ページ1に含まれる内容の要旨
READ AND SAVE THESE INSTRUCTIONS
™
CARRERA VERANDA
52” Ceiling Fan
Wet Location Owner's Manual
Model Numbers
CF552AW00 - Summer White
CF552GBZ00 - Gilded Bronze
CF552GES00 - Golden Espresso
CF552ORB00 - Oil Rubbed Bronze
CF552WB00 - Weathered Bronze
Net Weight: 21.60 Lbs.
Part No. F40BP73930001 Form No. BP7393-1
U.L. Model No.: CF552
ページ2に含まれる内容の要旨
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
ページ3に含まれる内容の要旨
THIS FAN IS SUITABLE FOR WET LOCATIONS SUCH AS PORCHES, PATIOS, AND DECKS. USE ONLY WITH LIGHT KITS MARKED SUITABLE FOR USE IN WET LOCATIONS. This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver One stepladder 50-100 ft. 12 One wire stripper Three wire connectors (supplied) ! WARNING MATERIALS Before assembly your cei
ページ4に含まれる内容の要旨
Electrical Requirements Your new ceiling fan will require a grounded electrical ! WARNING supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and Turning off wall switch is not sufficient. To avoid capable of withstanding a load of at least 50 pounds. possible electrical shock, be sure electricity is turned off at the main fuse box before attempting installation. All wiring must be in accordance with ! National and Local codes and the ceiling fan must be
ページ5に含まれる内容の要旨
4. The blade flanges have an interlocking feature that 9. Remove the three mounting screws from the must be fully engaged before tightening the screw. bracket switch housing assembly (Figure 5). Make sure all the flanges are properly engaged and then tighten the flange screws. If one of the flanges does not seat properly on the motor hub, loosen the adjacent flange screws, re-engage and reseat the flanges, then tighten the screws again. SWITCH HOUSING ASSEMBLY REMOVE ONE M4 x 10mm SERRATED PA
ページ6に含まれる内容の要旨
12. Remove the hanger ball by loosening the 14. Make sure the grommet is properly installed in setscrew in the hanger ball until the ball falls the coupling cover, then slide the coupling cover freely down the downrod (Figure 7). Remove the on the downrod until it rests on the motor pin from the downrod, then remove the hanger housing. Place the ceiling cover over the ball. Retain the pin and hanger ball for downrod. Be sure that the ceiling cover and the reinstallation in Step 15. coupling cove
ページ7に含まれる内容の要旨
How to Hang Your Ceiling Fan 2. Carefully lift the fan and seat the hanger ! WARNING ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 13). Be The fan must be hung with at least 7' of clearance sure the groove in the ball is lined up with tab on from floor to blades (Figure 11). the hanger bracket (Figure 12). CEILING ! WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until AT LEAST bracket con
ページ8に含まれる内容の要旨
How to Wire Your Ceiling Fan If you feel that you do not have enough electrical ! WARNING wiring knowledge or experience, have your fan installed by a licensed electrician. Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not ! WARNING operate fan until blades are in place. Noise and fan To avoid possible electrical shock, be sure electricity damage could result. is turned off at the main fuse b
ページ9に含まれる内容の要旨
Using Your Ceiling Fan Maintenance 1. Restore electrical power to the outlet box by turning IMPORTANT CARE INSTRUCTIONS the electricity on at the main fuse box. for your Ceiling Fan 2. Check the operation of the fan by gently pulling on Periodic cleaning of your new ceiling fan is the only the pull chain switch. maintenance that is needed. 3. All fans are shipped from the factory with the When cleaning, use only a soft brush or lint free cloth reversing switch positioned “down” to circulate air
ページ10に含まれる内容の要旨
Energy Efficient Use of Ceiling Fans Ceiling fan performance and energy savings rely heavily on comfortable breeze, lower speeds consume less energy. In the proper installation and use of the ceiling fan. Here are a the winter, reverse the motor and operate the ceiling fan at few tips to ensure quality and product performance. low speed in the clockwise direction. This produces a gentle updraft, which forces warm air near the ceiling down Choosing the Appropriate Mounting Location. Ceiling into
ページ11に含まれる内容の要旨
Repair Parts Listing Model Numbers Key No. Description CF552AW00 CF552GBZ00 CF552GES00 CF552ORB00 CF552WB00 * Hanger Ball Assembly, 761655-21 761655-77 761655-35 761655-32 761655-86 Consisting of: 1 Hanger Bracket — — — — — 2 Hanger Ball — — — — — 3 Downrod (4.5”) — — — — — * Parts Bag Containing: 763913-3 763913-3 763913-3 763913-3 763913-3 4 Wire Connector (3) — — — — — 5 Pin, Clevis — — — — — 6 Clip, Hairpin — — — — — 7 Screw, Flat Head M4 x 12mm (1) — — — — — 8 Screw, Pan Head M6 x 14mm, wit
ページ12に含まれる内容の要旨
LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for thirty years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the
