ページ1に含まれる内容の要旨
CDR22KIT
INSTRUCTION MANUAL
TUN VOL
CFD
DISPLAY PLAYBACK
FM AM
BAL
BND MOD MUT LOC RPT STOP
AUTO-LOADING COMPACT DISC PLAYER
WITH AM/FM TUNING RADIO
WWW. PYRAMIDCARAUDIO.COM
ページ2に含まれる内容の要旨
LOCATION AND FUNCTION OF CONTROLS 1 2 3 4 5 6 7 8 TUN VOL CFD DISPLAY PLAYBACK FM AM BAL BND MOD MUT LOC RPT STOP 9 18 10 11 12 13 19 14 15 16 17 1.POWER BUTTON Press it to turn on or off the unit. 2. TUNING KNOB Rotate it to select your desired broadcasting station. 3.CD COMPARTMENT 4.FREQUENCY COUNTER By the pointer, the display shows the frequency of the broadcasting station being received. 5.LED DISPLAY This is to show the track no.of CD. 6.VOLUME CONTROL Rotate it to increase or decrease th
ページ3に含まれる内容の要旨
8. (CD PLAY,PAUSE )BUTTON At tuner mode, press button to switch to CD mode. At CD mode, press it to pause the CD playing and press it again to resume CD playback. 9,17. TRACK UP/DOWN BUTTONS a. During CD mode, press button to allow you to track forward. Hold the button to allow you to skip forward. b. During CD mode, press button to allow you to track backward. Hold the button to allow you to skip backward. 10.BAND BUTTON Press it to select your desired radio band AM or FM. 11.MODE BUTTON Press
ページ4に含まれる内容の要旨
15.RPT BUTTON During CD mode, press RPT button to repeat a single track. 16.STOP BUTTON Press it for stop CD playing. 18.FM LIGHT The frequency in the FM station ,the FM light be lighted. 19.AM LIGHT The frequency in the AM station ,the AM light be lighted. 3
ページ5に含まれる内容の要旨
DISC PLAY: Cleaning discs Before playing ,clean the disc with a clean, lint-free, Flip the disc in the direction of the arrow. Note: Do not use so solvents such as benzine, thinners, commercially available cleaners or anti static spray damage the unit: insert a disc with the label surface down, Doing so may damage the unit. Label surface up Note: Do not try to insert another disc when one has been already inserted. Doing so may damage the unit. Handle the disc by its edge. And to keep the disc c
ページ6に含まれる内容の要旨
TROUBLE SHOOTING Before going through the check list, wiring connection, should any of the problem persist after check list has been made , consult your nearest service dealer. Symptom Cause Solution The car ignition is not on. If the power supply is properly connected to the car accessory No power switch the ignition key to “ACC” The fuse is blown Replace the fuse Presence of CD disc inside Remove the disc in the player Disc cannot the player then put a new upward be loaded or Inserting the dis
ページ7に含まれる内容の要旨
SPEAKER CONNECTION Speaker connection ANTENNA PLUG WHITE (L) RCA LINE OUT PLUG RED (R) 3A POWER SUPPLY RED FUSE BLACK GROUND AUTO ANTENNA YELLOW +GREEN GREY+ LR -GREEN/WHITE GREY/WHITE- NOTE: In spite of having any kinds of speaker system ,must use 4 ohms impedance of speaker to reduce the distortion during high volume level. SPECIFICATION GENERAL Power requirement------------------------------DC 13.8V negative ground Current consumption---------------------------------------------------3A MAX.
ページ8に含まれる内容の要旨
INSTALLATION DASH BOARD METAL MOUNTING STRAP HEX NUT SPRING WASHER PLAIN WASHER CONSOLE PLAIN WASHER SLIDE BRACKET HOUSING TAPPING SCREW HEX BOLT KEY PLATE KEY PLATE
