ページ1に含まれる内容の要旨
W23OT ManTel and Base
asseMBl Y and InsT alla TIOn InsTRUCTIOns
Important: Read entire instruction sheet before Assembling mAntel
assembling or installing mantel kit.
WARning: Use only 1/2" screws to attach metal
this mantel is only approved for use with DesA
angle brackets. Damage to mantel will result if other
Heating, LLC 21" and 23" fireplace systems*. Do
screws are used for this purpose.
not use mantel with any other product.
imPORt Ant : more than one person is required to lift
*CGE
ページ2に含まれる内容の要旨
1. Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach three brackets with 1/2" screws to bottom of right front leg (#3) leaving screws Header slightly loose. Face brackets out (see Figure 1). Place right front leg (#3) over right side (#2) as shown in Figure 2, paying close attention to direction arrow pointing up on panels. Align threaded holes with brackets on side. Start three 1/2" screws through brackets. Align bottom of side and leg assembly so the
ページ3に含まれる内容の要旨
Att ACHING toP oF MANtEL GAS FIREPLACE INSt ALLAtIoN 1. Fireplace should be fully assembled. See Assembling 1. Place mantel top (#7) onto upright leg assembly (see Fireplace in fireplace owner’s manual. Figure 5). Align back of top with back of sides. 2. Place mantel base close to installation location. See 1 2. Using three 1 ⁄4" screws with washers, attach top to fireplace owner’s manual for installation clearances. header/leg assembly (see Figure 5). 3. Mantel must be installed flush wit
ページ4に含まれる内容の要旨
DESA Heating, LLC 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004, USA www.desatech.com 1-866-672-6040 121868-01 121868 01 Rev. B 08/07 NOT A UPC
