ページ1に含まれる内容の要旨
1-BIT DIGITAL AUDIO SYSTEM
SD-CX1H
OPERATION MANUAL
ページ2に含まれる内容の要旨
l l l l Special Notes NOTES FOR USERS IN THE U.K. AND IRELAND The mains lead of this product is fitted with a non-rewireable (moulded) Ensure that neither the brown nor the blue wire is connected to the earth plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI terminal in your three pin plug. or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used. Before replacing the plug cover, make sure t
ページ3に含まれる内容の要旨
WARNING NOTES When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still Recording and playback of any material may require consent, which SHARP is present inside the unit. When the ON/STAND-BY button is set at STAND-BY posi- unable to give. Please refer particularly to the provisions of the Copyright Act tion and the clock is displayed, the unit may be brought into operation by the timer 1956, the Dramatic and Musical Performers Protection Act 1958
ページ4に含まれる内容の要旨
Introduction Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. Contents Page Page Important Instruction Radio Special Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3 Listening to the Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 - 27 General Informati
ページ5に含まれる内容の要旨
Precautions General In case of an electrical storm, unplug the unit for safety. Please ensure that the equipment is positioned in a well-ventilated area and ensure that there is at least 10 cm (4") of free space along the sides, top and back of the equipment. 10 cm (4") Hold the AC power plug by the head when removing it from the wall socket, as pulling the lead can dam- age internal wires. 10 cm (4") 10 cm (4") 10 cm (4") Use the unit on a firm, level surface fre
ページ6に含まれる内容の要旨
Accessories Precautions (continued) Warning: Please confirm that the following accessories are included. The voltage used must be the same as that specified on this unit. Using this prod- uct with a higher voltage other than that which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. CD players use a laser
ページ7に含まれる内容の要旨
Controls and Indicators Front panel Reference page 1. CD Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 3 2. CD Cover Open/Close Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 3. Remote Sensor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2 4 4. Function Indicator 5. Timer Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 1 6. On
ページ8に含まれる内容の要旨
Controls and Indicators (continued) Multi-function LCD display 1. Level Meter/Character Information/Frequency Indicator 2. Band Selector Indicator 3. Record Indicator 4. CD/MD Play Indicator 5. Top Position Indicator 6. Record Mode Indicator 7. RDS Indicator 1 8. Traffic Programme Indicator 9. Traffic Announcement Indicator 10.MD Record Pause Indicator 11.Dynamic PTY Indicator 2 12.CD/MD Repeat Indicator 13.EON Indicator 3 14.Programme Type Indicator 4 15.Traffic Information Indicator 16.Surro
ページ9に含まれる内容の要旨
Rear panel Reference page 1 2 1. Cooling Fan 2. Speaker Terminals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 3. FM 75 Ohms Aerial Socket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 4. Aerial Earth Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 5. AM Loop Aerial Socket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 6. AC Input Socket . . . . . . . . . . . . . . . . . .
ページ10に含まれる内容の要旨
Controls and Indicators (continued) Remote control Reference page 1. Remote Control Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 1 2. CD/MD Play Mode Select Button 2 3. MD Record Mode Button 4. On/Stand-by Button 3 5. MD Record Button 6. Top Position Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .39 4 7. Track Edit Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .38 21 8. Sound Synch
ページ11に含まれる内容の要旨
Remote Control Battery installation Test of the remote control Check the remote control after checking all connections have been made correctly. 1 Open the battery cover. (See pages 12 - 14.) 2 Insert the supplied batteries according to the direction indicated in Face the remote control directly to the remote sensor on the unit. the battery compartment. The remote control can be used within the range shown below: When inserting or removing the batteries, push them towards
ページ12に含まれる内容の要旨
System Connections FM aerial AM loop aerial Left speaker Right speaker Wall socket (AC 230V, 50 Hz) Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours) 12 00/12/17 CX1H_UK11-16.fm Preparation for Use System Connections
ページ13に含まれる内容の要旨
Aerial connection External FM or AM aerial Supplied FM aerial: Use an external FM or AM aerial if you require better reception. Consult your dealer. External FM aerial External AM aerial Connect the FM aerial wire to the FM 75 OHMS AM loop aerial 15 m (49 feet) socket and position the FM aerial wire in the di- rection where the strongest signal can be re- 7.5 m ceived. (25 feet) Earth rod Notes: When an external FM aerial is used, disconnect the supplied FM aerial wire from
ページ14に含まれる内容の要旨
System Connections (continued) To mount the speakers on the wall How to apply non-slip sheets The design of the speakers allows them to be hung on the wall. Be sure to use the type and Adhere the non-slip sheets to the Adhere the non-slip sheets on the size of screw that is shown below. bottom of the speaker. lower back of the speaker, and then 1 Make a hole in the wall using a drill. mount it to the wall. 2 Drive a wall mount plug into the hole using a hammer. Drive the wall mount plug
ページ15に含まれる内容の要旨
General Control You can select and change to the colour you like from 7 different colours. 1 Press the ON/STAND-BY button to turn the power on. 2 Press the DISPLAY button for 2 seconds or more. 3 Press the REC LEVEL/CURSOR or button to select "COLOR". 4 Press the ENTER button. 5 Press the REC LEVEL/CURSOR or button. INITIAL The colour changes automatically along with the operation. You can select a colour you like. FIXED DAILY The colour changes according to the day of the week. RAN
ページ16に含まれる内容の要旨
Sound Control Volume control Press the VOLUME button to increase the volume and the VOLUME button for decreasing. Bass control When the X-BASS button is pressed, the unit will enter the extra bass mode which emphasises the bass frequencies. To cancel the extra bass mode, press the X-BASS button. Bass is emphasised. Cancelled. Surround Press the SURROUND button to allow you to enjoy music that seems to surround you. "SURROUND" will appear. Press the SURROUND button again to cancel the s
ページ17に含まれる内容の要旨
Setting the Clock 7 Press the REC LEVEL/CURSOR or button to adjust the date, and then press the ENTER button. 8 Press the REC LEVEL/CURSOR or button to adjust the hour, and then press the ENTER button. 9 Press the REC LEVEL/CURSOR or button to adjust the minutes, In this example, the clock is set for 9:30 15. 02 '01 . and then press the ENTER button. 1 Press the ON/STAND-BY button to turn the power on. 2 Press the TIMER/DELETE button. The hour will not advance even if minutes advance f
ページ18に含まれる内容の要旨
Listening to a CD 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button. 3 Press the CD button to open the CD cover. 4 Set a CD and press the CD button. Total number of tracks Total playing time 5 Press the CD button to start playback. When the last track has finished playing, the CD player will stop automatically. Load a CD firmly with the label side facing toward you. To interrupt playback: Press the CD button. To resume playback from the same point, press the CD
ページ19に含まれる内容の要旨
To remove the CD: To locate the beginning of a track Whilst in the stop mode, press the CD button. Press the CD eject button and remove the CD. To move to the beginning of the next track: Press the button during playback. You can skip to any track by pressing the button repeatedly until the desired track number appears. To restart the track being played: Press the button during playback. You can skip to any track by pressing the button repeatedly until the d
ページ20に含まれる内容の要旨
Listening to a CD (continued) Switching to the level meter Each time the DISPLAY button on the remote control is pressed during playback, the display will change. The elapsed playing time for the current track will be displayed. The level meter will be displayed. Switching the time display Each time the TIME button on the remote control is pressed during playback, the dis- play will change. The elapsed playing time for the current track will be displayed. The remaining playing time
