ページ1に含まれる内容の要旨
REFRIGERATOR-
FREEZER
ZI 920/8 FF
© Electrolux plc 2002
INSTRUCTION BOOKLET
2222 122-72
ページ2に含まれる内容の要旨
Should adjustment of the furniture door be necessary, use the clearance of slots as required. IMPORTANT SAFETY INFORMATION At the end of operations, it is necessary to check if It is most important that this instruction book should be retained with the appliance for future the door of the furniture closes properly. reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in or
ページ3に含まれる内容の要旨
50mm 20 mm Separate parts A, B, C, D as shown in the figure B A CONTENTS Instructions for the User Instructions for the C Installer Important Safety Information 2 D Technical Specification 13 Description of the Appliance 4 PR266 Installation 14 Operation 5 Positioning 14 Before use 5 Setting the temperature 5 15 Electrical Connection Place guide (A) on the inside part of the furniture door, in the upper and lower position as shown in the The freezer compartment 5 Door Reversal 16 figure and mark
ページ4に含まれる内容の要旨
DESCRIPTION OF THE APPLIANCE A Push appliance into housing until stop strip (A) touches the kitchen unit. A B K C D023 J D I Open the door and push the appliance against the H side of the kitchen unit opposite to that of appliance E hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. G Snap the ventilation grille (C) and hinge cover (D) D into position C D723 F Press in the joint covers between the appliance and the kitchen unit. A - Thermostat control f
ページ5に含まれる内容の要旨
50 OPERATION Instructions for totally built-in appliances Before using Door reversal Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of The appliance is supplied with the door soda (5 ml to 0.5 litre of water). hinges on the right or on the left. To Do not use soap or detergent as the smell may change the opening direction of the doors linger. Dry thoroughly. proceed as follows before installing the appliance. Setting the temperature 1. Gently lay the
ページ6に含まれる内容の要旨
For replacement, use a 13amp BSI362 fuse. Only Fresh food refrigeration ASTA or BSI approved fuses should be used. Electrical connections Warning To obtain the best performance, do not store warm The plug must not be used if the fuse cover/carrier is Any electrical work required to install this appliance Do not put carbonated liquids, (fizzy drinks etc.), in food or evaporating liquids in the refrigerator; do lost. The cover/carrier is indicated by the coloured should be carried out by a qualifi
ページ7に含まれる内容の要旨
Movable shelves INSTALLATION The walls of the refrigerator have runners so that the shelves can be positioned as desired . Important For better use of space, the front half-shelves can lie Warning over the rear ones. IF YOU ARE DISCARDING AN OLD APPLIANCE It must be possible to disconnect the appliance from THAT HAS A LOCK OR CATCH ON THE DOOR, the mains power supply; the plug must therefore be YOU MUST ENSURE THAT IT IS MADE easily accessible after installation. UNUSABLE TO PREVENT YOUNG CHILDR
ページ8に含まれる内容の要旨
HINTS AND TIPS TECHNICAL SPECIFICATIONS Try to avoid keeping the door open for long Food Storage periods, or opening the door too frequently as POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz To obtain the best results from your appliance, warm air will enter the cabinet, and cause the neither hot foods nor liquids which may compressor to switch on unnecessarily often. TOTAL POWER ABSORBED 160 W evaporate, should be placed in the larder Ensure there are no obstructions preventing the
ページ9に含まれる内容の要旨
GUARANTEE CONDITIONS MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Standard guarantee conditions out, DISCONNECT the appliance from the We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part ELECTRICITY supply. thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that:
ページ10に含まれる内容の要旨
This is due to the air temperature within the refrigerator compartment being maintained at 6°C or under thus not calling the thermostat to energise the compressor . SOMETHING NOT WORKING During a normal night time period of approximately 8 hours a traditional fridge freezer can normally maintain the Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or frozen food temperature but if the appliance is left for longer period in a low ambient
ページ11に含まれる内容の要旨
This is due to the air temperature within the refrigerator compartment being maintained at 6°C or under thus not calling the thermostat to energise the compressor . SOMETHING NOT WORKING During a normal night time period of approximately 8 hours a traditional fridge freezer can normally maintain the Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or frozen food temperature but if the appliance is left for longer period in a low ambient
ページ12に含まれる内容の要旨
GUARANTEE CONDITIONS MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Standard guarantee conditions out, DISCONNECT the appliance from the We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part ELECTRICITY supply. thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that:
ページ13に含まれる内容の要旨
HINTS AND TIPS TECHNICAL SPECIFICATIONS Try to avoid keeping the door open for long Food Storage periods, or opening the door too frequently as POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz To obtain the best results from your appliance, warm air will enter the cabinet, and cause the neither hot foods nor liquids which may compressor to switch on unnecessarily often. TOTAL POWER ABSORBED 160 W evaporate, should be placed in the larder Ensure there are no obstructions preventing the
ページ14に含まれる内容の要旨
Movable shelves INSTALLATION The walls of the refrigerator have runners so that the shelves can be positioned as desired . Important For better use of space, the front half-shelves can lie Warning over the rear ones. IF YOU ARE DISCARDING AN OLD APPLIANCE It must be possible to disconnect the appliance from THAT HAS A LOCK OR CATCH ON THE DOOR, the mains power supply; the plug must therefore be YOU MUST ENSURE THAT IT IS MADE easily accessible after installation. UNUSABLE TO PREVENT YOUNG CHILDR
ページ15に含まれる内容の要旨
For replacement, use a 13amp BSI362 fuse. Only Fresh food refrigeration ASTA or BSI approved fuses should be used. Electrical connections Warning To obtain the best performance, do not store warm The plug must not be used if the fuse cover/carrier is Any electrical work required to install this appliance Do not put carbonated liquids, (fizzy drinks etc.), in food or evaporating liquids in the refrigerator; do lost. The cover/carrier is indicated by the coloured should be carried out by a qualifi
ページ16に含まれる内容の要旨
50 OPERATION Instructions for totally built-in appliances Before using Door reversal Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of The appliance is supplied with the door soda (5 ml to 0.5 litre of water). hinges on the right or on the left. To Do not use soap or detergent as the smell may change the opening direction of the doors linger. Dry thoroughly. proceed as follows before installing the appliance. Setting the temperature 1. Gently lay the
ページ17に含まれる内容の要旨
DESCRIPTION OF THE APPLIANCE A Push appliance into housing until stop strip (A) touches the kitchen unit. A B K C D023 J D I Open the door and push the appliance against the H side of the kitchen unit opposite to that of appliance E hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. G Snap the ventilation grille (C) and hinge cover (D) D into position C D723 F Press in the joint covers between the appliance and the kitchen unit. A - Thermostat control f
ページ18に含まれる内容の要旨
50mm 20 mm Separate parts A, B, C, D as shown in the figure B A CONTENTS Instructions for the User Instructions for the C Installer Important Safety Information 2 D Technical Specification 13 Description of the Appliance 4 PR266 Installation 14 Operation 5 Positioning 14 Before use 5 Setting the temperature 5 15 Electrical Connection Place guide (A) on the inside part of the furniture door, in the upper and lower position as shown in the The freezer compartment 5 Door Reversal 16 figure and mark
ページ19に含まれる内容の要旨
Should adjustment of the furniture door be necessary, use the clearance of slots as required. IMPORTANT SAFETY INFORMATION At the end of operations, it is necessary to check if It is most important that this instruction book should be retained with the appliance for future the door of the furniture closes properly. reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in or
ページ20に含まれる内容の要旨
REFRIGERATOR- FREEZER ZI 920/8 FF © Electrolux plc 2002 INSTRUCTION BOOKLET 2222 122-72
