ページ1に含まれる内容の要旨
S33 Sump Pump
INSTRUCTIONS AND SERVICE MANUAL
VERTICAL
FLOAT SWITCH
S33V1 & S33V1C
AUTOMATIC
S33P1 & S33PC-1
(CONTROL WITH SERIES PLUG)
NOT SHOWN
AUTOMATIC
S33A1 & S33A1C
R
23833A587 Bag #18812A108
ページ2に含まれる内容の要旨
WARNING risk of electric shock. This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding-type receptacle. Pumps can be installed with ABS, PVC or polyethylene plastic pipe, or galvanized or copper pipe. Proper adapters are required to connect plastic pipe to pump. The discharge is threaded for 1-1/2 inch pipe. NOTE: DO NOT OVERTIGHTEN DISCHARGE PIPE INTO PUM
ページ3に含まれる内容の要旨
IMPORTANT INSTRUCTIONS BEFORE INSTALLATION Failure to follow these instructions may cause serious bodily injury and/or property damage. Warranty void if product modified, drilled, painted, 5. Voltage of power supply must match the voltage of the or altered in any way; if used to pump hot water, pump. All Myers sump pumps are factory preset to or to pump liquids other than water (such as but 115V, 60Hz. not limited to chemicals, fertilizers, flammable 6. Before installing pump, clear sump basi
ページ4に含まれる内容の要旨
COMPLETE SUBMERSIBLE SUMP PUMP INSTALLATION Refer to the installation illustrations below and on the Myers distributor. All parts with part numbers are following page for the following instructions. Be certain quality Myers parts. sump basin is clean and all power to pump is shut off. Tools Needed for All Pump Installation If pump fails to operate properly after installation, refer Pipe wrench, slot screwdriver, hacksaw, round file, drill, to the troubleshooting checklist on page 6 or contact
ページ5に含まれる内容の要旨
STARTING PUMP - S33A (AUTOMATIC) 1. These pumps have an integral mechanical (mercury-free) ball float switch as shown on installation drawing. “Vertical switch” models have a vertical actuated cylinder float. 2. Plug cord into a 115 volt GROUNDED RECEPTACLE. 3. Run water into sump until pump starts. 4. Allow pump to operate through several on-off cycles to be sure operation is satisfactory. 5. If shut-off valve is used in discharge line, be sure valve is open. 6. If pump does not opera
ページ6に含まれる内容の要旨
Service Chart SYMPTOMS Pump does not run or hum. X X X X X X Pump runs but does not deliver water. X X X X X X Pump runs and pumps out sump but does not stop. X Pump runs but delivers only small amount of water. X X X X Fuse blows or circuit breaker trips when pump starts. X X X X Motor runs for short time then stops. Then after short period starts again. Indicates tripping overload X X X caused by symptom shown. For any other symptoms ca
ページ7に含まれる内容の要旨
MYERS LIMITED WARRANTY SUMP & RESIDENTIAL SEWAGE During the time periods and subject to the conditions hereinafter set forth, F.E. Myers will repair or replace to the original user or consumer any portion of your new MYERS product which proves defective due to defective materials or workmanship of MYERS. Contact your nearest Authorized MYERS Dealer for warranty service. At all times MYERS shall have and possess the sole right and option to determine whether to repair or replace defective equi
