Lux Products T10-1141SAの取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION & OPERATION
INSTALLATION AND
1). THERMOSTAT LOCATION
For accurate temperature control and comfort, correct
OPERATING INSTRUCTIONS
location is very important. On new installations, the
guidelines listed below should be followed as closely as
possible. When replacing an old thermostat, install the new
52014
one in the same location unless these conditions suggest
otherwise.
1. Locate the thermostat on an inside wall about five feet
above the floor, where it is easy to install and adj

ページ2に含まれる内容の要旨

S E L C Y .25 .2 C .12 .3 .15 ■■ Attach wires to terminal screws shown in Figure 2. FIGURE 3 DECORATIVE WALL PLATE (Either wire to either terminal) Push excess wire back into wall opening. ■■ Find anticipator setting on old thermostat. Setting on new thermostat should be the same. Do this by carefully sliding the long pointer on the anticipator over the desired number. If old anticipator setting cannot be determined, look on gas control on furnace, or set it at .6. During heating season, furnace