ページ1に含まれる内容の要旨
Use andCare Guide
Refrigerator—Freezer
English Version...................................2 Problem Solver.......................16–18
Version française...........................19 Normal Operating Sounds.........................16
Versión en español ......................39
Preparation
Safety Instructions.....................2, 3 Adding Door Panels .............................11, 12
Clearances.....................................................10
Location......................................
ページ2に含まれる内容の要旨
HELP US HELP YOU… Read this guide carefully. If you received a damaged refrigerator… It is intended to help you operate and maintain your new Immediately contact the dealer (or builder) that sold you refrigerator properly. the refrigerator. Keep it handy for answers to your questions. Save time and money. Write down the model and serial numbers. Before you request service… Check the Problem Solver in the back of this guide. It lists minor You’ll see them on a label on the wall beside the top d
ページ3に含まれる内容の要旨
Important Safety Instructions Operating Your Refrigerator • Unplug your refrigerator before cleaning and Mains lead replacement making repairs. NOTE: We strongly recommend that If the mains lead on your refrigerator needs replacing any servicing be performed by a qualified individual. at any time, it must be replaced by a special lead which • Before replacing a burned-out light bulb, unplug the is obtainable from your local dealer. A charge will be refrigerator or turn off power at the circuit
ページ4に含まれる内容の要旨
AUTOMATIC ICEMAKER & DISPENSER (on some models) How It Works The automatic icemaker makes ice continually. The dispenser Cubes dispense through the chute in the door when the dispenses water, ice cubes or crushed ice through the freezer dispenser pad is pressed. compartment door. Here’s how they work. When the Crushed pad is pressed (on some models), a Water flows from the household supply through a baffle channels cubes through the crusher and crushed ice falls (1) dual solenoid valve throug
ページ5に含まれる内容の要旨
Automatic Icemaker & Dispenser Once Your Icemaker and Dispenser are in Operation Throw away the first few batches of ice cubes (16 or 24 cubes). This To make sure the bin fills with ice, level the cubes occasionally. will flush away any impurities in the water line. Do the same thing When cubes fall into the bin they may pile up close to the icemaker after vacations or extended periods when ice isn’t used. and push the feeler arm to the (up) position, which stops icemaking, before the bin gets f
ページ6に含まれる内容の要旨
AUTOMATIC ICEMAKER & DISPENSER (continued) To Remove Ice Storage Bin To Replace Ice Storage Bin Lift the left corner to free the bin Slide the bin back until the tab on the from the shelf. Pull the bin straight out bin locks into the slot in the shelf. Rotate while supporting it at front and back. If the bin does not go all the way back, remove it and turn the drive mechanism 1/4 turn. Then push the bin back again until the tab on the bin locks into the slot Drive in the shelf. Mechanism If Ice
ページ7に含まれる内容の要旨
Automatic Icemaker & Dispenser Storage Drawers Shelves SHELVES Quick Space Shelf (on some models) Slide-Out Spillproof Shelves (on some models) This shelf splits in half and slides The slide-out shelf allows you to under itself for storage of tall items reach items stored behind others. on the shelf below. The special edges are designed to help prevent spills from dripping to lower shelves. Make sure you push them all the way back in before you close the door. How to Rearrange Your Shelves
ページ8に含まれる内容の要旨
FREEZER COMPARTMENT Loading the Freezer Compartment Freezer Baskets (on some models) Load so that at least 15 mm of space remains clear between stacks of Wire slide-out freezer baskets packages and 15 mm to 25 mm of space between the top of any stack can be pulled out for easy access to and any shelf or basket above it. Packages may hang over the front of frozen foods. shelves but must remain 15 mm from doors. WARNING: Poor performance may occur if freezer baskets are not used. • Food to be fr
ページ9に含まれる内容の要旨
Freezer Compartment Care and Cleaning 1 3 5 7 9 7 9 1 3 5 Drawer and Cover Removal Drawers will stop before coming all the way When replacing To remove the out of the refrigerator to help prevent the drawers, drawers when contents from spilling onto the floor. Drawers make sure you the fresh food can easily be removed by tilting up slightly slide them compartment and pulling past the “stop” location. through both door cannot be drawer guides on opened fully, To remove the the right side. remo
ページ10に含まれる内容の要旨
PREPARATION Clearances Refrigerator Location Allow the following clearances for ease of installation, proper air Do install it on a floor strong enough to support a fully circulation and plumbing and electrical connections: loaded refrigerator. Sides ...................................................................................3 mm Top....................................................................................25 mm (If built-in, allow 22 mm for hinge covers.) Back..................
ページ11に含まれる内容の要旨
Preparation Adding Door Panels (on models with trim kit) These instructions describe how to insert decorator panels and what Special cut- Special cut- size the panels should be. out required, out required, 36.4 cm 51.0 cm see below. see below. Panels should be cut to the following dimensions: Top freezer panel—36.4 cm x 47.6 cm Bottom freezer panel—36.4 cm x 82.2 cm 47.6 cm Fresh food panel—51.0 cm x 165.6 cm Panels that are 6 mm thick will fit the door frame trim with no special preparation. If
ページ12に含まれる内容の要旨
PREPARATION (continued) 19 mm or Raised Panel 6 mm A raised panel design screwed or glued to a 6 mm thick backing, or a Thick Backing 19 mm routed board can be used. The raised portion of the panel must be fabricated to permit clearances of at least 51 mm from the handle side for fingertip clearance and 32 mm from the hinge side to avoid striking adjacent cabinetry. 51 mm Clearance 19 mm Handle Side Appearance 32 mm Weight limitations for custom panels: Panel Refrigerator Clearance Fresh Food :
ページ13に含まれる内容の要旨
Preparation Installation INSTALLATION INSTRUCTIONS FOR GREAT BRITAIN AND IRELAND ONLY Electrical Requirements Mains Lead Replacement We recommend that this appliance is connected to the mains supply If the mains lead on this appliance needs replacing at any time, it must via a suitable switched socket in a readily accessible position. All be replaced by a special lead which is obtainable from your nearest appliances come complete with a fitted plug. The plug on your Food Service centre. A charge
ページ14に含まれる内容の要旨
HOW TO INSTALL FEATURES 3 NOT ALL FEATURES ARE ON ALL MODELS. ADJUSTABLE DOOR BINS (REFER TO THE CONTENTS LIST ON THE BOX.) Hook bins into holes in the ladder support at desired locations. CAUTION: Do not place 1 a door bin where door shelf fronts should be. 4 DOOR SHELF FRONTS Hook shelf fronts at locations where Door Shelf there are shelves in the door. Make 2 sure they are locked securely into place. Door Shelf NOTE: Shelf Front fronts must be 3 used in the lowest ladder position on the r
ページ15に含まれる内容の要旨
ADDITIONAL FEATURES (Available on some models) 3 NOT ALL FEATURES ARE ON ALL MODELS. REFRESHMENT CENTER, INSIDE COVER (REFER TO THE CONTENTS LIST ON THE BOX.) Depress pins on cover and insert into holes in sides of the Refreshment Center compartment. 2 1 4 REFRESHMENT CENTER, DOOR BIN 3 Hook Refreshment Center bin (with lip) Lip into uppermost slots 4 in shelf tracks. 5 QUICK SERVE DISHES UNDER SHELF Slide dishes in the 5 dish rack. 1 FREEZER BASKETS Place the rear edges of the basket on ope
ページ16に含まれる内容の要旨
QUESTIONS? USE THIS PROBLEM SOLVER PROBLEM POSSIBLE CAUSE REFRIGERATOR DOES • May be in defrost cycle when motor does not operate for about 30 minutes. NOT OPERATE • Temperature control is in “ position. ” • If interior light is not on, refrigerator may not be plugged in at wall outlet. • If plug is secure and the refrigerator still fails to operate, plug a lamp or a small appliance into the same outlet to determine if there is a tripped circuit breaker or burned-out fuse. MOTOR OPERATES • Mod
ページ17に含まれる内容の要旨
Problem Solver PROBLEM POSSIBLE CAUSE FOODS DRY OUT • Foods not covered, wrapped or sealed properly. FRESH FOOD OR • Temperature control not set cold enough. Refer to Temperature Control section. FREEZER COMPARTMENT • Warm weather—frequent door openings. TEMPERATURE TOO WARM • Door left open for too long a time. • Package holding door open or blocking air duct in freezer compartment. FROST OR ICE CRYSTALS • Door may have been left ajar or package holding door open. ON FROZEN FOOD • Too frequent
ページ18に含まれる内容の要旨
PROBLEM SOLVER (continued) PROBLEM POSSIBLE CAUSE AUTOMATIC • Icemaker feeler arm in (up) position. ICEMAKER • Water supply turned off or not connected. DOES NOT WORK • Freezer compartment too warm. (on some models) • Cubes too small—water shutoff valve connecting refrigerator to home water line may be clogged. • Piled up cubes in storage bin may cause icemaker to shut off prematurely. With icemaker feeler arm in (up) position, level cubes in bin by hand. CUBE DISPENSER • No ice cubes. Remove
