ページ1に含まれる内容の要旨
JANUARY 1996
SP250A
SP251A
Category 5 Primary and Secondary
Surge Protectors
CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX
SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
INFORMATION
Web site: www.blackbox.com • E-mail: info@blackbox.com
TM
Code: SP251A
S/N:
TM
Code: SP250A
S/N:
ページ2に含まれる内容の要旨
NOM STATEMENT NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY STATEMENT INSTRUCCIONES DE SEGURIDAD y y y n e y o o a a l o l a a o l a o o u a o 3 aparato. el en indique se como operaci n, de instructivo el en descrito tipo del s lo poder de fuente una connectado ser deber el ctrico aparato El 11. calor. producen que amplificadores) (incluyendo aparatos otros estufas calor, de registros radiadores, como calor de fuentes de alcance del fuera situado ser deber el ctrico equipo El 10. ventilaci
ページ3に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS y a l o a y a u o l e u o o a a l o o o o u s TRADEMARK USED IN THIS MANUAL a 4 Corporation. Datapoint of trademark registered is ARCNET da ada. sido ha cubierta tirado sido ha aparato El E: desempe o; su en cambio un muestra normalmente operar no parece aparato El D: lluvia; expuesto sido ha aparato El C: aparato; del dentro derramado sido ha l quido ca do han Objectos B: da ado; sido ha contacto poder de cable El A: cuando: provisto ser deber
ページ4に含まれる内容の要旨
TABLE OF CONTENTS Contents Chapter Page 6 8 8 9 5 15 .......................................... Compliance TSB-40A EIA/TIA B: Appendix 14 .................................................................. Compliance IEC A: Appendix 12 ................................................................ Procedures Installation 3.2 10 ................................................................................. Applications 3.1 10 ...................................................................
ページ5に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS 1. Specifications Compliance — Standards — Interfaces — 5 3 CAUTION! Because of clamp-voltage limitations, the Surge ® Protectors are not compatible with ARCNET or Type 1 Token Ring. Maximum Data Rate — Response Time — Characteristic Impedance — NEXT Loss — Appendix B Surge Rating — Surge Clamp Voltage — 6 input 1-kV with maximum volts 13 SP251A: input; 2-kV with maximum volts 15 SP250A: Level Standard 801.5 IEC See Mhz; 100 at dB —46 than bette
ページ6に含まれる内容の要旨
CHAPTER 1: Specifications DC Clamp Voltage — Grounding — Insertion Loss — Return Loss — Group Delay — Series Resistance — m Ω Connectors — Leads/Signals Protected — MTBF — a Maximum Altitude — Temperature Tolerance — F 0 ( o t Humidity Tolerance — Size — x x x x Weight — 1 7 kg) (0.5 lb. cm) 1.9 4.3 (5.7 0.8"D 1.7"W 2.3"H noncondensing 95% to Up C) 60ß 140ß to 32 m) (3048 ft. 10,000 (MIL-HDBK-217E) environment ground-benign in hours 1,595,000 All female RJ-45 (2) 400 than Less MHz) 100 to MHz
ページ7に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS 2. Introduction 2.1 General Overview 5 5 5 a Appendix B 5 a a a CAUTION! These surge protectors will not provide complete protection should your equipment or building be subject to a direct lightning hit, nor will they provide complete protection against severe differences in ground potential (“severe ground loops”). 8 connection. unit-ground-to-chassis-ground separate provides that strap ground external an with accomplished is Grounding MHz). 10
ページ8に含まれる内容の要旨
CHAPTER 2: Introduction 2.2 Important Features ¥ ¥ ¥ 5 ¥ ¥ ¥ 9 install to Easy ground building or ground chassis to directly surges Shunts Mhz 100 at dB —43 than better NEXT compliant Category TSB-40A EIA/TIA Mbps 100 to up rates data at Operation protection surge Multi-level
ページ9に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS 3. Installation 5 3.1 Applications 5 a 5 3.1.1 THE SECONDARY SURGE PROTECTOR (SP251A) a Category 5 Secondary Surge Protectors Figure 3-1. A typical point-of-use application for the SSP. 10 protected. being device the of frame metal grounded the to attached be should SSP the on wire grounding braided flat the Also, SSP). the with included cable patch the use to want might (you protect to want you device the of port communication the to possible as
ページ10に含まれる内容の要旨
CHAPTER 3: Installation 3.1.2 THE PRIMARY SURGE PROTECTOR (SP250A) a a a a a g Category 5 Primary or Secondary Surge Protectors Exterior Electrical Wall Panel Category 5 Local Hub Primary Surge Protector Category 5 Primary or Secondary Surge Protectors To other building or floor Figure 3-2. A typical barrier application for the PSP. 11 round. safety electrical- building s the to connected be should strap braided the wall, external an as such barrier at PSP the install you When protected. being
ページ11に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS 3.2 Installation Procedures 5 3.2.1 CONNECTING THE PSP OR SSP TO AN I/O PORT a 5 Cat. 5 patch cable to protected Cat. 5 input equipment from network (6 inches [15.2 cm] or less) Connection to chassis or safety ground Figure 3-3. Installing a Surge Protector. a a a a a 12 solution. grounding alternative an discuss to support technical supplier s your contact equipment, your on point connection chassis-ground locate cannot you If grounding. chassi
ページ12に含まれる内容の要旨
CHAPTER 3: Installation a CAUTION! Surge energy may run both directions on the ground strap. To provide the best protection, it is essential that the ground strap on the Surge Protector be connected to the chassis ground of the protected device. Do not lengthen the Surge Protector’s ground strap or connect it to a ground other than chassis ground unless instructed to do so by your supplier’s technical support. 3.2.2 CONNECTING THE PSP AT A BARRIER (WALL, BUILDING ENTRANCE, ETC.) a 5 a a a CAUTIO
ページ13に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS Appendix A: IEC Compliance These Category 5 Surge Protectors meet IEC standards 801.2, 801.4, and 801.5 (CE Mark). a Table A-1. IEC Threat Levels as a Function of Class Class Symmetrical Lines Coupling Mode Line = GND, Source Impedance = 42 ohms 1 1.0 kV at 24 A 2 1.0 kV at 24 A 3 2.0 kV at 48 A 4 N/A 5 4.0 kV at 95 A Surge Waveforms (Voltage and Current): 1.2 x 50 µs 14 marks. CE their by evidenced as standards, these with comply to found and t
ページ14に含まれる内容の要旨
APPENDIX B: EIA/TIA TSB-40A Compliance Appendix B: EIA/TIA TSB-40A Compliance 5 5 all Table B-1. Results of TSB-40A Compliance Testing, Part 1: Typical Near-End Crosstalk Measurements NEXT Measurements for the Primary Surge Protector (SP250A) SOURCE/VICTIM PAIRS Freq. 1-2/3-6 1-2/4-5 1-2/7-8 3-6/4-5 3-6/7-8 4-5/7-8 SPEC (MHz) (dB) (dB) (dB) (dB) (dB) (dB) (dB) 1 >80 >80 >80 >80 >80 >80 >65 4 78 71.0 >80 75.0 73.0 77.0 >65 8 75 66.0 >80 70.0 77.0 66.0 62 10 70 63.0 >80 68.0 74.0 69.0 60 16 66 59
ページ15に含まれる内容の要旨
CATEGORY 5 PRIMARY AND SECONDARY SURGE PROTECTORS Table B-2. Results of TSB-40A Compliance Testing, Part 2: Typical Attenuation Measurements Attenuation Measurements for the Primary Surge Protector (SP250A) Freq. Pins 1-2 Pins 3-6 Pins 4-5 Pins 7-8 SPEC (MHz) (dB) (dB) (dB) (dB) (dB) 1 0.0 0.0 0.0 0.0 0.1 4 0.0 0.0 0.0 0.0 0.1 8 0.0 0.0 0.0 0.0 0.1 10 0.0 0.0 0.0 0.0 0.1 16 0.0 0.0 0.0 0.0 0.2 20 0.0 0.0 0.1 0.0 0.2 25 0.1 0.0 0.0 0.0 0.2 31.25 0.1 0.1 0.1 0.2 0.2 62.5 0.2 0.1 0.2 0.3 0.3 100 0
ページ16に含まれる内容の要旨
APPENDIX B: EIA/TIA TSB-40A Compliance Table B-3. Results of TSB-40A Compliance Testing, Part 3: Typical Return-Loss Measurements Return-Loss Measurements for the Primary Surge Protector (SP250A) Freq. Pins 1-2 Pins 3-6 Pins 4-5 Pins 7-8 SPEC (MHz) (dB) (dB) (dB) (dB) (dB) 1 27.4 27.6 28.4 28.0 23 4 37.3 38.0 49.0 42.5 23 8 40.8 42.3 37.8 38.7 23 10 39.6 40.0 35.7 35.4 23 16 37.0 34.0 32.3 33.0 23 20 35.0 30.8 31.0 31.6 23 25 34.5 24.4 29.8 30.4 14 31.25 35.0 23.5 30.0 30.5 14 62.5 24.2 28.7 22
ページ17に含まれる内容の要旨
NOTES
ページ18に含まれる内容の要旨
© Copyright 1996. Black Box Corporation. All rights reserved. 1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746
