ページ1に含まれる内容の要旨
INSTRUCTION MANUAL
MPR-414F
MPR-414FS
Pharmaceutical Refrigerator
with Freezer
MPR-414F
32
ページ2に含まれる内容の要旨
Note: 1. No part of this manual may be reproduced in any form without the expressed written permission of SANYO. 2. The contents of this manual are subject to change without notice. 3. Please contact SANYO if any point in this manual is unclear or if there are any inaccuracies. SANYO Electric Biomedical Co., Ltd. All rights reserved. Printed in Japan. CONTENTS PRECAUTIONS FOR SAFE OPERATION P. 2 CAUTIONS FOR USAGE P. 6 ENVIRONMENTAL CONDITIONS P. 7 RE
ページ3に含まれる内容の要旨
PRECAUTIONS FOR SAFE OPERATION It is imperative that the user complies with this manual as it contains important safety advice. Items and procedures are described so that you can use this unit correctly and safely. If the precautions advised are followed, this will prevent possible injury to the user and any other person. Precautions are illustrated in the following way: WARNING Failure to observe WARNING signs could result in a hazard to personnel possibly resulting i
ページ4に含まれる内容の要旨
PRECAUTIONS FOR SAFE OPERATION WARNING Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to rain water. Only qualified engineers or service personnel should install the unit. The installation by unqualified personnel may cause electric shock or fire. Be sure to install the unit on a sturdy floor. If the floor is not strong enough or the installation site is not adequate, this may result in injury from the unit falling
ページ5に含まれる内容の要旨
PRECAUTIONS FOR SAFE OPERATION WARNING Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in order to prevent electric shock or injury. Ensure you do not inhale or consume medication or aerosols from around the unit at the time of maintenance. These may be harmful to your health. Never splash water directly onto the unit as this may cause electric shock or short circuit. Never disassemble, repair, or modify the unit your
ページ6に含まれる内容の要旨
PRECAUTIONS FOR SAFE OPERATION CAUTION Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping. Improper installation may result in water spillage or injury from the unit tipping over. Connect the unit to a power source as indicated on the rating label attached to the unit. Use of any other voltage or frequency other than that on the rating label may cause fire or electric shock. Fix the shelves securely. Incomplete instal
ページ7に含まれる内容の要旨
CAUTIONS FOR USAGE 1. If the unit is unplugged or the power to the unit is interrupted, do not restart the unit for at least 5 minutes. This protects the compressor. 2. This inner cabinet is refrigerated by the forced circulation of cooled air inside the chamber. Ensure that the intake and exhaust vents are not blocked. Adequate space should be provided between the o items inside the unit to allow air circulation. Too much stock will result in temperature of about -2 C o around
ページ8に含まれる内容の要旨
CAUTIONS FOR USAGE 13. Do not clean the unit with scrubbing brushes, acid, thinner, solvents powdered soap, cleanser or hot water. These agents can scratch the paint or cause it to peel. Plastic and rubber parts can be easily damaged by these materials. Especially never use any volatile solvent to clean the plastic or rubber parts. When a neutral dishwashing detergent is used to clean the unit, wipe it up thoroughly with a cloth soaked in clean water. 14. If condensation forms o
ページ9に含まれる内容の要旨
REFRIGERATOR COMPONENTS 7 6 3 4 5 1 2 13 16 15 17 8 8 Refrigerator 9 14 10 Freezer 11 4 12 MPR-414F with drawers (optional component) 40 8
ページ10に含まれる内容の要旨
REFRIGERATOR COMPONENTS 1. Glass window: Water can sometimes condense on the glass in areas of high humidity. Wipe off the condensation with a dry soft cloth. (MPR-414FS has no glass window.) 2. Magnetic door gasket: This prevents the cool air from escaping. Always keep clean. 3. Control panel: The operation status is displayed on this panel. And the temperature setting is available through this panel. Refer to page 10 for the details. 4. Mounting space for temperature r
ページ11に含まれる内容の要旨
REFRIGERATOR COMPONENTS Control panel 10 9 8 7 6 REFRIGERA TOR FREEZER DOOR REF . FREEZ. 1 2 3 4 5 1. Alarm buzzer stop key (BZ): Press this key to silence the buzzer in the event that the alarm operates and buzzer sounds. See page 17 for the details. 2. Display select key (REF./FREEZ.): By pressing this key, chamber temperature display of refrigerator or freezer and each setting is selected. 3. Set key (SET): Pressing this key activates temper
ページ12に含まれる内容の要旨
INSTALLATION Installation site To operate this unit properly and to obtain maximum performance, install the unit in a location with the following conditions: 1. A location not subjected to direct sunlight Installation in a location subjected to direct sunlight may lead to inadequate cooling. 2. A location with adequate ventilation Leave at least 10cm around the unit for ventilation. Poor ventilation will result in a reduction of the refrigeration capacity. 3. A location a
ページ13に含まれる内容の要旨
INSTALLATION Installation 1. Remove the packaging materials and tapes Remove all transportation packaging materials and tapes. Open the doors and ventilate the unit. If the outside panels are dirty, clean them with a diluted neutral dishwashing detergent. (Undiluted detergent can damage the plastic components. For the dilution, refer to the instruction of the detergent.) After the cleaning with the diluted detergent, always wipe it off with a wet cloth. Then wipe off the
ページ14に含まれる内容の要旨
OPERATING INSTRUCTIONS Temperature setting Table 1 shows the basic operation method. Perform key operation in the sequence indicated in the table. o The example in the table is based on the assumption that the refrigerator temperature is 4 C and the o freezer temperature is -25 C. o Note: The unit is set at the factory so that the refrigerator temperature is 5 C and the freezer o temperature is -20 C. o o Table 1 Basic operation procedure (Example of setting: refrigerator;
ページ15に含まれる内容の要旨
OPERATING INSTRUCTIONS Key lock operation This unit incorporates a key lock feature which can inhibit the tampering using the keys on the control panel. The key lock is set to OFF at the factory. Display Mode Function L 0 Key lock OFF Temperature change enabled L 1 Key lock ON Temperature change disabled Table 2 Key lock setup procedure (Example: Key lock OFF Key lock ON) Operation Key operated Indication after operation The current refrigerator or freezer tempe
ページ16に含まれる内容の要旨
OPERATING INSTRUCTIONS Alarm temperature setting The high temperature and low temperature at which the alarm will be activated are effective for freezer and refrigerator. The following shows the outline of the alarm temperature setting. Display Mode Application Settable range o F01 High temp. alarm setting +2 to +14 C Refrigerator o F02 Low temp. alarm setting -2 to -14 C o F03 High temp. alarm setting +5 to +15 C Freezer o F04 Low temp. alarm setting -5 to -15 C Table 3
ページ17に含まれる内容の要旨
OPERATING INSTRUCTIONS Table 4 Operation Key operated Indication after operation The current refrigerator temperature 1 ----- is displayed. Press and hold the numerical value The first digit of the temperature 2 shift key for about 5 seconds. display blinks. Set the first digit to 2 with the The first digit of the temperature 3 numerical value shift key. (Note 1) display blinks. The current set value is displayed 4 Press the set key. SET and the first digit of the te
ページ18に含まれる内容の要旨
ALARMS AND SAFETY FUNCTIONS This unit has the alarm and safety functions shown in Table 5, and also a self diagnostic function. Table 5 Alarms and safety functions Kind of alarm Situation Indication Buzzer Safety operation or safety • Refrigerator If the chamber temperature High Alarm lamp flashes. Intermittent tone Remote alarm is exceeds the set temperature. temperature All digits on the temperature after a delay of 15 activated after a • Freezer alarm display flash. minutes
ページ19に含まれる内容の要旨
SETTING OF ALARM RESUME TIME The alarm buzzer and remote alarm are silenced by pressing BUZZER key on the control panel during alarm condition. The buzzer and remote alarm will be activated again after certain suspension if the alarm condition is continued. The suspension time can be set by following the procedure shown in the Table 6 below. The example in the table is based on the assumption that the desired duration is 20 minutes. Note: The duration is set in 30 minutes at the fa
ページ20に含まれる内容の要旨
DEFROSTING Refrigerator The following 2 kinds of defrost methods are adopted for the refrigerator, which control defrosting automatically. 1. Cycle defrost To keep the temperature stable inside the chamber, the refrigeration compressor is cycled on and off. During “off” periods any frost which has accumulated on the evaporator is melted by energizing a heater. This will not have any discernible effect on the chamber temperature. 2. Forced defrost When the ambient humidity is high
