ページ1に含まれる内容の要旨
PLEASE READ AND SAVE THESE INSTRUCTIONS
NewAir AC-14100E / AC-14100H
Portable Air Conditioner
Owner’s Manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
PARTS LIST Front Back FIG.5 FIG.6 1. Control panel 6. Air filter 2. Carrying handle 7. Exhaust air outlet 3. Water tank 8. Air filter 4. Casters 9. Air inlet 5. Air louvers 10. Cord storage 11. Air inlet 12. Water plug / drainage point Accessories FIG.7 13. Exhaust hose 16. Window spacer – goes into an 19. Drain hose for open window space continuous drainage 14. Exhaust hose adapter - 17. Window spacer – goes into an 20. Activated ca
ページ4に含まれる内容の要旨
INSTALLATION INSTRUCTIONS Installing the Exhaust Hose and Window Kit This portable air conditioner can be vented with either the window kit or with the exhaust hose adapter only: 1. Using the window kit: Window kit FIG. 8 • Open the window and insert the window kit into the open gap. • Close the window until the window kit is held securely. You may need to expand the size of the window kit using the included window spacers. This technique can also be used for sas
ページ5に含まれる内容の要旨
Positioning the Exhaust Hose • Only use the provided exhaust hose with this AC. Insert the exhaust hose into the back of the unit and secure it in place. FIG.11 • Avoid kinks and bends in the exhaust hose. These can cause expelled moist air to accumulate, resulting in overheating and unexpected shut-offs (fig. 11 and 12). FIG.12 • The exhaust hose may be extended from 12 inches (300 mm) to 59 inches (1500 mm), but for maximum cooling efficiency, use the sho
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
OPERATING INSTRUCTIONS Control Panel FIG.17 1. ON/OFF button a. Display 2. Mode button b. Heater indicator (AC-14100H only) 3. Temperature increase button c. Automatic mode indicator 4. Temperature decrease button d. Cooling indicator 5. Fan speed (ventilation) button e. Fan indicator 6. Timer button f. High speed indicator 7. Sleep mode button g. Medium speed indicator 8. Ionizer button (optional) h. Low speed indicator i. Receiver for remote control j. Timer indicator k. Sl
ページ8に含まれる内容の要旨
Setting the Mode/Function 1. Press the MODE button to select the desired mode (cooling, fan, heating). Please note that the heating function is only available in the AC-14100H. 2. The selected mode’s indicator light will turn on. Setting the Temperature 1. Press the increase temperature or decrease temperature button to change the set temperature. 2. The display window will then indicate the set temperature. If no temperature is set, the display will show the room’s ambient te
ページ9に含まれる内容の要旨
Heating Function (Optional – Only Available on AC-14100H Model) This portable air conditioner can work as a heater because it has a heat pump. Ambient warm air is recycled and used to heat specific areas. In order to use the air conditioner as a heater, the exhaust hose must still be fitted onto the unit in order to allow cold air to be removed. When in heating mode, the unit can run on either high or low speed. Ionizer Function (Optional) Press the IONIZER button to turn on the por
ページ10に含まれる内容の要旨
Additional Notes: 1. To prolong the life of the compressor, after turning off the unit, please wait at least 3 minutes before turning the unit back on. 2. The cooling function will turn off if the ambient temperature is lower than the set temperature. However, the fan speed will still continue to operate at the set speed. If the ambient temperature rises above the selected temperature, cooling will resume. 3. The heating function will turn off if the ambient temperature is highe
ページ11に含まれる内容の要旨
DRAINING THE UNIT During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir. If the water reservoir is full, both the compressor and motor will stop and the unit will beep (press any button to stop the beeping sound). The full water tank indicator light will also flash. To resume cooling, empty the water reservoir by following these steps: 1. Turn off the air conditioner and unplug it from the wall socket. To prevent
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
ページ14に含まれる内容の要旨
.TROUBLESHOOTING The air conditioner does not work. Is the air conditioner plugged in? Is the power outlet functioning correctly? Is the full water tank indicator light flashing? Is the ambient room temperature lower than the set temperature? The unit does not produce adequate • Is the unit placed in direct sunlight? If so, close any cooling. curtains or move the unit to a more shaded area. • Are there too many windows or doors open? • Are there too many people in
ページ15に含まれる内容の要旨
