ページ1に含まれる内容の要旨
9101417100
È
CD-D4000
CD Duplicator
Professional
þ
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
Ø
that may be of sufficient magnitude to constitute a risk of electric
ページ2に含まれる内容の要旨
Important Safety Precautions IMPORTANT (for U.K. Customers) For U.S.A DO NOT cut off the mains plug from this TO THE USER equipment. This equipment has been tested and found to If the plug fitted is not suitable for the power points in your comply with the limits for a Class A digital home or the cable is too short to reach a power point, then device, pursuant to Part 15 of the FCC Rules. obtain an appropriate safety approved extension lead or These limits are des
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: ÉRead all of these Instructions. This reminder is provided to call the CATV system installer’s attention ÉSave these Instructions for later use. to Section 820-40 of the NEC which provides guidelines for proper ÉFollow all Warnings and Instructions marked on the audio grounding and, in particular, specifies that the cable ground shall be con- equipment
ページ4に含まれる内容の要旨
1 - Introduction The TASCAM CD-D4000 CD duplicator provides 1 - Introduction you with a quick and simple method of copying your 1.1 Installing the CD-D4000....................4 original audio material in CD format at more than 1.2 Parts of the CD-D4000 ......................5 real-time speeds, using easily-obtainable, low-cost [1] POWER switch.......................................5 [2] Display....................................................5 CD-R media, with no au
ページ5に含まれる内容の要旨
1 - Introduction In the “Play audio” mode (see 2.5, "Play audio 1.2 Parts of the CD-D4000 track"), a pre-recorded CD may be inserted into this drive, and played back, track by track. The head- The following refer to front panel items only. The phone jack and volume controls of this drive are only rear panel feature is the power cord, which operational in this mode only. should be plugged into a power supply that matches the voltage shown on the rear pa
ページ6に含まれる内容の要旨
1 - Introduction 1.3.4 Care of CD-R media 1.3 Basic operations The Compact Disc medium is a robust medium, and the discs can survive a good deal of physical abuse. 1.3.1 Power-up procedure However, there are precautions that you should take when handling CD-R discs which are different to When the unit is first powered up using the POWER those you should take when handling ordinary CDs. switch 1, it performs a self-check operation, and the screen shows the follo
ページ7に含まれる内容の要旨
2 - Modes The different modes available are: 1 Press the MODE key until the display appears as below (the 4x may also read 2x or 1x, and indi- • Copy cates the speed at which the copy will be made— • Test write see 2.6, "Setting the writing speed"below). • Compare CD-ROM Mode select • Play audio 1 Copy (4X) • Write speed selection These are accessed by pressing the MODE key. 2 Press the ENTER key. Details of these modes are given below. Co
ページ8に含まれる内容の要旨
2 - Modes 2.2 Test write mode 2.3 Possible problems when copying or in test write mode The test operation is functionally similar to the write operation, except that the writing of data to the slave If the MASTER or SLAVE drive does not contain a disc is simulated. This is useful to make sure that disc, or if the disc cannot be read by the drive (it is data can be transferred at the selected rate between upside-down or badly positioned
ページ9に含まれる内容の要旨
2 - Modes 2.4.1 Error conditions 2.4 Compare CD-ROM If no disc has been placed in either the MASTER or SLAVE drive, the display will show a No disc error This mode is used for comparing a CD-ROM which message, with the drive from which the disc is has just been duplicated using the copy mode. It can- missing. not be used for audio CDs. If the master or slave disc is damaged, scratched, or 1 Press the MODE ke
ページ10に含まれる内容の要旨
2 - Modes 4 If the MODE key is pressed from the screen 2.6 Setting the writing speed above, the display changes: Track 05 Play The CD-D4000 SLAVE drive is capable of writing information to a CD or CD-ROM drive at normal 2 Previous track (1X), double (2X) or four times (4X) normal speed. Pressing the ENTER key will start playing the The writing speed is set as described below. track before the current track. If the first track is
ページ11に含まれる内容の要旨
3 - Specifications 3.1 Operational specifications 3.2 Physical specifications Unit Professional CD and CD-ROM Dimensions (W x H x D) 482 x 104.5 x 288 mm (19 x 4.1 x duplicator 11.3 inches) Types of media that may CD-DA (audio CDs) and CD-ROM Weight 6.5 kg (14.3 lbs) a (ISO9600 standard) be copied Voltage and current USA/Canada 120 V ~ 60 Hz, 380 mA requirements: Korea 220V~ 60 Hz 220 mA Maximum write speed 4 times Europe/UK 230 V~ 50 Hz, 220mA Other speeds 2 times, real-time Australi
ページ12に含まれる内容の要旨
È CD-D4000 TEAC CORPORATION Phone: (0422) 52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan TEAC AMERICA, INC. Phone: (323) 726-0303 7733 Telegraph Road, Montebello, California 90640 TEAC CANADA LTD. Phone: 905-890-8008 Facsimile: 905-890-9888 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada TEAC MEXICO, S.A. De C.V Phone: 5-658-1943 Privada De Corina, No.18, Colonia Del Carmen Coyoacon, Mexico DF 04100 TEAC UK LIMITED Phone: 01923-819699 5 Mar
