ページ1に含まれる内容の要旨
EDGE® Pro
33CS
Commercial Thermostat
Owner's Manual
Part Numbers 33CS2PPRH-01 and 33CS2PP2S-01
SAFETY CONSIDERATIONS
• programming option (indicates which settings are being
adjusted)
Read and follow manufacturer instructions carefully. Fol-
• system is in auxiliary (supplemental) mode
low all local electrical codes during installation. All wiring
• cooling set point
must conform to local and national electrical codes. Improper
• heating set point
wiring or installation may damage thermostat.
•
ページ2に含まれる内容の要旨
right corner on the screen, depending on the mode the system is in. If it is the first time the thermostat is being used, the "heat" mode schedule occupied indicator will be displayed. The preprogrmmned heating or cooling temperatures are displayed in a box at the bottom of the screen. Change the displayed temperature set point by pressing fellow schedule _ auto _ off the up or down buttons until the desired setting is reached. held _ on _ heat _,- holiday o/,_ _- cool To change other temperatur
ページ3に含まれる内容の要旨
3. Thearrow willbepointing to"occ"onthescreen. Toset Then use the soft keys to change the start thne, the heat- theoccperiod start time, press thesoftbutton under the ing set point, and the cooling set point. hourorminute indictor andthen press theupordown 9. Press the soft button under the days of the week until the buttons tochange thetime. arrow is pointing to the next day that will be pro- 4. Settheheating temperature set pointforthattime period gralmned. bypressing thesoftbutton under thehe
ページ4に含まれる内容の要旨
around the date. To set the date (D), press the up button condensation on the windows, select a number lower than and stop on the desired date. 5. If there seems to be a lot of static electricity, which of- ten means the air is too dry, select a number higher than 5. 3. If the month (M) needs to be changed, press the soft but- ton under the month on the screen. The selection box will 5. Close the thermostat door. move to the month number. Press the up button to set the To turn off the humidify o
ページ5に含まれる内容の要旨
5. Press the done button. To switch thermostat operation, perform the following: 6. Close the thermostat door. 1. Open the thermostat door. 2. Press and hold the buttons underneath the heat and cool BACKLIGHTING -- The thermostat may feature a low level amount of backlighting until a button is pressed, which increas- set points simultaneously. The screen will display "01" es the lighting temporarily. The user can adjust the intensity of and up to three reset reminders. the backlighting or turn i
ページ6に含まれる内容の要旨
means, forexample, thatif theunocc period temperature set- Table 4 -- Thermostat Error Code Descriptions tingislower than theperiod thatprecedes it,then thethermo- ERROR stat willstart cooling down the space before the beginning of CODE DESCRIPTION the scheduled unocc period. The thermostat does this at an en- The system is not communicating properly, Call the ergy efficient rate. This not only helps make the space as com- E1 local Carrier representative for service fortable as possible, it also
ページ7に含まれる内容の要旨
Copyright 2008 Carrier Corporation Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Catalog No. 04-53330011-01 Printed in U.S.A. Form 33CS-20SO Pg 8 7-08 Replaces: New