ページ1に含まれる内容の要旨
ENGLISH ESpañoL FraNçaIS
See page 1 Vea la página 15 Consulter la page 29
Th e
Summer Breeze
Collection
Indoor/OutdoorP edestalF an
Owner’s Guide
f Or M Odel s 9015x & 901 7 x
42729-01 12/20/2006
ページ2に含まれる内容の要旨
Imporant t Safety InformatIon Read & Save These Instructions CI uta on 11. DO NOT operate fan in the pres- ence of explosive and/or flam- When using electrical appliances, basic mable fumes. precautions should always be taken to reduce the risk of fire, electric shock 12. DO NOT place fan or any parts and personal injury: near an open flame, cooking or any other heating appliances. 1. Read all instructions before using this fan. 13. DO NOT use near curtains, plants, window treatments
ページ3に含まれる内容の要旨
ENGLISH WelCome aC unp I k ng Thank you for choosing a Hunter As you unpack the fan, save the Pedestal Fan. This manual gives you carton and packing materials in case complete instructions for using your you want to move or ship the unit in fan. Here are some the features you the future. will enjoy with your fan: Carefully remove all items from • An attractive design that enhances the box. any decor NOTE: It is best to have someone • A powerful Hunter motor for max- hold the box while you
ページ4に含まれる内容の要旨
roundgIng InStruCI t S on This appliance is for household use WarnIng only and may be plugged into any If this fan is to be used outdoors 120-volt AC electrical outlet (or- or in a damp or wet location, then dinary household current). DO NOT it must be plugged into a Ground use any other type of outlet. Fault Circuit Interrupter (GFCI) re- ceptacle. WarnIng When the fan is used outdoors or in this unit is suitable for ground - a damp or wet location, it must be ed receptacle use only
ページ5に含まれる内容の要旨
ENGLISH aSSyembl LINE Cord SaFEtY tIpS :note Assembly of this fan will be easier if performed by two 1. NEVER pull or yank on the cord people. or the appliance. 1. Slide the Cover Support Cap 2. To insert plug, grasp it firmly over the bottom of the Tele- and guide it into the outlet. scoping Pole. See Figure 1. 3. To disconnect the appliance, grasp the plug and remove it Telescoping Pole from the outlet. 4. Before each use, inspect the line Cover support Cap cord for cuts and/or ab
ページ6に含まれる内容の要旨
aSSy embl ContInued 6. Lower the Base Cover over the 10. Connect the plugs coming from Cast Iron Base. See Figure 1. the bottom of the Telescoping Pole and the insdie of the Elec- 7. Twist the Cover Support Cap trical Cover. clockwise into the Cast Iron Base until it is tight. See Figure 11. Place the Electrical Cover 1. against the bottom of the Cast Iron Base and align the Keyslots 8. Carefully lean the entire assem- in the Electrical Cover with the bly over so it rests on its side
ページ7に含まれる内容の要旨
ENGLISH 13. Hold the wall plug out of the 16. Connect the plugs coming from way and stand the fan upright. the bottom of the Motor Mount and the top of the Telescoping 14. Loosen the Height Adjustment Pole. See Figure 4. Grip on the Telescoping Pole by turning it counterclockwise. See Figure 3. Raise theTelescoping Pole approximately 10 inches. Turn the Height Adjustment Grip clockwise to set the height of the Telescoping Pole. 15. Remove the Motor Mount Set- screw (pre-loaded and
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
ENGLISH 20. Align the three keyhole slots in 23. Loosen the Blade Assembly the Back Grille with the three re- Setscrew so that it does not maining Grille Mounting Screws protrude into the inside of the in the Motor Face, and place the Blade Assembly Sleeve. See Fig- Back Grille onto the Motor Face, ure 8. ensuring that the Grille Mount- Blade ing Screw washers are between Assembly setscrew the screw head and the Back Grille. If necessary, loosen the three remaining Grille Mounting Screw
ページ10に含まれる内容の要旨
24. Slide the Blade Assembly Sleeve 25. With the Hunter logo facing for- over the Motor Shaft, ensuring ward and upright, engage the the Blade Assembly Screw is po- tabs on the lower part of the sitioned over the Flat Portion of Front Grille into the rim of the the Motor Shaft. See Figure 9. Back Grille, as shown in Figure Tighten the Blade Assembly Set- 10, arrow 1. Then, move the screw so that it seats against the top of the Front Grille as shown Flat Portion of the Motor Shaft. in Figu
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
5. To adjust the upward or down- 2. DO NOT immerse the fan in wa- ter or any other liquid. ward flow of air, loosen the An- gle Adjustment Knob beneath the Fan Motor. See Figure 13. CLEaNING GrILLE aNd BLadES Position the fan to the desired 1. Turn the fan off and remove the angle, and tighten the Angle plug from the electrical outlet. Adjust knob. 2. To disassemble the Grille, un- 6. To make the fan oscillate, push latch the Grille Ring Latch, remove the Grille Ring and the the Osc
ページ13に含まれる内容の要旨
ENGLISH Storage roubleS t hootIng 1. To store the fan, disassemble proBLEm the Front and Back Grilles, • Fan will not work. remove the Blade Assembly, and clean the entire fan with a SoLutIoN damp cloth. • Make sure the Interlock Bracket is 2. ALWAYS store the fan in a dry properly installed as directed in the place. assembly instructions. See page 9. 3. NEVER store the fan while it is still plugged in. proBLEm • Fan will not oscillate. 4. NEVER wrap the cord tightly around the fan.
ページ14に含まれる内容の要旨
1 42729-01 12/20/2006
ページ15に含まれる内容の要旨
ESpañoL La colección ® Summer Breeze Ventilador depedestal para interiores/exteriores M Anu A l de Pr OPieTA r i O PA r A l Os MOdel Os 9015x e T 9 01 7 x 42729-02 12/20/2006 1
ページ16に含まれる内容の要旨
I I antetmpor CIÓ nforma n S de I egur dad Lea y guarde estas instrucciones preCauCIÓn 9. Para desconectarlo, tome el enchufe y tire de él para retirarlo de la toma de al utilizar aparatos eléctricos, siem - corriente de pared. NUNCA tire brus- pre deben tomarse precauciones básicas para reducir el peligro de camente del cordón. incendio, choque eléctrico y lesiones 10. Este producto está diseñado para uso personales: doméstico solamente y no para uso 1. Lea todas las instrucciones ante
ページ17に含まれる内容の要旨
ESpañoL I b V en I en do deSJ embala e Gracias por elegir el ventilador de pedestal Cuando desembale el ventilador, guarde Century de Hunter. Este manual le propor- la caja y los materiales de embalaje para ciona instrucciones completas para el uso el caso de que desee mover o embarcar la de su ventilador. Esas son algunas de las unidad posteriormente. características que usted disfrutará con su Retire cuidadosamente todos los artículos ventilador: de la caja. • Un diseño atractivo que mejo
ページ18に含まれる内容の要旨
InStruCCIoneS de pueS at a tIerra Este aparato es para uso casero WI arn ng solamente y se puede enchufar en Si va a usar esta unidad en exte- cualquier tomacorriente de 120 vol- riores o en un lugar húmedo o mo- tios, corriente alterna (c.a.) (voltaje jado, se debe conectar a un recep- residencial normal). NO use ningún táculo con interruptor automático otro tipo de tomacorriente. por falla de puesta a tierra (GFCI). adVtenCI er a Si va a usar esta unidad en exteriores Esta unidad se
ページ19に含まれる内容の要旨
ESpañoL enSamblaJe CoNSEJoS dE SEGurIdad para Nota: Este ventilador se ensam- EL CordÓN ELÉCtrICo bla más fácilmente entre dos personas. 1. NUNCA tire del cordón del aparato 1. Deslice la tapa de apoyo de la cubi- eléctrico. erta sobre la parte inferior del tubo 2. Para insertar el enchufe, agárrelo telescópico. Vea la Figura 1. firmemente y guíelo hacia dentro del tomacorriente. 3. Para desconectar el aparato, agarre el Tubo telescópico enchufe y sáquelo del tomacorriente. 4. Antes d
ページ20に含まれる内容の要旨
enSamblaJ e CI ont CIÓ nua n 6. Baje la cubierta sobre la base. Vea la 10. Conecte los enchufes que salen de la Figura 1. parte inferior del tubo telescópico y del interior de la cubierta eléctrica. 7. Gire la tapa de apoyo de la cubierta en el sentido horario hasta que la 11. Coloque la cubierta eléctrica contra base esté apretada. Vea la Figura 1. la parte inferior de la base y alinee las ranuras de bocallave en la cubi- 8. Apoye cuidadosamente todo el con- erta eléctrica con los tres
