ページ1に含まれる内容の要旨
SW ... R
UK Instructions for use
DE Bedienungsanleitung
FR Mode d’emploi
NL Gebruiksaanwijzing
ES Instrucciones para el uso
ページ2に含まれる内容の要旨
GB Thank you for purchasing your new to the local distributor before the refrigerator refrigerator from Smeg. Please note that is put to use. these instructions apply to all refrigerators in the SW range. Illustrations and fittings Remove the packaging. Clean the inside of may therefore not necessarily correspond the cabinet using warm water with a mild exactly to your model. detergent. Rinse with clean water and dry thoroughly (see cleaning instructions). Use a soft cloth. Warning As the
ページ3に含まれる内容の要旨
GB Get to know your refrigerator Control panel Lighting Bottle rack Nameplate Shelf with storage boxes Door shelf Glass shelf Sealing strip Door handle Crisper bins Kick plate Adjustable feet fig.1 3
ページ4に含まれる内容の要旨
600 600 GB Installation and start-up 600 600 Placement 600 600 For safety and operational reasons, the appliance must not be installed outdoors. The appliance should be placed on a level surface in a dry, well ventilated room (max. 75% relative air humidity). Never place the appliance close to sources of heat such as cookers or radiators, and avoid placing it in direct sunlight. Room temperature The climate class is stated on the nameplate (see fig. 1 on page 3 and fig. 17 on page 13). T
ページ5に含まれる内容の要旨
GB The appliance viewed from Distance pieces The distance pieces on the rear of the above appliance ensure sufficient air circulation. If the appliance is placed beside a wall, Fit the distance pieces supplied with the there must be sufficient room for its door appliance as shown in fig. 5. to be opened wide enough to allow the shelves to be pulled out (fig. 4). 600 fig. 5 Ventilation It is important that the appliance be well ventilated and that air can circulate 610 fig. 4 unhindere
ページ6に含まれる内容の要旨
GB Setting up Do not tilt the upright more than 7 degrees It is important that the appliance be to avoid damaging the floor. absolutely level. To level the appliance, remove the kick plate below the door and screw the adjustable feet up or down (figs 8-9). If necessary, it is possible to adjust the back feet before the upright is installed. Use a spirit level to check that the appliance is absolutely level. If the appliance is to be placed on a soft surface, e.g. floorboards or a carpet
ページ7に含まれる内容の要旨
GB Reversing the door The door can be changed from right-hinged to left-hinged and vice versa as follows: 1. Lay the appliance on its back with the 2. Remove the upper hinge. 5. Remove the kick plate by pulling it door uppermost. 3. Move the plastic plugs to where the outwards and upwards. upper hinge was fitted. 4. Lift off the door and lay it aside. 6. Loosen lock nut with the fork wrench 7. Remove the lower hinge. Rotate the 9. Remove the door closer and refit it on
ページ8に含まれる内容の要旨
GB Electrical connection The appliance is intended for connection to alternating current. The required volt- age (V) and frequency (Hz) are stated on the nameplate inside the appliance. Power must be connected via an independent wall socket outlet. Technical data This appliance complies with CE marking regulations, directives and standards. Low Voltage Directive 73/23/EEC. EMC Directive 89/336/EEC. Council Directive 92/75/EEC on the en- ergy labelling of household appliances as subsequent
ページ9に含まれる内容の要旨
GB Operation and function Control lamp 0 7 1 6 2 5 3 4 Lighting Thermostat button fig. 12 The thermostat button can be set from 1 (less cold) to 7 (more cold). A suitable setting must be found by trial and error. Start by setting the button to 4. Check the temperature, then adjust the setting upwards or downwards as required. Usually, a temperature of 5°C is recommended for items stored in a refrigerator. To check the temperature, place a thermometer in a glass of water positioned in t
ページ10に含まれる内容の要旨
GB Layout and fittings Glass shelves Glass shelf with slide damper The shelves are made of tempered glass The slide damper above the crisper bins and can be repositioned within the cabinet. allows the temperature and humidity in the To move the shelves, the door must be bins to be regulated. opened 90°. To remove a shelf, pull it - Opening the damper reduces the forwards and lower it. The shelf can then be temperature and humidity. removed and placed in the desired position. - Closing the dam
ページ11に含まれる内容の要旨
GB Defrosting, cleaning and maintenance Stainless steel or aluminium doors are best Automatic defrosting cleaned using a care spray and soft cloth. The refrigerator is defrosted automatically. Various suitable products are available from Defrost water runs through a pipe and is most household appliance distributors. collected in a tray above the compressor where the heat generated by the If the appliance is not to be used for any compressor causes it to evaporate. The length of time, sw
ページ12に含まれる内容の要旨
GB Fault finding Fault Possible cause Remedy No control lamps The appliance is switched off. Press the on/off switch. are lit. Power failure; the fuse is blown; Check that power is connected. the appliance is not plugged in Reset the fuse. correctly. Water collects on Items of food at the back of the Move the rearmost items for- the glass shelves. shelves are in contact with the wards. rear wall of the cabinet, thus causing condensation to run onto the shelf. Water collects in The defrost wat
ページ13に含まれる内容の要旨
GB Spare parts and service Spare parts When ordering spare parts, please state the type, serial and production numbers of your appliance (see fig. 1 on page 3 and fig. 17). This information is given on the nameplate on the rear of the appliance. The nameplate contains various technical information, including type and serial numbers. Important Please note that changes to the construction of the appliance or changes to the component equipment of the appliance will invalidate Smegs wa
ページ14に含まれる内容の要旨
GB Disposal Environmental regulations on disposal must also be observed. When disposing of the appliance you should contact your local authority technical department who will inform you of how collection and recycling of such units take place in your area. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences fo
