Aube Technologies TH147-Pの取扱説明書

ページ1に含まれる内容の要旨

TH147-P & TH148LE-P
2. Installation
Programmable Thermostats
Note: The installation must be performed by an electrician or a qual-
ified installer.
Installation
and User Guide
2.1 Removing the Old Thermostat
IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, CUT
POWER TO THE HEATING/COOLING SYSTEM.
1. Introduction
Remove the old thermostat to access the wires.
The TH147-P and TH148LE-P programmable thermostats can be
Attention: If the old thermostat was mounted onto an electrical box,
used to contr

ページ2に含まれる内容の要旨

2.3 Connecting the Thermostat 2.3.5 4-wire Heating and Cooling Refer to the following table for matching the wire labels with the thermostat terminals. Terminals Description Wire labels Rh Heating power supply Rh, R, 4, V Heat relay Rc Cooling power supply Rc, R Cool relay W Heating signal W, W1, H Y Cooling signal Y, Y1, M Fan relay GFan G, F Un / Un Input for a remote control device (TH148LE-P only) - 2.3.6 5-wire Heating and Cooling Note: Do not connect wires identified as C, X or B. Wrap the

ページ3に含まれる内容の要旨

2.6 Installing the Batteries 3.3 Viewing and Setting the Temperature The ambient temperature is normally displayed. To view the set- point, press once on one of the buttons. The setpoint is dis- played for 5 seconds and is indicated by the symbol on the display. During the setpoint display, press one of the buttons to change it. 3.4 Backlight The display illuminates for 12 seconds when the backlight button or Gently pull out the battery cover. either of the buttons is pressed. Install th

ページ4に含まれる内容の要旨

After replacing the batteries, set the time and day (see section 5.1). 5.2 Setting the Date (TH148LE-P model only) For TH148LE-P model, set the date also (see section 5.2). The date must be needed for the daylight-savings changeover func- Note: The temperature and schedule settings are not erased when tion. the batteries are removed. Press [ Clk ] for 3 seconds to display the year. Set the year using and press [ Clk ] to dis- 4. Configuration Menu play the month. Set the month using and pre

ページ5に含まれる内容の要旨

• 7. Warranty Start time Temperature Day to program setpoint Aube warrants this product, excluding battery, to be free from Period number defects in the workmanship or materials, under normal use and ser- vice, for a period of one (1) year from the date of purchase by the • To select a day to program, press [ Day ] until the day is dis- consumer. If at any time during the warranty period the product is played. Hold for 3 seconds to select all 7 days. determined to be defective or malfunctions,