ページ1に含まれる内容の要旨
5
®
9
1
READ AND SAVE THESE INSTRUCTIONS
TM
8
TM
Model No.
CF1AB01
CF1WB01
CF1PW01
DATE CODE:
Max. Weight: 27.0 Lbs.
The date code of this fan may be found on
the box, stamped in ink on a white label.
With Blades
You should record this data above and keep
it in a safe place for future use.
®
™
CORNERSTONE Series
Ceiling Fan Owner's Manual
Part No. F40BP72500002 Form No. BP7250-2
ページ2に含まれる内容の要旨
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
ページ3に含まれる内容の要旨
NOTE: Before discarding packaging material, be Unpacking Instructions certain all parts have been removed. For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This FAN MOTOR AND HOUSING ASSEMBLY will insure that all steps have been completed and will be helpful in finding your place should you be MOTOR interrupted. COVER ! WARNING Do not install or use fan if any part is damaged or missing. Call Toll-Free: HANGER BALL/ D
ページ4に含まれる内容の要旨
Assembly Instructions 1. Remove the fan motor and housing assembly from ! WARNING styrofoam packaging and position it so that the top of the motor is facing you. It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely 2.Remove the hanger ball from the downrod by tightened. Failure to verify that the pin and setscrew loosening the setscrew in the hanger ball until the are properly installed (as shown in Figure 3) could ball falls freely down the do
ページ5に含まれる内容の要旨
7. If you have installed the 12. Use the holes in the square recesses in the motor 18" DOWNROD 18” downrod, install the hub marked with "4" and install the blade downrod trim and assemblies in accordance with Steps 13 or 14. GROMMET decorative bulb as 13. FOUR-BLADE VERSION. Attach one blade DECORATIVE follows (Figure 5). Slide BULB assembly to the motor hub using two 10-32 x 5/8" the decorative trim oval head screws (supplied) (Figure 8). Do not (grommet-end first) over tighten completely at th
ページ6に含まれる内容の要旨
TURN SWITCH HOUSING How to Hang Your ASSEMBLY Ceiling Fan UPPER COVER TRIM ! WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 12). CEILING HOLE FOR SPEED CONTROL SWITCH CHAIN 8-32 x 3/8" SCREW (2) AT LEAST 7' Figure 10 LOOKING UP INTO SWITCH HOUSING ASSEMBLY FLOOR Figure 12 16. Position the lower trim assembly on the upper cover trim so that the tabs on the lower trim assembly slide into the slots in the upper cover trim ! WARNING (Figure 11). Then securely
ページ7に含まれる内容の要旨
NOTE: CEILING COVER, 2. Securely connect the fan motor white wire to the SUPPLY WIRES AND OUTLET supply white (neutral) wire using wire connector FAN WIRES OMITTED BOX supplied (Figure 15). Securely connect the fan FOR CLARITY. motor black wire and blue wire to the supply black (hot) wire using wire connector supplied (Figure 16). After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one HANGER BRACKET side of the outl
ページ8に含まれる内容の要旨
Using Your Ceiling Fan Attaching Light Kit 1. Restore electrical power to the outlet box by To install an accessory light kit, first unscrew the finial turning the electricity on at the main fuse box. and remove the lower trim (Figure 18). Then remove the center trim by removing four 8-32 x 1/2” screws. 2. Check the operation of the fan by gently pulling on Remove the threaded nipple from the center trim and the 4-position speed control pull chain switch install the light kit in accordance with
ページ9に含まれる内容の要旨
Maintenance Accessories IMPORTANT CARE INSTRUCTIONS 1. Ceiling Fan Light Kits (see store or catalog). for your Ceiling Fan 2. Downrod Extension Kits (see store or catalog). Periodic cleaning of your new ceiling fan is the only 3. Ceiling Fan Controls (see store or catalog). maintenance that is needed. When cleaning, use only a soft brush or lint free cloth ! WARNING to avoid scratching the finish. The use of any other control not specifically Abrasive cleaning agents are not required and should
ページ10に含まれる内容の要旨
Repair Parts Before discarding packaging material, be certain all parts have been removed. 2 How to Order 1 3 Repair Parts 18 WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING 16 6 INFORMATION: 38 17 • PART NUMBER • PART DESCRIPTION 7 • NAME OF ITEM 18 • MODEL NUMBER 19 19 For repair parts, phone 15 20 1-800-654-3545. 37 27 39 40 35 5 4 26 23 25 24 8 33 9 28 34 10 21 12 11 36 29 24 22 14 13 31 30 32 10
ページ11に含まれる内容の要旨
Repair Parts Listing Part Numbers Key Model No. Model No. Model No. No. Description CF1AB01 CF1WB01 CF1PW01 — Hanger Pack, Containing: 761655-3 761655-20 761655-22 1 Bracket, Hanger (1) — — — 2 Hanger Ball Assembly (1) — — — 3 Downrod (1) — — — 6 Ceiling Canopy 761620-3 761620-26 761620-30 7 Trim, Ceiling Cover 762077 762077-1 762077-2 8 Hub, Rubber 760601 760601 760601 9 Blade Assembly — — — (Sold Separately) 10 Flange Set 762108 762108-1 762108-2 (Full set for four blades) 11 Flange Set 762109
ページ12に含まれる内容の要旨
LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for the lifetime of your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your
