ページ1に含まれる内容の要旨
SG10 Spray Guns
Model: 255107
311977C
Maximum Working Pressure: 3600 psi (248 bar, 24.8 MPa)
IMPORTANT SAFETY INSTRUCTIONS. Refer to your
sprayer instruction manual for Pressure Relief, priming and
spray instructions. Keep these instructions.
ti8919a
- For the application of architectural paints and coatings -
The following Warnings are for the setup, use, grounding, maintenance and repair of this equipment. The exclamation point
symbol alerts you to a general warning and hazard symbols refer
ページ2に含まれる内容の要旨
Installing Tip (16) and Guard (15) on Gun Pressure Relief Procedure WARNING WARNING Follow this Pressure Relief Procedure 1.If equipment has recently been operated, whenever instructed to relieve pressure, relieve pressure. Set trigger lock. stop spraying, check or service equipment, or install or clean spray tip. 2. Using a pencil or similar object, insert seat (17) into back 1. Turn OFF power and turn sprayer pressure control to low- of guard (15). est pressure setting. 3. Install guar
ページ3に含まれる内容の要旨
Maintenance 16 WARNING Before performing any maintenance on gun, read all warnings on front cover of this manual and relieve pressure. Cleaning/Replacing Filter (19) 17a 1 1. Relieve pressure. Set trigger lock. 17b 1 2. Unscrew hose from gun at gun swivel. 3. Remove filter (19). 4. Clean filter. Use a soft brush to loosen and remove excess 15 debris. 5. Insert clean filter into handle. 1 Always replace the gasket and Cleanup seat (included with tip) when you replace a worn spray tip. See In
ページ4に含まれる内容の要旨
For complete warranty information contact your local Graco distributor, call Graco customer service: 1-800-690-2894 or visit our website: www.graco.com. All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. This manual contains English. MM 311977 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. P.O. BO
