ページ1に含まれる内容の要旨
9101012300
È
CD-RW5000
CD Rewritable Recorder
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
Ø
that may be of sufficient magnitude to constitute a risk of electric shock to
ページ2に含まれる内容の要旨
Important Safety Precautions For U.S.A IMPORTANT (for U.K. Customers) TO THE USER DO NOT cut off the mains plug from this equipment. This equipment has been tested and found to If the plug fitted is not suitable for the power points in your comply with the limits for a Class A digital device, home or the cable is too short to reach a power point, then pursuant to Part 15 of the FCC Rules. These obtain an appropriate safety approved extension lead or limits are designed to
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: ÉRead all of these Instructions. This reminder is provided to call the CATV system installer’s attention to ÉSave these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding ÉFollow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to t
ページ4に含まれる内容の要旨
SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as class 1 laser product. There is not hazardous invisible laser radiation during oper- ation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regur
ページ5に含まれる内容の要旨
Table of Contents [31] Number keys........................................ 13 1 - Introduction [32] REPEAT key......................................... 13 1.1 About CD-R and CD-RW discs........ 6 [33] PGM key ............................................... 13 1.2 Finalizing........................................... 7 [34] DISPLAY key........................................ 13 1.2.1 “Recordable” disc............................. 7 [35] FIN
ページ6に含まれる内容の要旨
1 - Introduction The TASCAM CD-RW5000 allows you to make reproduction or distribution thereof may result your own standard audio CDs, using cost-effective in severe civil and criminal penalties under standard CD-R discs. CD-RW discs can also be used, copyright laws and international copyright allowing bad “takes” and tracks to be erased and treaties. If you are uncertain about your rights, re-recorded as well as allowing whole discs to be contact your legal advisor. Under no c
ページ7に含まれる内容の要旨
1 - Introduction in a rack, See 1.4, "Environmental considerations" 1.2 Finalizing below for ventilation, etc. parameters. Although audio data may be written on a CD-R or CD-RW disc, an audio CD player will not be able to read the data (i.e. play back the audio) until a final table of contents (TOC) has been written at the start of the disc. The process of writing this table of contents is known as “finalizing”. Once this has been done, no further data can be writte
ページ8に含まれる内容の要旨
1 - Introduction heat such as radiators or heat-generating electrical 1.5 Use of CD-R and CD-RW discs devices. Always store CD-R and CD-RW discs in their “jewel The Compact Disc medium is a robust medium, and cases” to avoid dirt and dust accumulating on their the discs can survive a good deal of physical abuse. surfaces. However, there are precautions that you should take when handling CD-R and CD-RW discs which are When labeling CD-R and CD-RW discs, always use different to those
ページ9に含まれる内容の要旨
2 - Parts of the CD-RW5000 TASCAM CD-RW5000 9
ページ10に含まれる内容の要旨
2 - Parts of the CD-RW5000 Most parts and controls of the CD-RW5000 are In both digital and analog input modes, you can self-explanatory. However, we suggest that you look increment track numbers manually by pressing either through this section in order to gain an overview of the RECORD key [17] or [45], or the TRACK the functions of the CD-RW5000. INCR [39] key while recording is taking place. [8] SOURCE key 2.1 Front panel Us
ページ11に含まれる内容の要旨
2 - Parts of the CD-RW5000 [12]ERASE key NOTE This key only has any effect when a CD-RW disc is The CD-RW5000 needs between 150ms and inserted in the CD-RW5000. If a standard CD or a 400ms to recognize the start of a track. If the CD-R disc is inserted, it will have no effect. audio material starts too close (i.e. within this Pressing this key once will prepare to erase the last time) of the logical track start, the recorded track. Pres
ページ12に含まれる内容の要旨
2 - Parts of the CD-RW5000 Tally signals are open collector, with a maximum [24]COAXIAL digital INPUT current of 40 mA. Input signals are active when low This RCA connector accepts digital audio data in (ground) for ‡ 30 ms. SPDIF format. [29]REMOTE IN connector [25]COAXIAL digital OUTPUT This RCA connector outputs digital audio data in This connector is used for the RC-RW5000 remote SPDIF format. control unit supplied with the CD-RW500
ページ13に含まれる内容の要旨
2 - Parts of the CD-RW5000 The remote control unit keys are listed here, together [37]SYNC START key with the number (in square brackets) of the corre- See [18]. sponding key on the main unit, when these keys are [38]AUTO/MANUAL identical in function to those on the main unit. When these keys have a different function, or are additional See [7]. to those on the main unit, an explanation of their [39]TR
ページ14に含まれる内容の要旨
3 - Playback operations This section gives details of the basic operations you 2 To repeat the whole disc, press the REPEAT can perform when using the CD-RW5000 to play key [32] on the remote control unit twice to back CDs. show REPEAT ALL on the display. The disc will play to the end and then restart playing Playing back CDs on the CD-RW5000 is similar to from the beginning until stopped. pla
ページ15に含まれる内容の要旨
3 - Playback operations 3.3.2Fast searching 1 Press and hold the backward or forward key to search backward or forward at twice nor- The remote control unit features keys to allow pre- mal speed. cise searching and positioning within the CD. 2 Press the FAST key, followed in by the back- ward or forward key to search backward or forward at eight times normal speed. TASCAM CD-RW5000 15
ページ16に含まれる内容の要旨
4 - Recording operations Before starting to record CDs, make sure that all 4.1.1Disc types appropriate connections (analog and digital) are Both CD-R and CD-RW discs can be used. When made both into and out of the CD-RW5000. Turn off inserted into the CD-RW5000, the unit detects the all equipment while making connections to avoid type of disc that has been inserted, and shows either transient noises which may damage your monito
ページ17に含まれる内容の要旨
4 - Recording operations you are recording and enter pause mode on 2 Use the DIGITAL INPUT key [9] to select the source player. If the audio source is a dig- between the three possible digital audio itally-connected CD (coaxial or optical), sources: AES/EBU, COAXIAL and make sure the CD player is stopped, not OPTICAL. paused. It is assumed that the digital program material has been edited so that there is no clipping. If a d
ページ18に含まれる内容の要旨
4 - Recording operations • Automatically, when the signal level drops below 1 Locate the audio source to a little before the –36 dB and stays below that level for 20 seconds or start of the material you are recording, and more. insert a disc into the CD-RW5000. • Manually, using the CD-RW-5000’s STOP key. • If you are recording a CD using a digital connec- SYNC ALL tion , you should not pause the CD play
ページ19に含まれる内容の要旨
4 - Recording operations When recording from analog sources, you should NOTE take care that the signal level is low enough to avoid distortion on the finished CD. You cannot use the manual track division facility if the automatic synchronization is The INPUT level controls [10] should be used to selected. Make sure that this facility is turned adjust the level of the input signal, with reference to off before you start recording with manual the me
ページ20に含まれる内容の要旨
4 - Recording operations disc, the disc can be completely erased for further 4.7.1Erasing a finalized disc recording, however). The whole contents (audio material and subcode) will all be erased. This allows you to use a single 1 With the disc to be finalized inserted into the CD-RW disc many times as a pre-master disc for CD-RW5000, press the FINALIZE key [11] duplication. or [35]. 1 Make sur
