ページ1に含まれる内容の要旨
ATD-6902
1.8MM PRIMER GUN W/CUP
INSTRUCTION MANUAL
Read this manual carefully and understand it completely.
Retain manual for future use.
Always follow safety precautions to prevent personal injury and/or damage
to the equipment.
Illustrations and photos are intended for reference only. Actual product may vary.
Specifications are subject to change without notice.
Important Safety Instructions
1. Always wear eye protection, gloves and respirator to prevent against harmful
vapors while
ページ2に含まれる内容の要旨
Operating Instructions POWER SOURCE This tool operates best on a clean, dry supply of compressed air delivered at 29 to 50 psi. Use of a moisture trapping air filter (ATD-7812) is highly recommended as moisture or foreign matter can damage the internal parts of this tool. CAUTION: All air pressure in the system should be rated at 29 to 50 psi. Higher or lower pressure can adversely influence the operation or cause damage to this tool. NOTE: To maintain 10 psi at the nozzle, use a mi
ページ3に含まれる内容の要旨
Figure 3 – INCORRECT Figure 4 – CORRECT 3
ページ4に含まれる内容の要旨
ADJUSTMENT 1. Fine-tune the gun to your desired working settings of spray patters, fluid output and degree of paint atomization using the three controls illustrated in Figure 5. Figure 5 Maintenance To clean the gun, pour any leftover paint back into its container. Using thinner, clean out the paint cup and cap. Spray some thinner through the gun to clean the spray head, needle and nozzle. Spray until thinner comes out clean. Clean all paint
ページ5に含まれる内容の要旨
ATD-6902 1.8mm Gun ITEM# ORDERING PART# PART DESCRIPTION ITEM# ORDERING PART# PART DESCRIPTION 1 PRT6900-01 9 AIR ADJUST ASSY PRT6900-09 CUP 2 PRT6900-02 10 AIR VALVE ASSEMBLY PRT6900-10 FILTER (PACK OF 10) 3 PRT6900-1.8 11 1.8mm TIP KIT (NEEDLE, FLUID NOZZLE, AIR CAP) PRT6900-11 FLUID ADJUST ASSEMBLY 4 PRT6900-04 12 FLUID NOZZLE PLUG PRT6900-12 PATTERN ADJUST ASSEMBLY 5 PRT6900-05 13 FLUID NOZZLE WASHER PRT6900-13 GUN BODY 6 PRT6900-06 14 NEEDLE PACKING ASSEMBLY PRT6900-14 AIR INLET FITTING 7 P