ページ1に含まれる内容の要旨
READ AND SAVE THESE INSTRUCTIONS
™
Model No.
ATHENIAN
CF2400AB00
CF2400BC00
Ceiling Fan
CF2400BZH00
Owner's Manual
CF2400ORB00
CF2400PW00
CF2400SCK00
Net Weight: 21.6 Lbs.
CF2400WB00
LIMITED WARRANTY
What The Warranty Covers:
This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials.
You must be the original purchaser or user of the product to be covered.
What The Period Of Coverage Is:
As it applies to t
ページ2に含まれる内容の要旨
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
ページ3に含まれる内容の要旨
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver One wire stripper 50-100 ft. 12 Three wire connectors (supplied) One stepladder Four T8 25-watt (max.) candelabra base bulbs (supplied) ! WARNING MATERIALS Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 7). If you feel
ページ4に含まれる内容の要旨
Electrical Requirements How to Assemble Your Ceiling Fan Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. IMPORTANT: If you are going to use an Emerson The outlet box must be securely anchored and remote control and receiver to control your fan, capable of withstanding a load of at least 50 pounds. perform the instructions in this Owner’s Manual in conjunction with the instructions contained in the remote control/receiver Owner’s Manual.
ページ5に含まれる内容の要旨
4. Align the clevis pin holes in the downrod with the 8. Reinstall the hanger ball on the downrod (Figure 4) holes in the motor coupling. Install the clevis pin as follows. Route the motor leads through the and secure with the hairpin clip (Figure 2). (Pin and hanger ball and slide the hanger ball over the clip are supplied in loose parts bag.) The clevis pin downrod. Install the pin through the holes at the top must go through the holes in the motor coupling of the downrod and slide the hanger
ページ6に含まれる内容の要旨
5 5 4 11. Use the 10 round recessed holes in the motor hub ! WARNING that are marked with a “5” and install the five blade assemblies in accordance with Step 12. The outlet box and joist must be securely mounted One side of the switch housing has been indented and capable of supporting at least 50 lbs. Use only a to allow easy access when installing the flange U.L. outlet box listed as “Acceptable for Fan Support”. screws. ! WARNING 1. Securely attach the hanger bracket to the outlet box using t
ページ7に含まれる内容の要旨
EMERSON FAN CONTROL How to Wire Your Ceiling Fan LISTED OUTLET BOX BLACK FAN WIRE If you feel that you do not have enough electrical GREEN WIRE BLACK LIGHT RED BLACK (GROUND) CONTROL wiring knowledge or experience, have your fan (HOT) FROM installed by a licensed electrician. HANGER TO 120 BRACKET VOLT SUPPLY WHITE ! WARNING WHT. GROUND WIRE Turning off wall switch is not sufficient. To avoid GROUND GROUND BLUE possible electrical shock, be sure electricity is THREE-CONDUCTOR CABLE (WITH tur
ページ8に含まれる内容の要旨
4. Screw the two 1-1/4” threaded studs (supplied) into 9. Position the switch housing cover so that the tab on the tapped holes in the hanger bracket the inside of the switch housing cover aligns with (Figure 9). the notch in the switch housing (Figure 14). With the switch housing cover held in this position, 5. Lift the ceiling cover up to the threaded studs and pass the shortest pull chain through the nearest turn until the studs protrude through the holes in bushing. the ceiling cover (Figure
ページ9に含まれる内容の要旨
Using Your Ceiling Fan Attaching Light Kit 1. Restore electrical power to the outlet box by turning To install an Emerson accessory light kit, remove the the electricity on at the main fuse box. three screws securing the switch housing cover to the switch housing. Remove the finial nut and cover pate 2. Check the operation of the fan by gently pulling on from the bottom of the switch housing cover and the 4-position speed control switch pull chain. The install the light kit in accordance with th
ページ10に含まれる内容の要旨
! WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or 2. Check line power connections to fan and switch wire loose switch wire connections in the switch connections in the switch housing. housing. ! WARNING: Make sure mai
ページ11に含まれる内容の要旨
Repair Parts Before discarding packaging material, be certain all parts have been removed. 1 HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS 8 2 GIVE THE FOLLOWING INFORMATION: 4 • PART NUMBER 3 • NAME OF ITEM 5 • PART DESCRIPTION 20 • MODEL NUMBER The model number of your Fan will be found on a label attached to the top housing. For repair parts, phone 1-800-654-3545. 7 6 7 6 21 9 30 31 32 33 22 10 11 12 13 23 14 24 FAN BLADE (Order Separately) 25 15 26 27 16 17 18 28 19 19 29 11
ページ12に含まれる内容の要旨
Repair Parts Listing Part Numbers Key Model No. Model No. Model No. Model No. Model No. Model No. Model No. No. Description CF2400AB00 CF2400BC00 CF2400BZH00 CF2400ORB00 CF2400PW00 CF2400SCK00 CF2400WB00 * Hanger Pack, Consisting of: 761655-3 761655-24 761655-57 761655-32 761655-22 761655-31 761655-20 1 Hanger Bracket — — — — — — — 2 Hanger Ball — — — — — — — 3 Downrod — — — — — — — * Parts Bag, Containing: 762548 762548 762548 762548 762548 762548 762548 4 Wire Connector (4) — — — — — — — 5 Set
