ページ1に含まれる内容の要旨
P A N T O N E 2 8 5 B l a c k _ C co m bo_ em b_ co ver
C o m p u t e r i z e d E m b r o i d e r y M a c h i n e
O p e r a t i o n M a n u a l
P r o d u ct C o d e 8 85 - V 51
G ET T I N G REA D Y
EMBR O I D E RY
A P P EN D I X
8 8 5 -V5 1 Pl e a se vi si t u s a t h tt p : / / s o l u t i o n s . b r o t h e r . c o m w h e r e yo u ca n g e t
En g l i sh
p r o d u ct su p p o r t a n d a n sw e r s t o f r e q u e n t l y a ske d q u e st i o n s ( F A Q s) .
X E5 4 2 7 - 0 0 1 ①
Pr i n te d
ページ2に含まれる内容の要旨
0711-0120-C-combo_E.book Page 91 Friday, July 4, 2008 1:35 PM
ページ3に含まれる内容の要旨
0711-0120-C-combo_E.book Page 1 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Introduction Thank you for purchasing this embroidery machine. Before using this machine, carefully read the "Important Safety Instructions", and then study this manual for the correct operation of the various functions. In addition, after you have finished reading this manual, store it where it can quickly be accessed for
ページ4に含まれる内容の要旨
preface1 Page 2 Tuesday, August 19, 2008 3:29 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — • Do not operate where aerosol (spray) products are being used or where oxygen is being administered. Do not use the machine near a heat source, such as a stove or iron; otherwise, the machine, power cord or garment being embroidered may ignite, resulting in fire or an electric shock. Do not place this machine on an unstable surface, su
ページ5に含まれる内容の要旨
0711-0120-C-combo_E.book Page 3 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — FOR USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLY IMPORTANT In the event of replacing the plug fuse, use a fuse approved by ASTA to BS 1362, i.e. carrying the mark, rating as marked on plug. Always replace the fuse cover. Never use plugs with the fuse cover omitted. If the available electrical outlet is not suitable for
ページ6に含まれる内容の要旨
preface1 Page 4 Tuesday, August 19, 2008 3:30 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — 4
ページ7に含まれる内容の要旨
0711-0120-C-combo_E.book Page 5 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Contents Introduction ........................................................................................................................1 Important Safety Instructions ..............................................................................................1 Machine Features ........................................
ページ8に含まれる内容の要旨
0711-0120-C-combo_E.book Page 6 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Embroidering .....................................................................................................................57 Embroidering a pattern .................................................................................................................................... 57 Appliquéing .........................
ページ9に含まれる内容の要旨
0711-0120-C-combo_E.book Page 7 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Machine Features a Automatic thread cutting The thread can be cut automatically after embroidering (page 58). b Fast bobbin winding system With the fast and simple bobbin winder, you can wind bobbins with one press of a button (page 29). c USB port Various embroidery patterns on the website or saved in your PC become availab
ページ10に含まれる内容の要旨
0711-0120-C-combo_E.book Page 8 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Accessories After opening the box, check that the following accessories are included. If any item is missing or damaged, contact your dealer. Included accessories *1 10. 3. 12. 4. 5. 6. 7. 8. 9. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. *1 75/11 3 needles, 90/14 1 needles Part Code Part Code No. Part Name No. Part Name U.S.A. /
ページ11に含まれる内容の要旨
introduction1 Page 9 Wednesday, August 20, 2008 4:08 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Optional accessories The following are available as optional accessories. 1. 2. 3. Part Code No. Part Name U.S.A. / Canada Others Brother poly #90 bobbin EBT-PEN: 1 EBT-PE thread XC5996-001 2 Embroidery card - Embroidery set (small) EF61: 3 H 2 cm × W 6 cm SA431 4. 5. XA6630-102 (H 1 inch × W 2-1/2 inches) Embroidery set (large) H
ページ12に含まれる内容の要旨
introduction1 Page 10 Tuesday, August 19, 2008 4:54 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Names of Machine Parts and Their Functions The names of the various parts of the machine and their functions are described below. Before using the machine, carefully read these descriptions to learn the names of the machine parts. Front view a Thread guide cover (page 31, 39) h Presser foot lever (page 28) Pass the thread under this thr
ページ13に含まれる内容の要旨
0711-0120-C-combo_E.book Page 11 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Needle and embroidery foot Right-side/rear view section a Handle a Thread guide disk (page 40) Carry the machine by its handle when transporting the Pass the thread through the thread guide disk when machine. using the needle threader to thread the needle. b Handwheel (page 38) b Needle bar thread guide (page 40) Turn the
ページ14に含まれる内容の要旨
0711-0120-C-combo_E.book Page 12 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Operation buttons The operation buttons help you to easily perform various basic machine operations. a Start/stop button Press the start/stop button to start or stop embroidering. CAUTION The machine embroiders at a slow speed while the button is pressed. When embroidering is stopped, the ● Do not press the thread cutter but
ページ15に含まれる内容の要旨
0711-0120-C-combo_E.book Page 13 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Operation panel The front operation panel has an LCD (liquid crystal display) and operation keys. a LCD (liquid crystal display) (touch panel) e Memory key Setting for the selected pattern and error messages Press to save embroidery patterns and the alphanumeric appear in the LCD. characters in the machine’s memory. Touch
ページ16に含まれる内容の要旨
0711-0120-C-combo_E.book Page 14 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — 14
ページ17に含まれる内容の要旨
0711-0120-C-combo_E.book Page 15 Thursday, July 24, 2008 1:46 PM 1 GETTING READY The various preparations to start embroidering are described in this chapter. Basic Steps for Embroidering...................................................................................16 Turning the Machine On/Off ..................................................................................17 Attaching the Embroidery Unit................................................................................19
ページ18に含まれる内容の要旨
0711-0120-C-combo_E.book Page 16 Thursday, July 24, 2008 1:46 PM GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Basic Steps for Embroidering This section describes the preparations for embroidering. The basic steps for embroidering are as follows. Attach the embroidery unit. 1 Embroidery unit attachment For details, refer to "Attaching the embroidery unit" (page 19). ↓ Use a needle matched to the fabric. 2 Needle preparation For details
ページ19に含まれる内容の要旨
0711-0120-C-combo_E.book Page 17 Thursday, July 24, 2008 1:46 PM — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Turning the Machine On/Off This section explains how to turn the machine on and off. 1 Power supply precautions Be sure to observe the following precautions concerning the power supply. WARNING ● Use only regular household electricity for the power source. Using other power sources may result in fire, electric shock, or dam
ページ20に含まれる内容の要旨
0711-0120-C-combo_E.book Page 18 Thursday, July 24, 2008 1:46 PM GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — Turning on the machine Turning off the machine When you have finished using the machine, turn it Memo off. In addition, before transporting the machine to another location, be sure to turn it off. Before turning on the machine, be sure to attach the embroidery unit to it. If the Make sure that the machine is completely em
