ページ1に含まれる内容の要旨
Ceramic
Tower Heater Instruction Booklet
KCE340
KCE340_IB_A12.indd 3 2/11/12 11:37 AM
ページ2に含まれる内容の要旨
Important Please retain your instruction book for future use. In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 0800 273 845 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au or www.kambrook.co.nz KCE340_IB_A12.indd 2 2/11/12 11:37 AM
ページ3に含まれる内容の要旨
Contents Kambrook Recommends p4 Safety First Your Kambrook Ceramic p7 Tower Heater Quick Start Guide p8 Using your Kambrook Heater p9 Care and Maintenance p11 KCE340_IB_A12.indd 3 2/11/12 11:37 AM
ページ4に含まれる内容の要旨
Kambrook Recommends Safety First IMPORTANT: Please retain your instruction book for future use. At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions. Important Safeguards For Your Kambrook Ceramic Tower Heat
ページ5に含まれる内容の要旨
• To prevent a possible fire or heat damage, • Keep the heater clean. Follow the cleaning allow ample space around the heater (at instructions provided in this book. 1.7m at front and 0.5m at the rear, top and • Always ensure the heater is properly sides) and do not totally or partially block the assembled before use. Follow the air inlet or outlets in any manner. Check the instructions provided in this book. openings from time to time for accumulated • Do not operate the heater on a
ページ6に含まれる内容の要旨
Important Safeguards For All Electrical Appliances continued WARNING: In order to avoid overheating, do not cover the heater. WARNING: This heater is intended for floor use only. Do not mount on the ceiling or wall. WARNING: Children should be supervised to ensure that they do not play with the heater. 6 KCE340_IB_A12.indd 6 2/11/12 11:37 AM
ページ7に含まれる内容の要旨
Your Kambrook Ceramic Tower Heater 1. LCD screen 3. Remote control 2. Control panel; featuring: 4. Remote control signal receiver • Power ‘ON/OFF’ button 5. 2000 watts ceramic heating elements • Mode button (2 heat settings, auto and fan only setting) 6. Oscillating platform • Temperature buttons (+/-) 7. Main power ‘ON/OFF’ switch to set variable temperature Not Shown • Timer button (up to 8 hours) • Safety tip-over cut-out-switch • Swing button to set oscillation • ThermoGuard pro
ページ8に含まれる内容の要旨
Quick Start Guide Turning the heater on Plug the cord into a 230V or 240V Switch the heater ON using Press the ‘POWER’ button to power point and switch on. the main power ‘ON/OFF’ activate heating. The heater switch located at the base will be in HIGH heat mode of the heater. (2000W) and the current room temperature will appear on the LCD screen. Setting the heating mode Pressing the ‘MODE’ button Pressing the ‘MODE’ button Pressing the ‘MODE’ button once will set the heater into twice
ページ9に含まれる内容の要旨
Using Your Kambrook Heater Pressing the ‘MODE’ button once Before First Use will set the heater into the AUTO Remove your heater from its carton mode. AUTO mode allows the heater and associated protective wrapping. to maintain the desired set room Unwind the cord to its full length and temperature. In this setting, the remove any protective cardboard heater will automatically cycle on or foam that may have been used and off to maintain temperature to minimise transportation damage.
ページ10に含まれる内容の要旨
Using Your Kambrook Heater continued Setting the Variable NOTE: There is a tip-over Temperature switch fitted to this heater. If the heater is tipped over, it The variable temperature can be will automatically turn off. The used to maintain your desired room temperature. heater will need to be placed back into the upright position, the heater will be in standby NOTE: The variable temperature mode and the settings will only operates when the heater need to be selected again. is se
ページ11に含まれる内容の要旨
Safety Tip-Over Cut-Out Switch There is a tip-over switch fitted to the base of the heater, if the heater is accidentally tipped over the heater will stop operating. Once the heater is placed back into an upright Position the heater will be in standby mode and the settings will need to be selected again. ThermoGuard Overheating Safety Device Your heater is fitted with a safety device that switches off the heater in the event of overheating. Should this heater stop working, turn off th
ページ12に含まれる内容の要旨
Care and Maintenance • Ensure that the main power • It is then necessary to separate the ‘ON/OFF’ switch of the heater mesh from the filter cover. Once is switched OFF and the unit is separated, shake both the filter disconnected from the power cover and the mesh filter into a outlet before cleaning. rubbish receptacle until all fine dust particles and debris are removed. • Use a clean, dry cloth to clean Wipe over with a soft, dry cloth if the external surfaces of the required to re
ページ13に含まれる内容の要旨
Notes 13 KCE340_IB_A12.indd 13 2/11/12 11:37 AM
ページ14に含まれる内容の要旨
Notes 14 KCE340_IB_A12.indd 14 2/11/12 11:37 AM
ページ15に含まれる内容の要旨
Notes 15 KCE340_IB_A12.indd 15 2/11/12 11:37 AM
ページ16に含まれる内容の要旨
Kambrook - Australia Kambrook - New Zealand Building 2, Port Air Industrial Estate Private Bag 94411 1A Hale Street Botany, Manukau Botany NSW 2019 Auckland 2163 Australia New Zealand Customer Service Line 1300 139 798 Customer Service Line/ Customer Service Fax 1800 621 337 Spare Parts 0800 273 845 Customer Service Fax 0800 288 513 www.kambrook.com.au www.kambrook.co.nz Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the illustration in t
