ページ1に含まれる内容の要旨
TC170 THERMOSTAT
INSTALLATION
1. This thermostat is a 24 VAC only control. Leave the Voltage Selec-
WARNING
!
▲
tion Switch in the 24 VAC position for proper operation. Failure to
select the correct voltage will result in thermostat malfunction or perma-
• READ THESE INSTRUCTIONS CAREFULLY BEFORE
nent thermostat damage.
ATTEMPTING TO INSTALL, OPERATE OR SERVICE THIS
2. Connect wires using the wiring diagram. Wire nut off all unused wires.
THERMOSTAT.
All connections must be located in the ou
ページ2に含まれる内容の要旨
HVAC SETBACK SYSTEMS CONDENSATE OVERFLOW INTERRUPT • Occupancy Detection The remote probe input can be used with a condensate overflow switch • Setback Operation (CO), either in conjunction with a remote probe (normally closed CO • Door Switch Only Operation switch) or with local sensing (normally open CO switch). When con- densate switch activates, the T170 will display the service wrench and Occupancy Detection disable all outputs. Install jumper JP3. The T170 can be used with the PECO S20
ページ3に含まれる内容の要旨
WIRING DIAGRAM OUTPUT RATINGS INPUT PILOT VOLTAGE VOLTAGE DUTY 24VAC 24VAC 24VA OUTPUT CONFIGURATION A table is provided on the inside of the base to docu- ment the function of various outputs. The function of configurable outputs should be filled in when the unit is installed. JP4 JUMPER SELECTION This jumper is temporarily installed at initial power HIGH -VOL TAGE - REMOVE POWER BEFORE SER VICING CAUTION: up to reconfigure outputs 3 through 6. See Output JP4 JUMPER Configuration. JP4 J
ページ4に含まれる内容の要旨
A- Cool Stage Separation SERVICE MENU The AUX, COOL and current separation icons are displayed. The value Access to the Service Menu: can be changed from 0-12F using the Up or Down buttons. 1. Hold the UP Arrow and DOWN Arrow buttons down for 5 seconds. Note: These values are stored and recalled in the event of a power 2. Current display icon will be turned off. failure. 3. Service Menu numbers 1 through A are available. The SYSTEM but- ton is used to scroll to the item to be changed. 4. The
