ページ1に含まれる内容の要旨
Thank you for purchasing this SHARP product.
To obtain the best performance from this product, please read this
MINI COMPONENT SYSTEM
manual carefully. It will guide you in operating your SHARP product.
CD-DD4500 Mini Component System consisting of CD-DD4500 (main unit),
MODEL
CP-DD4500 (Front), center (GBOXS0064AWM1), surround (R)
(GBOXS2008AWM1) and surround (L) (GBOXS4008AWM1) speaker sys-
tem.
CD-DD4500
OPERATION MANUAL
ページ2に含まれる内容の要旨
Special Notes NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. CAUTION: TO REDUCE THE RISK OF
ページ3に含まれる内容の要旨
Important Safeguards CD-DD4500 1 CAUTION 12 Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, All the safety and operating instructions should be read before the appliance is be sure the antenna system is grounded so as to provide some protection against operated, and should be retained for future reference. voltage surges and built-up static charges. Section 810 of the National Electrical 2 Electrical energy can perform many useful functions. This unit has been eng
ページ4に含まれる内容の要旨
Contents General Information Page Tape Playback Page Accessories ......................................................................................... 4 Listening to a Cassette Tape (TAPE 1 or TAPE 2) .......................... 24 Precautions ......................................................................................... 5 Controls and Indicators ................................................................6 - 9 Tape Recording Recording from the Radio ...........................
ページ5に含まれる内容の要旨
Precautions CD-DD4500 1 Warning: General The voltage used must be the same as that specified on this unit. Please ensure that the equipment is positioned in a well ventilated area and Using this product with a higher voltage other than that which is specified is dan- 2 ensure that there is as least 4" (10 cm) of free space along the sides, top and gerous and may result in a fire or other type of accident causing damage. SHARP back of the unit. will not be held responsible for any damage resultin
ページ6に含まれる内容の要旨
Controls and Indicators Front panel Reference page 78 9 01. Disc Tray .......................................................................................... 18 10 02. Surround Effect Buttons .......................................................... 29, 30 03. Timer Set Indicator .......................................................................... 37 11 04. Power On/Stand-by Button ................................................ 15, 36, 41 12 05. Tape 2 Cassette Compartment ..........
ページ7に含まれる内容の要旨
CD-DD4500 1 Display 1 23 4 01. Left Front Speaker Indicator 2 02. Low Frequency Effect Indicator 03. Center Speaker Indicator 3 55 04. Right Front Speaker Indicator 05. Subwoofer Indicator 06. Left Surround Speaker Indicator 4 07. Surround Indicator 67 8 08. Right Surround Speaker Indicator 9 1011 12 13 14 15 16 5 09. Extra Bass Indicator 10. Tape 2 Record Indicator 11. CD Repeat Indicator 6 12. Disc Number Indicators 13. FM Stereo Receiving Indicator 17 7 14. FM Stereo Mode Indicator 15. Sleep
ページ8に含まれる内容の要旨
Controls and Indicators (continued) Remote control Reference page 01. Remote Control Transmitter 02. CD Memory Button 1 1 03. Set Up Menu Select Buttons .................................................. 31 - 34 15 2 04. Menu Button .............................................................................31 - 34 3 16 05. Item Button ...............................................................................31 - 34 06. Disc Number Select Buttons 07. CD Random Button ......................
ページ9に含まれる内容の要旨
CD-DD4500 1 Speaker system 2 Center speaker Front speaker (left) 3 1 4 2 1 4 5 5 2 6 6 3 01. Full-Range Speaker 7 02. Speaker Wire Front speaker (right) 8 9 Surround speaker 1 4 10 1 2 5 2 11 1 6 3 2 12 13 01. Woofer 02. Tweeter 01. Full-Range Speaker 14 03. Subwoofer 02. Speaker Wire 04. Speaker Wire for SUBWOOFER Terminals 15 05. Bass Reflex Duct 06. Speaker Wire for MAIN Terminals 9 *CD_DD4500_P04_09 9 2001.4.19, 11:42 PM General Information – Controls and Indicators –
ページ10に含まれる内容の要旨
System Connections FM antenna AM loop antenna Center speaker Surround speaker (right) Surround speaker (left) Front speaker (left) Front speaker (right) AC outlet (AC 120 V, 60 Hz) 10 *CD_DD4500_P10_14 10 2001.4.19, 11:41 PM Preparation for Use – System Connections –
ページ11に含まれる内容の要旨
Connections (continued) CD-DD4500 1 Surround speakers Speaker connection Connect each surround speaker wire to the SURROUND SPEAKER jack as shown. Front speakers Use speakers with an impedance of 8 ohms or more, as lower impedance speakers 2 Main terminals: can damage the unit. Connect the black wire to MAIN(–) terminal and the blue wire to the MAIN(+) terminal. Left Right Subwoofer terminals: 3 Red White Connect the black wire to the SUBWOOFER(–) terminal and the red wire to the SUBWOOFER(+) te
ページ12に含まれる内容の要旨
Speakers Surround speakers: Placing the speakers The surround speakers should be installed on the wall. Install them 23-5/8" - 35-7/16" (60 - 90 cm) above the height of your ears when seated, if possible (see page 13). When you connect this unit to a DVD player playing a disc with the trade- mark, you can enjoy realistic, powerful sound by playing the soundtrack through 5 Example: When installed on the wall channels; the front left, front right, center, surround left and surround right speakers
ページ13に含まれる内容の要旨
Speakers (continued) CD-DD4500 1 Bi-amp system: To install the surround speakers on the wall Each speaker unit has a built-in subwoofer (low frequency range) which is driven sepa- Sharp designed the surround speakers so you may hang them on the wall. rately from the woofer and tweeter (mid-to-high frequency range). Two independent 2 Be sure to use the correct type and size of screw, as shown below. amplifiers which have individual frequency characteristics are used. By amplifying separately the
ページ14に含まれる内容の要旨
Remote Control Battery installation Test of the remote control Face the remote control directly to the remote sensor on the unit. Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included. The remote control can be used within the range shown below: Press the POWER button. Does the power turn on? Now, you can enjoy the music. 1. Remove the battery cover. 2. Insert the batteries according to the direction indicated in the bat- tery compartment. When inserting or removi
ページ15に含まれる内容の要旨
General Control CD-DD4500 1 Demonstration mode The first time the unit is plugged, the unit will enter the demonstration mode. You will 2 see words scroll. 3 4 To cancel the demonstration mode: When the unit is in the power stand-by mode (demonstration mode), press the X- 5 BASS/DEMO button. The demonstration mode will be canceled and the display will disappear. 6 To return to the demonstration mode: When the unit is in the power stand-by mode, press the X-BASS/DEMO button again. 7 Note: When th
ページ16に含まれる内容の要旨
Sound Control Volume control Main unit operation: When the VOLUME control is turned clockwise, the volume will increase. When it is turned counterclockwise, the volume will decrease. Remote control operation: Press the VOLUME UP button to increase the volume and the VOLUME DOWN but- ton for decreasing. ..... 01 2 29 30 MAXIMUM Bass control When the power is first turned on, the unit will enter the extra bass mode which empha- sizes the bass frequencies, and “X-BASS” will appear. To cancel the ex
ページ17に含まれる内容の要旨
Setting the Clock CD-DD4500 1 4 Press the TUNING/TIME (X X X or W W W) button to adjust the hour and X X W W then press the MEMORY/SET button. 2 3 Press the TUNING/TIME (X or W) button once to advance the time by 1 hour. Hold it down to advance continuously. 4 When the 12-hour display is selected, “AM” will change automatically to “PM”. 5 5 Press the TUNING/TIME (X X X X X or W W W W W) button to adjust the minutes and then press the MEMORY/SET button. 6 7 Press the TUNING/TIME (X or W) button o
ページ18に含まれる内容の要旨
Listening to a CD (CDs) This system can play audio CD-R and CD-RW discs just as CD discs, but cannot perform recording. 1 Press the POWER button to turn the power on. 2 Press the CD button. 3 Press the 7 7 7 7 7 OPEN/CLOSE button to open the disc tray. 4 Place the CD(s) on the disc tray, label side up. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. CDs can be placed on any open position on the disc tray. Be sure to place 3" (8
ページ19に含まれる内容の要旨
Advanced CD playback (continued) CD-DD4500 1 To locate the beginning of a track 7 Press the 0/R 0/R 0/R 0/R 0/R (0 R 0 R 0 R 0 R 0 R) button to start playback. 2 To move to the beginning of the next track: Press the W PRESET 2 4 button for less than 0.5 seconds during playback. 3 You can skip to any track by pressing the W PRE- SET 2 4 button repeatedly until the desired track number appears. Playback will begin from track 1 on the disc you have selected to play. 4 After that disc finishes playi
ページ20に含まれる内容の要旨
Listening to a CD (CDs) (Continued) Repeat or Random Play Starting playback with a desired track Repeat Play You can play a disc starting with the desired track. All tracks on up to 3 discs, or a programmed sequence can be continuously repeated. To repeat all tracks on up to 3 discs: 1 While in the stop mode, press one of the s s s s s 1 - s s s s s 3 buttons or Press the 0/R (0 R) button twice. DISC SKIP button to select the desired disc. Selected disc number To repeat a desired track: Perform
