ページ1に含まれる内容の要旨
BLUE FLAME VENT-FREE PROPANE/LP GAS HEATER
OWNER’S OPERATION AND INSTALLATION MANUAL
CG6P
CG10P
CGS10P
10,000 and 6,000 Btu/Hr
Thermostat and
Non-Thermostat Models
WARNING: Improper installa-
WARNING: If the information in this manual is
tion, adjustment, alteration,
not followed exactly, a fire or explosion may
service, or maintenance can
result causing property damage, personal in-
cause injury or property dam-
jury, or loss of life.
age. Refer to this manual for
correct installation and oper
ページ2に含まれる内容の要旨
PROPANE/LP GAS HEATER 5. Keep all air openings in the front and Do not place clothing or other SAFETY bottom of heater clear and free of de- flammable material on or near bris. This will insure enough air for INFORMATION the appliance. Never place any proper combustion. objects on the heater. WARNINGS 6. If heater shuts off, do not relight until you provide fresh, outside air. If heater Surface of heater becomes very IMPORTANT: Read this owner’s keeps shutting off, have it serviced. hot when ru
ページ3に含まれる内容の要旨
OWNER’S MANUAL PRODUCT PRODUCT IDENTIFICATION FEATURES Control Knob SAFETY DEVICE Piezo Ignitor This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff sys- tem. The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air. PIEZO IGNITION SYSTEM Grill This heater has a piezo ignitor. This system Guard requires no matches, batteries, or other sources to light heater. Glass THERMOSTATIC HEAT Panel CONTROL
ページ4に含まれる内容の要旨
PROPANE/LP GAS HEATER Confined and Unconfined Space PROVIDING ADEQUATE AIR FOR VENTILATION The National Fuel Gas Code, ANS Z223.1 COMBUSTION AND defines a confined space as a space whose The following are excerpts from National VENTILATION volume is less than 50 cubic feet per 1,000 Fuel Gas Code. NFPA 54/ANS Z223.1, Sec- 3 Btu per hour (4.8 m per kw) of the aggre- tion 5.3, Air for Combustion and Ventilation. gate input rating of all appliances installed WARNING: This heater shall All spaces i
ページ5に含まれる内容の要旨
OWNER’S MANUAL AIR FOR COMBUSTION AND VENTILATION Continued DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION Determining if You Have a Confined or Unconfined Space Use this worksheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install heater plus any adjoining rooms with doorless passageways or ventilation grills between the rooms. 1. Determine the volume of the space (length x width x height). Length x Width x Height = _________________ cu.
ページ6に含まれる内容の要旨
PROPANE/LP GAS HEATER AIR FOR COMBUSTION AND VENTILATION 12" Continued VENTILATION AIR Ventilation Air From Inside Ventilation Grills Building Into Adjoining Room, Ventilation Option 2 Grills Or This fresh air would come from an adjoining into Adjoining Remove unconfined space. When ventilating to an Room, Door into adjoining unconfined space, you must pro- Option 1 Adjoining vide two permanent openings: one within Room, Option 3 12" of the ceiling and one within 12" of the floor on the wa
ページ7に含まれる内容の要旨
OWNER’S MANUAL CEILING LOCATING HEATER INSTALLATION This heater is designed to be mounted on a wall. NOTICE: This heater is intended 36" for use as supplemental heat. Use Minimum WARNING: Maintain the mini- 6" this heater along with your pri- Minimum mum clearances shown in Figure From mary heating system. Do not in- 4. If you can, provide greater clear- Sides of stall this heater as your primary Heater ances from floor, ceiling, and Right heat source. If you have a central joining wall. Side
ページ8に含まれる内容の要旨
PROPANE/LP GAS HEATER 4. For thin walls (1/2" or less), insert red INSTALLATION WARNING: Maintain minimum key into wall anchor. Push red key to Continued clearances shown in Figure 8. If “pop” open anchor wings. you can, provide greater clear- IMPORTANT: Do not hammer key! Removing Front Panel Of Heater ances from floor and joining wall. For thick walls (over 1/2" thick) or solid walls, do not pop open wings. 1. Remove two screws near bottom cor- 2. Mark screw locations on wall (see ners of fro
ページ9に含まれる内容の要旨
OWNER’S MANUAL The installer must supply an external regulator. INSTALLATION CAUTION: Use only new, The external regulator will reduce incoming Continued black iron or steel pipe. Inter- gas pressure. You must reduce incoming gas 4. If installing bottom mounting screw into nally-tinned copper tubing may pressure between 11 and 14 inches of water. If hollow or solid wall, install wall anchor. be used in certain areas. Check you do not reduce incoming gas pressure, heater Follow steps 1 through 4
ページ10に含まれる内容の要旨
PROPANE/LP GAS HEATER Test Pressures Equal To or Less Than Pressure Testing Heater Gas INSTALLATION 1/2 PSIG (3.5 kPa) Connections Continued 1. Close equipment shutoff valve (see Fig- 1. Open equipment shutoff valve (see Fig- ure 15). ure 15). CHECKING GAS 2. Pressurize supply piping system by ei- 2. Open propane/LP supply tank valve. CONNECTIONS ther using compressed air or opening 3. Make sure control knob of heater is in propane/LP supply tank valve. the OFF position. WARNING: Test all gas p
ページ11に含まれる内容の要旨
OWNER’S MANUAL Note: If pilot does not stay lit, refer OPERATING LIGHTING to Troubleshooting, pages 14 through INSTRUCTIONS HEATER 16. Also contact a qualified service 1. STOP! Read the safety information person or gas supplier for repairs. in column 1. Until repairs are made, light pilot with NON-THERMOSTAT MODELS 2. Make sure equipment shutoff valve match. To light pilot with match, see CG10P AND CG6P is fully open. Manual Lighting Procedure. FOR YOUR SAFETY 3. Turn control knob clockwise 7.
ページ12に含まれる内容の要旨
OFF HI PROPANE/LP GAS HEATER Note: If pilot does not stay lit, refer LIGHTING OPERATING to Troubleshooting, pages 14 through INSTRUCTIONS HEATER 16. Also contact a qualified service 1. STOP! Read the safety information person or gas supplier for repairs. Continued in column 1. Until repairs are made, light pilot with 2. Make sure equipment shutoff valve match. To light pilot with match, see THERMOSTAT MODEL CGS10P is fully open. Manual Lighting Procedure, page 13. FOR YOUR SAFETY 3. Turn contro
ページ13に含まれる内容の要旨
OWNER’S MANUAL ODS/PILOT AND BURNER OPERATING WARNING: If yellow tipping • Use a vacuum cleaner, pressurized air, occurs, your heater could pro- HEATER or small, soft bristled brush to clean. duce increased levels of carbon Continued monoxide. If burner flame pat- CLEANING BURNER MANUAL LIGHTING tern shows yellow tipping, follow PILOT AIR INLET HOLE PROCEDURE instructions below. 1. Follow steps 1 through 5 under Light- We recommend that you clean the unit every ing Instructions, page 12. 2,500
ページ14に含まれる内容の要旨
PROPANE/LP GAS HEATER TROUBLESHOOTING CAUTION: Never use a wire, WARNING: Turn off heater needle, or similar object to clean and let cool before servicing. Only Note: For additional help, visit DESA ODS/pilot. This can damage ODS/ a qualified service person should International’s technical service web pilot unit. service and repair heater. site at www.desatech.com. Note: All troubleshooting items are listed in order of operation. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY When ignitor button is pr
ページ15に含まれる内容の要旨
OWNER’S MANUAL TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Burner does not light after ODS/pilot is lit 1. Burner orifice is clogged 1. Clean burner orifice (see Cleaning and Maintenance, page 13) or replace burner orifice 2. Burner orifice diameter is too small 2. Replace burner orifice 3. Inlet gas pressure is too low 3. Contact local propane/LP gas company Delayed ignition of burner 1. Manifold pressure is too low 1. Contact local propane/LP gas company 2. Burner orifice
ページ16に含まれる内容の要旨
PROPANE/LP GAS HEATER TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, ci
ページ17に含まれる内容の要旨
OWNER’S MANUAL SPECIFICATIONS CG10P CG6P CGS10P Btu (Variable) 5,000/10,000 4,400/6,000 5,000/10,000 Type Gas Propane/LP Only Propane/LP Only Propane/LP Only Ignition Piezo Piezo Piezo Pressure Regulator Setting 8" W.C. 8" W.C. 8" W.C. Inlet Gas Pressure (inches of water) Maximum 14" 14" 14" Minimum 11" 11" 11" Dimensions, Inches (H x W x D) Heater 18 x 14 x 5 18 x 14 x 5 18 x 14 x 5 Carton 21 x 16 x 7 21 x 16 x 7 21 x 16 x 7 Weight (pounds) Heater 12.9 12.9 13.3 Shipping 15 15 15.4 TECHNICAL SE
ページ18に含まれる内容の要旨
PROPANE/LP GAS HEATER PARTS NOT UNDER ACCESSORY REPLACEMENT WARRANTY Purchase this heater accessory from your PARTS local dealer. If they cannot supply this ac- Contact authorized dealers of this product. Note: Use only original replacement parts. cessory, either contact your nearest Parts If they cannot supply original replacement This will protect your warranty coverage for Central (see page 19) or call DESA part(s), either contact your nearest Parts parts replaced under warranty. Internationa
ページ19に含まれる内容の要旨
OWNER’S MANUAL PARTS CENTRALS These Parts Centrals are privately owned businesses. They have agreed to support our customer's needs by providing original replacement parts and accessories. Baltimore Electric Washer Equipment Co. Dayton Hardware 1715 Main Street P.O. Box 275 1348 Dixwell Avenue Kansas City, MO 64108-2195 North Dayton Station Hamden, CT 06514-0322 1-800-397-7553 KS, MO, AR Dayton, OH 45404-0275 203-248-7553 816-842-3911 All States Parts Department www.washerparts.com 937-258-3721
ページ20に含まれる内容の要旨
PROPANE/LP GAS HEATER ILLUSTRATED PARTS LIST CG10P 8 30 1 18 9 12 11 19 17 7 3 23 4 20 15 17 14 30 16 24 7 5 7 13 26 10 6 22 27 25 21 18 19 7 28 29 2 7 29 25-1 25-2 7 ODS Pilot Assembly 107295 20
