ページ1に含まれる内容の要旨
PROFESSIONAL AUDIO CD RECORDER
Owner’s Manual
POWER
PEAK TIME INPUT REC LEVEL
PROFESSIONAL
HOLD DISPLAY SELECT UTILITY
OPEN/
AUDIO CD RECORDER
CLOSE
REC
MUTE UV22 REPEAT A-B
SYNC INDEX TRACK
REC AUTO INC INC 010
L R
ON / OFF
PHONES LEVEL
PREV NEXT INDEX SEARCH PAUSE STOP PLAY REC
010
ERASE FINALIZE
PHONES FOOT SW
Keep This Manual For Future Reference.
E
ページ2に含まれる内容の要旨
FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructio
ページ3に含まれる内容の要旨
i Important Information Read the Following Before Operating the CDR1000 Warnings • Do not subject the CDR1000 to extreme temperatures, humidity, direct sunlight, or dust, which could be a potential fire or electrical shock hazard. • Do not allow water to enter this unit or allow the unit to become wet. Fire or electrical shock may result. • Connect the power cord only to an AC outlet of the type stated in this Owner’s Manual or as marked on the CDR1000. Failure to do so is a fire and
ページ4に含まれる内容の要旨
ii • Do not block the CDR1000 ventilation slots. The CDR1000 has ventilation slots at the side and a cooling fan at the rear to keep the internal components cool. Blocking the ventilation slots or obstructing the fan’s airflow is a potential fire hazard. Cautions • Allow enough free space around the unit for normal ventilation. This should be: 10 cm at the sides, 40 cm behind, and 30 cm above. These distances should also be adopted when rack-mounting the CDR1000. For normal ventilat
ページ5に含まれる内容の要旨
iii Interference The CDR1000 uses high-frequency digital circuits that may cause interference on radio and television equipment located nearby. If interference is a problem, relocate the affected equipment. CDR1000 Exclusion of Certain Responsibility Manufacturer, importer, or dealer shall not be liable for any incidental damages includ- ing personal injury or any other damage caused by improper use or operation of the CDR1000. Yamaha cannot be held responsible for any loss o
ページ6に含まれる内容の要旨
iv Contents Contents Incrementing Track Numbers Manually . . . . . 32 1 Introduction . . . . . . . . . . . . 1 Incrementing Index Numbers Manually . . . . . 33 Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Using Auto Rec Start & Track Increment . . . . 34 About this Manual . . . . . . . . . . . . . . . . . . . . . . . . 1 Inserting a Two-second Mute . . . . . . . . . . . . . 35 Installation . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ7に含まれる内容の要旨
Introduction 1 1 Introduction Welcome Thank you for choosing the Yamaha CDR1000 Professional Audio CD Recorder. The CDR1000 is a stand-alone professional audio CD recorder that can record onto blank and partially recorded CD-R and CD-RW discs, and playback prerecorded audio CDs and unfinalized or finalized CD-R or CD-RW discs. See page 2 for a concise rundown of CDR1000 features. About this Manual This Owner’s Manual contains all the information you need in order to operate your
ページ8に含まれる内容の要旨
2 Chapter 1—Introduction CDR1000 Features Recording Media • CD-R (Compact Disc Recordable) • CD-RW (Compact Disc Rewritable) Sonic Performance • 20-bit 64-times oversampling A/D converters • 20-bit 128-times oversampling D/A converters • UV22 Super CD Encoding Flexible I/O • AES/EBU and coaxial (S/PDIF) digital I/O • Balanced XLR analog I/O (switchable –10 dBV/+4 dB) • Headphone output Recording • Up to 99 tracks per disc, up to 99 indexes per track • Built-in sampling-rate conver
ページ9に含まれる内容の要旨
CDR1000 Features 3 Quick Locate • Previous and next track locate • Previous and next index locate • Forward and reverse search • Direct track selection from the remote controller Display • Large, easy-to-read vacuum fluorescent display • Dedicated track and index counters • Elapse, Remain, and Total time display modes • 16-segment level meters, with peak hold Remote Control • Wireless remote controller • 9-pin parallel interface • Optional footswitch Others • Copy Bit setting • Digita
ページ10に含まれる内容の要旨
4 Chapter 1—Introduction Operating Notes This section contains information that will help you get the most from your CDR1000. Playback The CDR1000 can play prerecorded audio CDs and unfinalized or finalized CD-R or CD-RW discs. Only Session 1 of a multi-session disc can be played. Recording The CDR1000 can record onto CD-R and CD-RW discs that feature one of the follow- ing logos. CD-R CD-RW Data Consumer DIGITAL AUDIO DIGITAL AUDIO digital audio The CDR1000 can record up to 99 trac
ページ11に含まれる内容の要旨
Operating Notes 5 Finalization The finalization process writes the final TOC to disc, so that discs can be played on stan- dard CD players. Unfinalized CD-R discs can be played on other CD-R recorders, but cannot be played on standard CD players until they have been finalized. Once finalized, CD-R discs can- not be used for additional recording and are fixed for life. Unfinalized CD-RW discs can be played on other CD-RW recorders. Unlike CD-R discs, CD-RW discs can be erased, and you can eras
ページ12に含まれる内容の要旨
6 Chapter 2—Touring the CDR1000 2 Touring the CDR1000 Front Panel 1 2 3 4 5 6 PEAK TIME INPUT REC LEVEL POWER PROFESSIONAL OPEN/ HOLD DISPLAY SELECT UTILITY AUDIO CD RECORDER CLOSE REC MUTE UV22 REPEAT A-B SYNC INDEX TRACK REC AUTO INC INC 010 L R ON / OFF PHONES LEVEL PREV NEXT INDEX SEARCH PAUSE STOP PLAY REC 010 ERASE FINALIZE PHONES FOOT SW 7 8 9 J K L M N O P QR S A Disc tray Discs are loaded into the CDR1000 using the disc tray. See “Loading & Unloading D
ページ13に含まれる内容の要旨
Front Panel 7 J PREV & NEXT buttons These buttons are used to select tracks. Pressing the PREV [ ] button during play- back selects the top of the current track. Pressing it again selects the top of the previous track. Pressing the NEXT [ ] button during playback selects the top of the next track. See “Selecting Tracks” on page 23 for more information. These buttons are also used with the Utility, Erase, and Sync Recording functions. K INDEX buttons These buttons are used
ページ14に含まれる内容の要旨
8 Chapter 2—Touring the CDR1000 Display 1 2 3 4 5 67 8 TRACK INDEX M S ANALOG AES/EBU COAX ELAPSE 9 CD-RW LOCK SRC REMAIN 88 88 TOTAL88 88 J REC COPY10 SYNC-REC 1 ALL K P CDR1000 REPEAT A B 1 ALL L L dB –60 –50 –40 –32 –24 –18 –14 –12 –10 –8 –6 –4 –3 –2 –1 CLIP O R NM A TRACK counter The track counter displays the selected track number. B INDEX counter The index counter displays the selected index number. C ELAPSE, REMAIN & TOTAL indicators These indicators show the selected time display mode.
ページ15に含まれる内容の要旨
Function Buttons 9 K SYNC-REC indicators These indicators are used with the Sync Recording functions. See “Sync Recording from CD, MD, or DAT” on page 39 for more information. L REPEAT indicators These indicators are used with the Repeat Playback functions. See “Using Repeat Play- back” on page 24 for more information. M PAUSE ( ) indicator This indicator lights up when playback is paused or in Record Standby mode. N REC indicator This indicator flashes in Record Standby mode and lights up conti
ページ16に含まれる内容の要旨
10 Chapter 2—Touring the CDR1000 D UTILITY button & indicator This button is used to select the Utility functions. The UTILITY indicator lights up when a Utility function is selected. Utility Function Settings AUTO TRACK INC dB 30, 35, 40, 45, 50, 55, 60, 70, 96 –dB AUDIO DELAY 0, 66, 132, 198, 264, 330, 396, 462...4,950 ms FADE IN 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 second FADE OUT 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 second FALL TIME SLOW, FAST CLOCK SELECT INT, WORD, AES, COAX DIGITAL OUT NORMAL, T
ページ17に含まれる内容の要旨
Rear Panel 11 Rear Panel AC IN ANALOG OUT ANALOG IN PARALLEL DIGITAL(COAXIAL) DIGITAL(AES/EBU) WORD RL RL OUT IN CLOCK IN OUT IN –10dBV +4dB 1 2 3 4 5 6 7 8 9 J K A Cooling fan The cooling fan keeps the internal components cool. See “Installation” on page 1 for more information. B AC IN connector This connector is used to connect the CDR1000 to an AC outlet, using the supplied power cord. See “Connecting the Power Cord” on page 16 for more information. C ANALOG OUT connectors These balanced ma
ページ18に含まれる内容の要旨
12 Chapter 2—Touring the CDR1000 F PARALLEL port This 9-pin D-sub connector is a general purpose interface that provides access to vari- ous CDR1000 functions. By using custom made switches and cables, it can be used for simultaneous control of multiple CDR1000s in multiple disc recording, or disc dupli- cation systems. See “Using the Parallel Port” on page 51 for more information. G DIGITAL COAXIAL OUT connector This phono jack outputs playback and monitor signals as S/PDIF format digital audi
ページ19に含まれる内容の要旨
Remote Controller 13 Remote Controller Apart from the number key- pad, which is unique to the remote controller, remote controller buttons operate the same as their counterparts on the CDR1000 front panel. A OPEN/CLOSE button J B REC MUTE button OPEN / PEAK TIME CLOSE HOLD DISPLAY K 1 C INPUT SELECT button REC INPUT L MUTE SELECT REPEAT A-B D AUTO button 2 M 3 INDEX TRACK AUTO INC INC E Number keypad N 4 The number keypad is used to O 123 +10 select tracks for playback. See page 23 for mor
ページ20に含まれる内容の要旨
14 Chapter 2—Touring the CDR1000 Block Diagram CDR1000—Owner’s Manual INPUT SELECT WORD AES/EBU CLOCK (CLK SEL) COAX IN INT (D-OUT) ANALOG DIGITAL WORD DIGITAL Driver (AES/EBU) (AES/EBU) Receiver AES DIT OUT SRC SRC IN COAX THRU CD-RW DIGITAL PB DIGITAL Drive Driver (COAXIAL) (COAXIAL) Receiver DIT OUT SRC NORMAL IN Rec L L +4dB ANALOG ANALOG REC A/D D/A IN OUT LEVEL –10dBV R R Front panel buttons LED FLD PHONES FOOT SW CPU PHONES LEVEL PARALLEL
