ページ1に含まれる内容の要旨
®
SIDE BY SIDE
REFRIGERATOR
Use & Care Guide
Table of Contents................................................. 2
www.crosley.com
2188765
ページ2に含まれる内容の要旨
TABLE OF CONTENTS REFRIGERATOR SAFETY .............................................................3 Convertible Vegetable/Meat Drawer, Crisper and Covers ........15 Proper Disposal of Your Old Refrigerator....................................3 Convertible Vegetable/Meat Drawer Temperature Control.......15 Crisper Humidity Control............................................................15 INSTALLATION INSTRUCTIONS ..................................................4 Wine or Can/Bottle Rack.....
ページ3に含まれる内容の要旨
REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately
ページ4に含まれる内容の要旨
INSTALLATION INSTRUCTIONS Unpacking Location Requirements WARNING WARNING Excessive Weight Hazard Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury. Removing packaging materials Explosion Hazard Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap Keep flammable materials and vapors, such as over the adhesive with your fingers. Wipe with warm water gasoline, away from ref
ページ5に含まれる内容の要旨
Water Pressure Electrical Requirements A cold water supply with water pressure of between 30 and 120 psi (207-827 kPa) is required to operate the water dispenser and WARNING ice maker. If you have questions about your water pressure, see “Troubleshooting” or call a licensed, qualified plumber. Reverse Osmosis Water Supply If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system needs to be a minimum of 40 to 60 psi (276 - 414 kPa). If
ページ6に含まれる内容の要旨
Door Removal TOOLS NEEDED: ¹⁄₄ in. hex-head socket wrench, ⁵⁄₁₆ in. hex-head socket wrench and a flat-blade screwdriver. IMPORTANT: Before you begin, turn the refrigerator control OFF, unplug refrigerator or disconnect power. Remove food and any adjustable door or utility bins from doors. NOTE: It may only be necessary to remove either the door handle or the doors to get your product through the doorway of your residence. Measure the door opening to determine whether to remove the refrigerator h
ページ7に含まれる内容の要旨
6. Disconnect wiring: Handle Removal (optional) Style 1 Disconnect wiring plug. 1. Apply firm pressure with your hand on the face of trim. Slide top trim up and bottom trim down away from handle. Lift trim Remove green ground wire screw to disconnect ground pieces off shoulder screws (see Graphic 1). wires. NOTE: Some models include accent pieces between the handle 3 and the handle trim. If your model includes the accents, you will 4 need to carefully remove them with a flat-blade screwdrive
ページ8に含まれる内容の要旨
4. Align and replace the top left hinge as shown (see Graphic 4). 3. Use a hex-head socket wrench to adjust the leveling screws. Tighten screws. Turn the leveling screw to the right to raise that side of the refrigerator or turn the leveling screw to the left to lower that side. It may take several turns of the leveling screws to adjust WARNING the tilt of the refrigerator (see Graphic 8). NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling screws and
ページ9に含まれる内容の要旨
NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 Connecting to Refrigerator days to completely fill ice container. Style 3 Style 1 1. Unplug refrigerator or disconnect power. 1. Unplug refrigerator or disconnect power. 2. Remove the shipping tape from the gray, coiled water tubing 2. Attach the copper tube to the valve inlet using a compression on the rear of the refrigerator. nut and sleeve as shown. Tighten the compression nut. Do 3. Thread theprovided nutonto thewater valveassh
ページ10に含まれる内容の要旨
2. Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 2 to 3 gal. (8 to 12 L) of water. REFRIGERATOR USE Cleaning the system will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households. Ensuring Proper Air Circulation NOTE: As air is cleared from the system, water may spurt out of the dispenser. In order to ensure proper temperatures,
ページ11に含まれる内容の要旨
Some models dispense both cubed and crushed ice. Before Adjusting Controls dispensing ice, select which type of ice you prefer. The button controls are designed for easy use and cleaning. If you need to adjust temperatures, adjust the refrigerator temperature first. ICE NOTE: Wait at least 24 hours between adjustments and then CRUSH CUBE recheck the temperatures. Turn the control right (clockwise) to make the compartment For crushed ice, cubes are crushed before being dispensed. This colder. Tur
ページ12に含まれる内容の要旨
The Dispenser Light Water Filtration System The dispenser area has a light. It can be turned on manually by (on some models) pressing the ON button (touchpad or rocker switch). NOTE: Do not use with water that is microbiologically unsafe On some models: Whenever you use the dispenser, the lever will or of unknown quality without adequate disinfection before automatically turn the light on. or after the system. LIGHT Changing the Water Filter Cartridge OFF ON The base grille water filter is locat
ページ13に含まれる内容の要旨
5. With cartridge cap in the vertical position, push the new filter To increase ice production rate: cartridge into the base grille until it stops. Rotate the cartridge Normal Ice Production: In normal ice production mode, the cap clockwise to a horizontal position. Flush the water ice maker should produce approximately 7 to 9 batches of ice system (see “Flushing the Water System After Replacing in a 24-hour period. If ice is not being made fast enough, turn Filter” later in this section). the
ページ14に含まれる内容の要旨
Flip-up Shelf REFRIGERATOR FEATURES (on some models) Your model may have some or all of these features. Features that To raise or lower the shelf: can be purchased separately as product accessories are labeled 1. Raise the shelf by pulling forward on the lever located at the with the word “Accessory.” Not all accessories will fit all models. bottom front of the shelf and lift until the shelf locks into the If you are interested in purchasing one of the accessories, please vertical position. call
ページ15に含まれる内容の要旨
Meat Storage Guide Convertible Vegetable/Meat Drawer, Store most meat in original wrapping as long as it is airtight and Crisper and Covers moisture-proof. Rewrap if necessary. See the following chart for (on some models) storage times. When storing meat longer than the times given, freeze the meat. Crisper and Convertible Vegetable Meat Drawers Fresh fish or shellfish.........................use same day as purchased Chicken, ground beef, variety meat (liver, etc.) ................1-2 days To r
ページ16に含まれる内容の要旨
FREEZER FEATURES DOOR FEATURES Your model may have some or all of these features. Features that Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled can be purchased separately as product accessories are labeled with the word “Accessory.” Not all accessories will fit all models. with the word “Accessory.” Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please If you are
ページ17に含まれる内容の要旨
REFRIGERATOR CARE IMPORTANT: This cleaner is for Stainless Steel parts only! Do not allow the Stainless Steel Cleaner & Polish to come into Cleaning contact with any plastic parts such as the trim pieces, dispenser covers or door gaskets. If accidental contact does occur, clean plastic part with a sponge and mild detergent in warm water. Dry thoroughly with a soft cloth. To order the cleaner, see the “Accessories” section. 5. There is no need for routine condenser cleaning in normal home operati
ページ18に含まれる内容の要旨
Style 2 - Behind Freezer Basket Crisper Lights Depending on your model, remove the top freezer basket or top freezer basket shelf. Remove light shield by removing the If necessary, remove the top crisper drawer to access the Phillips screw on the top of the shield. Carefully rotate the crisper light shield. Remove the light shield by lifting the ends shield until the left tab can be gently pulled from the freezer out of the brackets as shown. wall. Replace the light shield by inserting the
ページ19に含まれる内容の要旨
Moving There is water in the defrost drain pan When you are moving your refrigerator to a new home, follow Is the refrigerator defrosting? The water will evaporate. It is thesesteps to prepareitfor themove. normal for water to drip into the defrost pan. 1. If your refrigerator has an automatic ice maker: Is it more humid than normal? When it is humid, expect that the water in the defrost pan will take longer to evaporate. Turn off the water supply to the ice maker at least one day ahead of
ページ20に含まれる内容の要旨
Is an ice cube jammed in the ice maker ejector arm? Is ice stuck in the delivery chute? Clear the ice from the For modelswithastandard icestoragebin, removetheice delivery chute with a plastic utensil. Do not use anything from the ejector arm with a plastic utensil. For models with an sharp to remove the ice. You could cause damage. ice storage bin on the freezer door, access the ice maker by Is the ice dispenser stalling while dispensing “crushed” depressing the ice sensor door on the upp
