Monte Carlo Fan Company 5GIR54XXDの取扱説明書

ページ1に含まれる内容の要旨

Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weigh
with light
For 5GIR54XXD Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans

ページ2に含まれる内容の要旨

Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,

ページ3に含まれる内容の要旨

9 8 7 Remote Transmitter Dip swtiches Remote Receiver Dip switches Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both Tighten 2 downrod set screws and Align hole in downrod with hole in receivers the same as the transmitter. If you have more lock nuts. yoke and install cross pin. Install than one fan with remote. You can

ページ4に含まれる内容の要旨

19 20 21 Center Canopy Hole Larger holes Smaller holes Place canopy on top of the fan motor allowing the Remove side covers from canopy Remove 2 screws in yoke (see yoke to pass through the large hole in the center of exposing 4 holes. 2 closed holes insert). Remove 3 screws with key- the canopy. Align the 3 larger holes around the and 2 open “L” shape holes. hole slots from top of fan. center hole with the 3 screws already installed in the fan. Install 3 flush mount screws provided into sma

ページ5に含まれる内容の要旨

31 32 33 Install the 3 x 40 watt incandescent Place glass and cage on light kit, Install finial cap nut and tighten in candelabra bulbs. install rubber washer and hex nut to direction of arrow. hold in place and tighten in direction of arrow. 34 35 36 Attach cover of remote by placing Remove cover by snapping off from Install wall control unit to outlet box over buttons and snapping into top or bottom. Install 12V battery using machine screws provided. place. into wall remote. Duracell MN

ページ6に含まれる内容の要旨

Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin

ページ7に含まれる内容の要旨

6/21/06 REV.0 New made from 5GMR manual