ページ1に含まれる内容の要旨
Register your product and get support at
www.philips.com/welcome
32PFL3514D
32PFL3504D
42PFL3704D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Puerto Rico, or the U.S. Virgin Islands, contact Philips
Customer Care Center at 1-866-771-4018
• To obtain assistance in Canada, contact Philips Customer Care Center at:
EN User manual • 1-800-661-6162 (French speaking)
• 1-866-771-4018 (English speaking)
• To obtain assistance in
ページ2に含まれる内容の要旨
Contents 9 Connect Devices 27 1 Notice 4 Connection Overview 27 Select Your Connection Quality 29 2 Important 5 Connect Y our Devices 30 Product Information 5 Screen Care 5 10 Troubleshooting 35 Environmental Care 5 Regulatory Notices 5 11 Notes for the Use of USB Devices 3 Your TV 6 (Available for 42PFL3704D only) 36 Side Controls and Indicators 6 Remote Control 6 12 Product Information 37 4 Get Started 8 13 Warranty 38 Position the TV 8 Insert the Remote Control Batteries
ページ3に含まれる内容の要旨
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of *Product Safety *Additional Benefits Purchase Notification Returning the enclosed card guarantees By registering your p
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
ページ5に含まれる内容の要旨
1 Notice Modifi cations 2009 © Koninklijke Philips Electronics N.V. All rights reserved. The FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Specifi cations are subject to change without notice. Trademarks are Philips Consumer Electronics may void the user’s authority to operate the property of Koninklijke Philips Electronics N.V. or their respective the equipment. owners. Philips reserves the right to change produ
ページ6に含まれる内容の要旨
Environmental Care 2 Important Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to The packaging of this product is intended to be recycled. Contact your ob
ページ7に含まれる内容の要旨
Remote Control 3 Your TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome. b Side Contr ols and Indicators s c 32PFL3504D / 32PFL3514D * r d q VOLUME p e e f d MENU g CHANNEL c o h b . POWER a n i 42PFL3704D j VOLUME e k d MENU CHANNEL m l c b . POWER a a Standby indicator / remote control sensor *This button does not function on this unit. b . POWER: Switches the TV on or off.
ページ8に含まれる内容の要旨
c FORMAT Selects a picture format (see ‘Change picture format’ on page 16). d SAP Digital Mode (DTV) • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g (Navigation buttons) Navigates through the menus. h INFO Displays information about the TV channel or accessory device. The quality and accuracy of the information depends on the broadcaster. You might see a differen
ページ9に含まれる内容の要旨
Insert the Remote Control Batteries 4 Get Started This section supplements information in the Quick Start. For information about how to mount and install your TV, refer to the Quick Start. Position the TV Warning 1 Slide the battery cover off the back of the remote control. • Do not inser t the power plug into the wall socket before all the connections are 2 Insert the 2 supplied batteries (AAA). Be sure the + and - ends of made. • Lar ge screen TVs are heavy. Two people are required
ページ10に含まれる内容の要旨
Connect to an antenna Connect a set-top box through RF IN/OUT If the TV is connected to a cable box or satellite set-top box via a Any DTV programs that are broadcast in your area can be received for coaxial connection, set the TV to channel 3 or 4, or to the channel free through an antenna connection. specifi ed by the service provider. Contact your local content provider or your local electronics retailer if you are unsure about what HDTV programs are available in your area. 32PFL3504D / 32
ページ11に含まれる内容の要旨
Connect a set-top box through component video input or HDMI Connect the AC Power Cord 32PFL3504D / 32PFL3514D (Available for 42PFL3704D only) W arning • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Locate the power connector at the back of the TV. The location of the power connector varies according to TV model. 2 Insert the AC power cord fully into the power connector. 3 Connect the A
ページ12に含まれる内容の要旨
Manage Cables 2 Keep the cable through this holder to avoid tangle them. 32PFL3504D / 32PFL3514D Route your antenna cable and all other cables through the cable holder at the back of the TV. The holder helps keep your cables tidy and easily manageable. 1 Attach the cable holder as illustrated below. 32PFL3504D / 32PFL3514D 42PFL3704D 42PFL3704D EN 11 English
ページ13に含まれる内容の要旨
Press Í or Æ 5 times to select the side of the pictures that is the most Switch on and Set Up the TV pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . on Left side Right side the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu language. Se
ページ14に含まれる内容の要旨
Switch Channels 5 Use Your TV 32PFL3504D / 32PFL3514D This section helps you perform basic TV operations. Switch Your TV on/off or to Standby CHANNEL 32PFL3504D / 32PFL3514D . POWER 42PFL3704D CHANNEL 42PFL3704D . POWER Press CHANNEL +/- on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “.” and then the corresponding sub channel number (1 to 135). Ex. 108.30. • Press CH +/- or enter a number on the remote control. • Press PREV CH to return to the previ
ページ15に含まれる内容の要旨
Adjust Volume Still Mode You can pause the image shown on the TV screen. 32PFL3504D / 32PFL3514D Press FREEZE to pause the image shown on the TV screen. FREEZE • The sound output will not be paused. VOLUME • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except . (Standby-On). Watch Channels from a Set-top Bo
ページ16に含まれる内容の要旨
DTV Watch a DVD 1 Press SAP to display the currently selected language and the To watch a DVD number of available languages. 1 Insert a DVD disc into your player. 6.1 2 Press on the remote control of the DVD player to select English 1/3 channels. » The DVD might automatically play on the TV. 2 Press SAP repeatedly to cycle through the available audio If the picture does not appear languages. • Available languages differ depending on the broadcast. [Other] is displayed when the audio la
ページ17に含まれる内容の要旨
PC Settings 6 Use More of Your TV This function lets you adjust the PC screen position during PC input through the HDMI 1 input jack. 1 Press MENU on the remote control and select [FEATURES] > Change Picture and Sound Settings [PC Settings]. 2 Adjust the setting. Change picture settings [Position Reset] Press or to select [Reset], then press OK. • The Horizontal/Vertical position of the PC screen are automatically adjusted. [Horizontal Position], [Vertical Position] Press or to adjus
ページ18に含まれる内容の要旨
HDMI1 Summar y of picture formats For PC input signal through input mode Four types of display modes can be selected when the broadcasting station is sending 4:3 or 16:9 video signal. And three types of display modes can be selected for PC input signal. [Normal] [Full] For 4:3 video signal [Normal] [16:9] [Dot By Dot] Normal Display a proportionately stretched picture. Sidebars appear on both edges of the screen. [Wide] [Movie Expand] Full Display a picture that is stretched out of proportio
ページ19に含まれる内容の要旨
Change sound settings Summary of sound settings 1 Press MENU on the remote control and select [SOUND]. The following sound settings can be confi gured. Depending on the sound source, some sound settings are not available. • [Equalizer]: Adjusts individual sound frequencies. • [Virtual Surround Sound]: This selects the modes for more spatial or surround sound reproduction. PICTURE Auto Sound Standard • [Auto Volume Leveling]: Reduces sudden changes in volume, for SOUND Equalizer example, durin
ページ20に含まれる内容の要旨
Use the TV ratings lock Use Child Contr ol and Rating Locks Your TV is equipped with a V-chip that allows you to control access to You can prevent your children from watching certain programs or individual programs based on their age rating and content rating. The certain channels by locking the TV controls and by using ratings. program content advisory data are sent by the broadcaster or by the program provider. If you receive channels through a set-top box or cable box connected Set y
