ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Thank you for purchasing a Honda water pump. This manual covers the operation and maintenance of WD20X and WD30X water pumps. All information in this publication is based on the latest pro- duct information available at the time of printing. The illustrations in this manual are based on the WD30X water pump unless otherwise noted. Honda Motor Co., Ltd. reserves the right to make changes at any time without notice and without incurring any obligation. No part of this publication may be rep
ページ4に含まれる内容の要旨
CONTENTS 3 1. WATER PUMP SAFETY ......................................................... 2. COMPONENT IDENTIFICATION .............................................. 5 -3. PRE-OPERATION CHECK ....................................................... 6 ........................................................ 11 4. STARTING THE ENGINE ........................................................................ 13 5. OPERATION ....................................................... l High altitu
ページ5に含まれる内容の要旨
1. WATER PUMP SAFETY To ensure safe operation - l For safety, never pump flammable or corrosive liquids such as gasoline or acid. Also, to avoid pump corrosion, never pump sea water, muddy water, chemical solutions, or caustic liquids such as used oil, wine, or milk. l Place the pump on a firm, level surface. If the pump is tilted or overturn- ed, fuel spillage may result. l To prevent fire hazards and to provide adequate ventilation, keep the pump at least 1 meter (3 feet) away from bu
ページ6に含まれる内容の要旨
Read these labels before you operate the water pump. GASOLINE WARNING LABEL -WARNING, DO NOT PUMP FLAMMABLE OR CORROSIVE MATERIALS AN EXPLOSION OR FIRE COULD RESULT, CAUSING SEVERE PERSONAL INJURY. BP n “V Y..” JOINT O’ETANCHEITE.
ページ7に含まれる内容の要旨
2. COMPONENT IDENTIFICATION < WD20X > < WDBOX> OIL ALERT MUFFLER THROTTLE LEV STARTER GRIP L FILLER CAP/ FUEL VALVE FUEL FILLER PRIMING WATER CAP FILLER CAP \ SUChON STRAINER ‘ORT PLUG PUMP DRAIN CAP 5 i
ページ8に含まれる内容の要旨
3. PRE-OPERATION CHECK 1. Suction hose Use a reinforced-wall or wire braided hose to prevent suction collapse. Since the pump’s self-priming time is directly proportional to hose length, a’ short hose is recommended. Secure the hose with the hose band. CAUTION: Always install the strainer on the end of the suction hose before pumping. Gravel or debris sucked into the pump will cause serious impeller damage. 2. Discharge hose When using a fabric hose, always use a hose band to prevent t
ページ9に含まれる内容の要旨
3. Engine Oil CAUTION: l Engine oil is a major factor affecting engine performance and service life. Non-detergent and 2-stroke engine oils are not recommended. l Be sure to check the engine on a level surface with the engine stopped. Use Honda 4-stroke oil, or an equivalent high detergent, premium quality motor oil certified to meet or exceed U.S; automobile manufac- turer’s requirements for Service Classification SE or SF, (Motor oils classified SE or SF will show this -20 0 20 40
ページ10に含まれる内容の要旨
4. Fuel Unscrew the fuel cap. Check the fuel level. Your engine is designed to use any gasoline that has a pump octane number (y) of 86 or higher, or that has a research octane number of 91 or higher. Gasoline pumps at service station normally display the pump octane number. We recommend that you use unleaded fuel because it produces fewer engine and spark plug deposits and extends the life of exhaust system components. Never use stale or contaminated gasoline or an oil/gasoline mixture
ページ11に含まれる内容の要旨
Gasoline is extremely flammable and is explosive under certain condi- tions. Refuel in a well-ventilated area with the engine stopped. Do not. smoke or allow flames or sparks in the area where the engine is refueled or where gasoline is stored. Do not overfill the fuel tank (there should be no fuel in the filler neck). After refueling, make sure the tank cap is closed properly and securely. Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite. If any fuel is
ページ12に含まれる内容の要旨
5. Air cleaner Remove the wing nut, washer and air cleaner cover. Check the element for dirt or obstruction. Clean the element if necessary (see page 18). AIR CLEANER COVER \ AIR CLEANER ELEMENT 6. Priming water The pump chamber should be completely filled before operating. CAUTION: Never attempt to operate the pump without priming water or the pump will overheat. Extended dry operation will destroy the pump seal. If the unit has been operated dry, stop the engine immediately and a
ページ13に含まれる内容の要旨
4. STARTING THE ENGINE 1. Turn the fuel valve ON. 2. Close the choke lever. NOTE: Do not use the choke if the engine is warm or the ambient temperature is high. CHOKE LEVER FUEL VfLVE 3. Turn the engine switch to the ON position.
ページ14に含まれる内容の要旨
4. Move the throttle lever slightly to the left. 5. Pull the starter grip lightly until resistance is felt, then pull it briskly. CAUTION: Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter. STARTER GRIP 12 I
ページ15に含まれる内容の要旨
5. OPERATION 1. As the engine warms up, gradually open the choke. 2. Set the throttle at the desired speed. THROTTLE LEVER 13
ページ16に含まれる内容の要旨
Oil Alert System The Oil Alert system is designed to prevent engine damage caused by an in- sufficient amount of oil in the crankcase. Before the oil level in the crankcase can fall below a safe limit, the Oil Alert system will automatically shut down the engine (the engine switch will remain in the ON position). If the Oil Alert system shuts down the engine, the Oil Alert lamp will flash when you .operate the starter, and the engine will not run. If this occurs, add engine oil (page 7).
ページ17に含まれる内容の要旨
6. STOPPING THE ENGINE I, Move the throttle lever fully to the,right. 2. Turn the engine switch to the OFF position. THROTTLE LEVER ENGINE S-WITCH 3. Turn the fuel valve OFF. FUEL VALVE NOTE: To stop the engine in an emergency, turn the engine switch to the OFF position. 15
ページ18に含まれる内容の要旨
7. MAINTENANCE , The purpose of the maintenance and adjustment schedule is to keep the pump in the best operating condition. Inspect or service as scheduled in the table below. m Shut off the engine before performing any maintenance. If the engine must be run, make sure the area is well ventilated. The exhaust con- tains poisonous carbon monoxide ‘gas. CAUTION: Use only genuine HONDA parts or their equivalent. The use of replacement parts which are not of equivalent quality may damage th
ページ19に含まれる内容の要旨
1. Oil change Drain the oil while the engine is still warm to assure rapid and complete draining. 1. Remove the oil filler cap and the drain plug, then drain the oil. 2. Reinstall the drain plug and tighten securely. 3. Refill with the recommended oil (see page 7) to the specified level. OIL CAPACITY: 0.61 (0.63 US qt) OIL FILLER CAP/ DIPSTICK \ DRAIN PLUG OIL LEVEL - CAUTION: Used motor oil may cause skin cancer if repeatedly left in con- tact ‘with the skin for prolonged periods.
ページ20に含まれる内容の要旨
2. Air cleaner service A dirty air cleaner will restrict air flow to the carburetor. To prevent car- buretor malfunction, service the air cleaner regularly. Service more fre- quently when operating the pump in extremely dusty areas. mzm Never use gasoline or low flash point solvents for cleaning the air cleaner element. A fire or explosion could result. CAUTION: Never run the pump without the air cleaner. Rapid engine wear will result. 1. Unscrew the wing nut, remove the air cleaner cove
