ページ1に含まれる内容の要旨
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY
THIS MANUAL IS PRINTED ON RECYCLED PAPER
EG 40 B Vented
By SHERWOOD INDUSTRIES LTD.
OWNERS MANUAL
WHAT TO DO IF YOU SMELL GAS
WARNING
• Open windows
If the information in this manual
• Do not try to light any appliance.
is not followed exactly, a fire or
• Do not touch any electrical switch; do not use any explosion may result causing
property damage, personal
phone in your building.
ページ2に含まれる内容の要旨
SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" STOVE, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: GENERAL • Always keep the appliance area clear • Installation and repair should be done by a and free of combustible materials, gasoline qualified service person. The appliance should be and other flammable vapors and liquids. inspected before use and at once least annually by a qualified service person. More frequent cleaning • These appliances s
ページ3に含まれる内容の要旨
TABLE OF CONTENTS Safety Precautions 2 Code Approvals 3 Deciding where to locate your stove 4 Venting 6 Installation of Log Sets and Embers 8 Operating Instructions 9 Maintenance and Technical 10 Trouble Shooting 11 12 Gas Line Connection 13 Electrical Parts and Accessories 14 Fuel Type Conversion 15 Warranty 16 Parts List 17 Exploded views 18-19 Installation Data Sheet 20 CODE APPROVALS • This Vented appliance draws all of its combustion air from the dwelling and must be vented
ページ4に含まれる内容の要旨
DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: Front Width: 25"/ 63 cm Rear Width: 25"/ 63 cm Height: 29"/ 74 cm* Depth 21"/ 53 cm ( *not including vent coupling ) Shipping Weight: 256 lbs/116 kg CLEARANCES: FIG. 1 A. Side wall to stove 12"/ 30cm B. Rear wall to stove 4"/ 10cm C. Combustible to stove Top 36”/ 91cm D. Floor to stove 0"/ 0cm E. Corner clearance 2"/ 5cm F. Alcove depth 48"/ 122cm Maintain sufficient clearances for service and
ページ5に含まれる内容の要旨
VENT TERMINAL CLEARANCES A= Clearance above grade, verandah, porch, deck, H= *Not to be installed above a meter/regulator or [balcony (*12 inches (30cm) minimum] assembly within 3 feet (90cm) horizontally B= Clearance to window or door that may be opened from the center-line of the regulator [*12 inches (30cm) minimum] I= Clearance to service regulator vent outlet C= Clearance to permanently closed window [*6 feet (1.8m) minimum] [minimum 12 inches
ページ6に含まれる内容の要旨
VENTING This model must have a vent opening in the rear of the unit. Confirm this and also check that the label on the right side panel door states "Vented Room Heater". WARNING: THIS APPLIANCE HAS BEEN DESIGNED TO OPERATE BY DRAWING COMBUSTION AIR AND DILUTION AIR FROM THE ROOM. THE DRAFT HOOD LOCATED IN THE SAME ATMOSPHERIC PRESSURE ZONE AS THE COMBUSTION AIR INLET TO THE APPLIANCE. IT IS ALSO DESIGNED TO DRAW ROOM AIR FOR PROPER HEAT CIRCULATION FROM THE REAR OF THE UNIT. BLOCK
ページ7に含まれる内容の要旨
A. USING AN EXISTING CHIMNEY • Measure the height of the chimney beforehand and purchase the appropriate kit. Never attempt to over stretch a flexible liner to accommodate the height of the chimney. • Any flue damper must be removed or locked permanently in the open position. • The chimney must be clean, in good working order and constructed out of non-combustible materials. • Make sure that all chimney clean-outs are tightly fitting and will not permit air to leak into the chimney.
ページ8に含まれる内容の要旨
INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of ceramic fiber embers is provided for use on the front burner ember tray. CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other foreign materials on the burners may create dangerous conditions. If over time, through cleaning and servicing, thes
ページ9に含まれる内容の要旨
OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot, which must • If you cannot reach your gas supplier, call the be lit by hand by following these instructions exactly. fire department. B) BEFORE LIGHTING smell all around the appliance C) Use only your hand to push in or turn the gas
ページ10に含まれる内容の要旨
MAINTENANCE AND TECHNICAL To Replace: Annually check to ensure that your Vent • open door fully system is clear. • Lift door vertically so that hinge pins lift out of hinge receivers. Periodically check the pilot and burner. Check to • Return the door assembly to dealer. see that all the burner ports are clean and clear. Door and glass assembly must be replaced as a Check the pilot head for blockage. Check to ensure complete unit by your ENVIROGAS Dealer. the pilot flame is
ページ11に含まれる内容の要旨
TROUBLE SHOOTING Problem Possible Cause Solution Spark will not light the pilot after Defective piezo igniter Check connections to igniter repeated pressing of spark -If igniter connections are good but igniter there is no spark-replace igniter Broken spark electrode -Check for broken ceramic insulation replace, electrode if broken Miss-aligned spark electrode -If spark is not arcing from the electrode to pilot- adjust by loosening screws on pilot base. Adjust and re- tighten Pilo
ページ12に含まれる内容の要旨
GAS LINE CONNECTION ORIFICE SIZES, PRESSURE AND BTU’S NATURAL GAS PROPANE GAS FRONT BURNER #48 (1.93mm) #55 (1.32mm) REAR BURNER #41 (2.49 mm) #54 (1.40 mm) Manifold pressure. 3.8” wc (.95 kPa) 11” wc (2.74 kPa) Min. Manifold pressure. 1.1” wc (.27 kPa) 2.7” wc (.67 kPa) Supply Pressure. 7.0” wc (1.74 kPa) 12” wc (2.98 kPa) Min. Supply pressure. 5” wc (1.25 kPa) 11.5” wc (2.86 kPa) Max. BTUH Input. 38,000 Btu/h (11.1 kW) 38,000 Btu/h (11.1 kW) Min. BTUH Input. 20,000 Btu
ページ13に含まれる内容の要旨
ELECTRICAL The ENVIROGAS EG 40.FS.BV. will operate with no external power supply. These models have a Milli volt gas control which uses the pilot flame to generate enough electricity to operate the main burner. The appliance when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE A
ページ14に含まれる内容の要旨
PARTS AND ACCESSORIES Service Parts available from your local Envirogas Dealer Burner Control Assembly Convection Blower Natural Gas Pilot Assembly Light Bulb Holder Propane Pilot Assembly Light Switch (momentary) Door Bolt Fan Controller Relief Door Gasket Log Set (with Embers) Regulating Valve Thermocouple Piezo Igniter Embers Burner Switch Thermopile Door Gasket B-vent Spill switch 220° Orifice Blank Convection Fan Sensor 120 F (49C) Accessories Gold trim Package Low
ページ15に含まれる内容の要旨
• There is a separate air shutter for each burner. • Remove one screw from the cover plate located below the ash shelf. Loosen the other screw (do not remove) swing the cover plate out of the way and tighten screw down to hold it in place. • With along screwdriver rotate spring clips to open or close the shutter to the desired setting. • The burner flame should be a bright yellow/orange when hot. Excessive blue is to lean and dark orange with soot is to rich FUEL TYPE CONVERSION
ページ16に含まれる内容の要旨
WARRANTY Sherwood Industries Ltd. offers a *Lifetime Warranty on this gas product. The lifetime warranty covers the appliance for a period of seven years from the date of installation. This warranty applies only to the original owner in the original location Covered under the lifetime warranty are Cabinet Sides, Tops, Pedestals, Surround Panels and Chassis and Heat Exchanger. These steel components are covered against manufacturer’s defects for 5 years and labor for the first year a
ページ17に含まれる内容の要旨
PARTS LIST EC-001 120 °F CERAMIC TEMP SENSOR EG40-081 UPPER GOLD BARS (SET of 2) EC-003 EG40-084 FS LOWER GOLD BAR 300 °F CERAMIC SPILL SWITCH EC-006 S.I.T. NOVA VALVE NG EG40-086 FS SIDE PANEL EC-007 S.I.T. NOVA VALVE LP EG40-087 BV STOVE TOP EC-008 THERMOCOUPLE POST (10,00) EG40-088 FIREBOX BAFFLE EC-011 SPARK ELECTRODE W/ IGNITER WIRE EG40-091 STOVE TOP BAFFLE EC-012 THERMOPILE EG40-093 IEC POWER CORD OUTLET EC-013 PILOT NG W/ELECTRODE EG40-098 FRONT VENTURI EC-014 PILOT LP W/E
ページ18に含まれる内容の要旨
FRONT BURNER REAR BURNER EG40-089 EG40-090 PAINTED DOOR ASSEMBLY WITH FULLY ASSEMBLED GLASS (A + B) PILOT EG40-073 EC-015 NG, 016 LP GOLD DOOR ASSEMBLY WITH THERMOPILE REAR LOG GLASS (A + B) EC-012 SUPPORTS EG40-075 THERMOCOUPLE EC-009 PILOT ORIFICE GLASS RETAINER EC-019 NG, 020 LP DOOR LATCH STRIP HINGE SPARK ELECTRODE DOOR LATCH BOLT SET OF 2 REAR EC-011 EC-059 EG40-302 VENTURI EG40-099 GAS TRAY TOP AND SIDES FRONT VENTURI GLASS EG40-098 EXTRUSIONS CONT
ページ19に含まれる内容の要旨
FS STOVE TOP (BV or DV) EG40-087 1 X 1 SIDE CABINET HINGE FLUE PIPE EC-054 120° F (49° C) FAN TEMP SENSOR EC-001 CONVECTION BLOWER FS SIDE PANEL CABINET EG40-035 EG40-049 FS FAN MOUNT EG40-304 CONVECTION AIR DEFLECTORS EG40-033 220° F (104° C) SPILL SWITCH EC-002 FS UPPER BAR SET EG40-081 FS SIDE PANEL CABINET EG40-049 FS LOWER BAR EG40-084 FS PEDESTAL WIRING PLATE FS ASH SILL EG40-213 FS PEDESTAL BOX COVER EG40-307 FS PEDESTAL DOOR EG40-135 EG 40 EMBLEM EG 40 FRE
ページ20に含まれる内容の要旨
INSTALLATION DATA SHEET The following information must be recorded by the installer for warranty purposes and future reference. Model: EG 40 Name of Dealer: Name of Owner: __________________________________________ ___________________________________________ Address: Address: __________________________________________ ___________________________________________ ___________________________________________ __________________________________________ ___________________
