ページ1に含まれる内容の要旨
W32AUA And W32AOSA WAll MAntel And
BASe With PeriMeter triM
Assembl Y AnD inst All Ati On inst RUCti Ons
IMPORTANT: If you are staining an unfinished mantel (W32AUA
Important: Read entire instruction sheet before
only), remove any sawdust, dirt or oils. This will prevent blem-
assembling or installing mantel kit.
ishes from appearing under the stain. Stain mantel before
t hese mantels are only approved for use with any
assembling according to manufacturer’s instructions. Apply
DESA Heatin
ページ2に含まれる内容の要旨
1. Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach four brackets with 1/2" Header screws to bottom of right front leg (#3) leaving screws slightly loose. Face brackets out (see Figure 1). Place right front leg (#3) over right side (#2) as shown in Figure 2, paying close attention to direction arrow pointing up on panels. Align threaded holes with brackets on side. Start four 1/2" screws through brackets. Align bottom of side and leg assembly so they
ページ3に含まれる内容の要旨
L I P F F O L O 3. Attach mantel to base using 6 brackets and 1/2" screws, FiRePlACe inst AllA tiOn 3 per leg assembly, into threaded holes in base and leg 1. Fireplace should be fully assembled. See Assembling assembly (see Figure 7). Fireplace in fireplace owner’s manual. 4. Adjust fireplace so that it fits into mantel opening properly. 2. Place mantel base close to installation location. See fire- 5. Gas fireplace with louver door: Lower bottom louver door
ページ4に含まれる内容の要旨
Screws Fixed Shoulder Holes are Behind Louver on Louver Screw Fireplace Bottom for Attaching Fireplace to Wooden Mantel Base Figure 9 - Screw Locations for Gas Fireplace with Fixed Louver inst Alling FiRePlACe WithOUt FlAnge 1. Place mantel assembly on wood base and center left to right having back of assembly flush with back of base. 2. Attach mantel to base using 6 brackets and 1/2" screws, Shoulder 3 per leg assembly into threaded holes in base and leg Screw assembly (see Figure 7, p
