ページ1に含まれる内容の要旨
9101423400
È
CD-450
Compact Disc Player
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
Ø
that may be of sufficient magnitude to constitute a risk of electric shock to person
ページ2に含まれる内容の要旨
Important Safety Precautions Note for U.K. Customers TO THE USER DO NOT cut off the mains plug from this This equipment has been tested and found to comply equipment. with the limits for a Class A digital device, pursuant to If the plug fitted is not suitable for the power points in Part 15 of the FCC Rules. These limits are designed your home or the cable is too short to reach a power to provide reasonable protection against harmful interference when the equipment is
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: ÉRead all of these Instructions. This reminder is provided to call the CATV system installer’s attention to ÉSave these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding ÉFollow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to
ページ4に含まれる内容の要旨
SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisi- ble laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown 1. CAUTIO
ページ5に含まれる内容の要旨
Before Getting Started Thank you for choosing the TASCAM CD-450 com- Mounting in a 19" Rack pact disc player. This unit comes with a rack mount vis kit allowing the To get the most out of your CD-450, spend some time unit to be mounted in an EIA standard 19-inch rack, as now to read this manual. If you read this manual thor- shown. oughly at least once, you will know where to turn when you need answers. This manual is divided into the following sections: Important Safety Precautions . . . .
ページ6に含まれる内容の要旨
Specifications Disc: 8-cm/12-cm CD Power requirements: 120 V AC, 60 Hz (U.S.A./Canada model) Audio channel: 2 channels 230 V AC, 50 Hz (Europe/U.K. model) Quantization: 16-bit linear 240 V AC, 50 Hz (Australia model) Sampling frequency: 44.1 kHz Analog output level Line output (RCA) Power consumption: 16 Watts Nominal output level: –10 dBv (load impedance External dimensions: 482 x 104.5 x 310 mm 10kOhms, unbalanced) Weight: 5.1 kg Maximum output level: +6 dBv (2Vrms) Line output (XLR) [Option
ページ7に含まれる内容の要旨
General Guide 1 POWER Switch E PLAY Key 2 Headphone Volume Control (PHONES) F READY Key This key puts the deck into Ready-for-play mode. 3 Headphone Jack G CALL Key 4 Disc Tray The point where you press PLAY to leave the ready mode and start playing is stored in memory, and you 5 Numeric Keypad can go back to that point by pressing this CALL key. This is used to enter tack numbers, index numbers and time points. H AUTO READY Key When this key is pressed on, the deck goes into Ready 6 CLEAR K
ページ8に含まれる内容の要旨
General Guide O ATTenuator — Optional wiring of these conductors, see illustration under the heading, "Fader Start," p.11. This reduces the balanced analog output level by 12 dB at maximum. P ANALOG OUTPUT Connectors ( RC-450C Remote Control Unit — Optional ) (BALANCED) — Optional W PGM (Program) Key A +4 dBu analog output signal is available at these A maximum of 30 tracks can be programed to play in XLR-type connectors. sequence. ¨ p.10 Q DIGITAL OUTPUT Connector X CHECK Key (AES/EBU) — Op
ページ9に含まれる内容の要旨
Preference Settings Settings you make here are stored in EEPROM so they They are factory preset to become default settings. OFF EOM 1 Hold STOP and press POWER to enter a OFF preference setting mode. OFF –72 dB 2 Use the SKIP keys to select the desired items. respectively. E)SEF = EOSET: End-of-Message triggering time setting; 5 to 35 seconds, in 5-sec- ond steps. 3 Set the necessary parameters with the SEARCH keys. FALLY = TALLY: Tally signal output timing; at EOM or STOP time. 4 To termina
ページ10に含まれる内容の要旨
Operations Programed Play Changing the Pitch A maximum of 30 tracks can be programed. 1 Press the PGM key on the optional remote to let "PROGRAM" show in the display. By operating the "+" and "–" keys of PITCH CONT you can change the pitch within the limits of 2 Enter the desired tracks on the numeric keypad. ±12% in 1% steps. The pitch percent value is * To enter track 5 for example, press 0 then 5. shown in the INDEX display window. Press the PITCH CONT switch to let its LED light To delete t
ページ11に含まれる内容の要旨
Operations Fader Start Backup Memory You can let the deck go into Play or Ready, as con- Each time you turn this unit off, the status of the fol- trolled from a fader switch. lowing features are stored in backup memory, so that they are restored when you turn the unit on again. RING SLEEVE RING FADER/EVENT É On/Off of REPEAT START connector PLAY É On/Off of SINGLE READY É On/Off of INCR PLAY TIP SLEEVE TIP É On/Off of AUTO READY É DISPLAY mode (ELAPSED, REMAIN, or TOTAL REMAIN) Event Start É O
ページ12に含まれる内容の要旨
È CD-450 TEAC CORPORATION Phone: (0422) 52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan TEAC AMERICA, INC. Phone: (213) 726-0303 7733 Telegraph Road, Montebello, California 90640 TEAC CANADA LTD. Phone: 905-890-8008 Facsimile: 905-890-9888 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada TEAC MEXICO, S.A. De C.V Phone: 5-658-1943 Privada De Corina, No.18, Colonia Del Carmen Coyoacon, Mexico DF 04100 TEAC UK LIMITED Phone: 01923-819699 5 Marlin House, Marlins Meadow, The C
