ページ1に含まれる内容の要旨
• Direct Vent Freestanding Stove
• Natural Gas or Propane
• Vent Horizontally or Vertically
• Standard Residential
• Mobile Home Approved
Tested and Listed by
Omni-Test Laboratories, Inc.
Beaverton, Oregon
Report # 028–S–38-5
AN SI Z 21.88, C SA 2.33 M 9 8, C AN /C G A 2.17- M 91
Featuring the Burner
WARNING: If the information in these instructions is not followed exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
- Do not store or use gasoli
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Introduction 1 Introduction We welcome you as a new owner of a Cedar Stove. In purchasing this heater you have joined the growing ranks of concerned individuals whose selection of an energy system reflects both a concern for the environment and aesthetics. The Cedar is one of the finest home heaters the world over. This manual will explain the installation, operation, and maintenance of this gas-burning heater. Please familiarize yourself with the Owner’s Manual before operating your heater
ページ4に含まれる内容の要旨
Gas 2 Safety Precautions • IF YOU SMELL GAS: * Do not light any appliance * Extinguish any open flame * Do not touch any electrical switch or plug or unplug anything * Open windows and vacate building * Call gas supplier from neighbor’s house, if not reached, call fire department • This unit must be installed by a qualified installer to prevent the possibility of an explosion. Your dealer will know the requirements in your area and can inform you of those people considered qualified. T
ページ5に含まれる内容の要旨
Safety Precautions 3 • Do not place clothing or • Light the heater using the other flammable items on or built-in piezo igniter. Do not near the heater. Because use matches or any other AA AA this heater can be controlled external device to light your by a thermostat there is a heater. AA AAA possibility of the heater • Never remove, replace, turning on and igniting any modify or substitute any part items placed on or near it. of the heater unless instructions are given in this • The door (gla
ページ6に含まれる内容の要旨
4 Table of Contents Introduction Operation Introduction......................................................1 Safety Notice....................................................21 Important Information .........................................1 Location of Controls ...........................................21 Starting the Pilot Flame .......................................22 Safety Precautions Starting the Heater for the First Time......................23 Safety Precautions .....................
ページ7に含まれる内容の要旨
Specifications 5 Installation Options: Features: • Freestanding Stove • Ember Fyre ™ Burner for "Wood Fire" Look • Residential or Mobile Home • Works During Power Outages • Horizontal or Vertical Vent • Optional Thermostat or Remote Control • Variable-Rate Heat Output • Optional Blower Heating Specifications: Approximate Heating Capacity (in square feet)*......500 to 1,500 With Blower, 500 to 1200 Without Maximum BTU Input Per Hour...............................31,000 (NG & LP) Minimum BTU Outp
ページ8に含まれる内容の要旨
6 Installation (for qualified installers only) Installation Warnings ! Failure to follow all of the requirements may result in property damage, bodily injury, or even death. ! This heater must be installed by a qualified installer who has gone through a training program for the installation of direct vent gas appliances. ! This appliance must be installed in accordance with all local codes, if any; if not, follow current ANSI Z223.1 or NFPA 54 in the USA or the current CGA B149 in Canada. ! In M
ページ9に含まれる内容の要旨
Installation (for qualified installers only) 7 Heater Placement Requirements • Heater must be installed on a level surface capable of supporting the heater and vent • Due to the high temperature of the heater, it should be located out of traffic and away from furniture and draperies. ? When placed in a location where the floor to ceiling height is under 7 feet, the installation is considered an alcove and must meet the following requirements: • The alcove floor to ceiling height must be at least
ページ10に含まれる内容の要旨
8 Installation (for qualified installers only) Vent Requirements ! Always maintain the required 1” clearance (air space) to combustible materials to prevent a fire hazard. Do not fill air spaces with insulation. ! The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or gas-burning appliance. Each direct vent gas appliance must use it’s own separate vent system. • This appliance is equipped only
ページ11に含まれる内容の要旨
Installation (for qualified installers only) 9 To Adjust the Restrictor Approved Vent Loosen these Slide the restrictor Replace the cotter pin Configurations a b c adjustment rod in. through the correct four screws hole on the restrictor Lift the cotter pin out. adjustment rod. and tilt the Restrictor Position NOTE: stove top up to The restrictor is Restrictor shipped in # 1 Positions position #1. access the # 4 • A vent restrictor is built # 5 restrictor . into the appliance to # 6 #
ページ12に含まれる内容の要旨
10 Installation (for qualified installers only) Vertical Terminations with 0, 2, or 4 45° Offsets Horizontal Offset Length Hor. Offset Vert. Rise Offset None 5" 1' Vertical 1' Section 1' 1' 7" Rise 2' Section 1' 9" 2' 4" Offset Length 3' Section 2' 5" 3' 4' Section 3' 2" 3' 8" • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. 40' (max) 40' (max) AAAAAAAAAAAAAAAAAA Restrictor AAAAAAAAAAAAAAAAAA Position # 6 AAAAAAAAAAAAAAAAAA 35 fee
ページ13に含まれる内容の要旨
Installation (for qualified installers only) 11 Horizontal Terminations with One 90° Elbow • If using a Snorkel Termination (14” or 36”) add the snorkel height to the vertical height (snorkel terminations are used primarily for basement installations). • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. 19' (max) 19' (max) Restrictor Position # 5 AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAA NOTE:
ページ14に含まれる内容の要旨
12 Installation (for qualified installers only) Approved Venting Configurations with a Horizontal Termination and Two Elbows (one 90° vertical and one 90° or 45° horizontal elbow) • If using a Snorkel Termination (14” or 36”) add the snorkel height to the vertical height (snorkel terminations are used primarily for basement installations). • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. 19' (max) 19' (max) AAAAAAAAAAAAAAAAAAAAA Restr
ページ15に含まれる内容の要旨
Installation (for qualified installers only) 13 Approved Venting Configurations with a Horizontal Termination and Three 90° Elbows (all vertical) • If using a Snorkel Termination (14” or 36”) add the snorkel height to the vertical height (snorkel terminations are used primarily for basement installations). • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. AAAAAAAAAAAAAAAAAA 21' (max) 21' (max) AAAAAAAAAAAAAAAAAA Restrictor AAAAAAAAAAA
ページ16に含まれる内容の要旨
14 Installation (for qualified installers only) Vertical Terminations with Two 90° Elbows • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. 40' (max) 40' (max) AAAAAAAAAAAAAAAAAAAAA Restrictor AAAAAAAAAAAAAAAAAAAAA Position # 6 AAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA 35 feet 35 feet AAAAAAAAAAAAAAAAAAAAA Restrictor AAAAAAAAAAAAAAAAAAAAA Position # 5 AAAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
ページ17に含まれる内容の要旨
Installation (for qualified installers only) 15 Approved Venting Configurations for Vertical Terminations with Three 90° Elbows (Two 90° Vertical and One 45° or 90° Horizontal Elbow) • The termination must fall within the shaded area shown in the chart. Use the indicated restrictor position. 40' (max) AAAAAAAAAAAAAAAAAA 40' (max) AAAAAAAAAAAAAAAAAA Restrictor Position # 5 AAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA 35 feet 35 feet AAAAAAAAAAAAAAAAAA NOTE: AAAAAAAAAAAAAAAAAA Restric
ページ18に含まれる内容の要旨
16 Installation (for qualified installers only) Termination Requirements (see the illustration below) A Minimum 9" clearance from any door or window Roof B Minimum 12" above any grade, veranda, porch, deck or balcony Surface C Minimum 12" from outside corner walls 11” Min. D Minimum 12" from inside corner walls Roof 6” Min. Eaves E Minimum 11" clearance below unventilated soffits or roof surfaces Minimum 18" clearance below ventilated soffits Minimum 6" clearance from roof eaves NOTE: Vinyl su
ページ19に含まれる内容の要旨
Installation (for qualified installers only) 17 Finalizing the Installation ! Turn the gas control valve to “OFF” prior to conducting any service. 1 Install the control box following the instructions below. b Phillips Screwdriver Place the control box in place and secure with the two screws. NOTE: a tab on the back of the control box inserts into this slot. a Remove the wire cover by loosening these screws and sliding it to the left. c 1/4" Nutdriver Replace wire cover so it conceals the
ページ20に含まれる内容の要旨
18 Installation (for qualified installers only) 6 Let the heater burn for thirty minutes. Adjust the air shutter, if necessary, to achieve the correct looking flame (see the illustration below). • The air shutter adjusts the amount of air that mixes with the gas before it exits the burner holes. It is used to fine-tune the flame for differences in altitude and vent configuration. ADJUSTING THE AIR SHUTTER Gas Control Valve Pushing to the left gives the flame less air (making it more orange).
