 33 31 55 24 1 29 48 40 57 58 51 52 50 53 W415-0360 / 11.05.02
