ページ1に含まれる内容の要旨
fridge
USER MANUAL
ERN 34800
2223 429-31
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.You MUST read it care
ページ3に含まれる内容の要旨
Disposal of old Appliances The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more de
ページ4に含まれる内容の要旨
OPERATION Before using Remove all securing tapes. Wash inside the Do not use soap or detergent as the smell may appliance with lukewarm water and bicarbonate of linger. Dry thoroughly. soda (5 ml to 0.5 litre of water). Control panel C - Function button A - Applince button ON/OFF D - Fridge Thermostat knob B - Temperature and function indicator DISPLAY 1. Door open alarm indicator 2. Positive or negative Temperature indicator 3. Temperature indicator 4. If on the shopping function is on Op
ページ5に含まれる内容の要旨
Use of the fridge compartment Setting the temperature Fresh food refrigeration The temperature within the appliance is controlled by To obtain the best performance, do not store warm the thermostat control knob situated at the top of the food or evaporating liquids in the refrigerator; cover appliance. or wrap the food, particularly if it has a strong flavour. To operate the appliance proceed as follows: Do not cover the shelves with any protective material, such as paper, cardboard or plastic,
ページ6に含まれる内容の要旨
Movable shelves The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie over the rear ones. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height.To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. Bottle holder Place the bottles (
ページ7に含まれる内容の要旨
HINTS AND TIPS Food Storage Energy Saving Advice To obtain the best results from the appliance Do not install the appliance close to sources of neither hot foods nor liquids which may heat, such as a boiler or radiator. evaporate, should be placed in the larder Locate the appliance in a cool well ventilated compartment. room and make sure that the air openings of the Keep the time between buying chilled food and appliance are not obstructed. placing it in your refrigerator as short as po
ページ8に含まれる内容の要旨
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Changing the light bulb out, DISCONNECT the appliance from the ELECTRICITY supply. If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY P
ページ9に含まれる内容の要旨
SOMETHING NOT WORKING If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre Symptom Solution No power to the appliance Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. The light does not come on Ensure that the bulb is correctly fitted. Replace the bulb if it has blown. Check the door light switch is not jammed. The temperature in the frid
ページ10に含まれる内容の要旨
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Electrolux Service Force Centre by telephoning:- 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk Before calling out an engineer, please ens
ページ11に含まれる内容の要旨
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has
ページ12に含まれる内容の要旨
TECHNICAL SPECIFICATIONS POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 120 W AVERAGE DAILY UNITS ELECTRICITY * 0.397 kWh GROSS CAPACITY Fridge 332 l NET CAPACITY Fridge 330 l * This figure is based on standard test results in accordance with European Standard EN 153. Actual consumption will depend on how the appliance is used and where it is located. 12
ページ13に含まれる内容の要旨
INSTALLATION Important Warning IF YOU ARE DISCARDING AN OLD APPLIANCE It must be possible to disconnect the appliance from THAT HAS A LOCK OR CATCH ON THE DOOR, the mains power supply; the plug must therefore be YOU MUST ENSURE THAT IT IS MADE easily accessible after installation. UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “D
ページ14に含まれる内容の要旨
The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only Electrical connections ASTA or BSI approved fuses should be used. Any electrical work required to install this appliance The plug must not be used if the fuse cover/carrier is should be carried out by a qualified electrician or lost. The cover/carrier is indicated by the coloured competent person. insert at the base of the plug. WARNING:THIS APPLIANCE MUST BE A replacement cover/carrier must be obt
ページ15に含まれる内容の要旨
Door Reversibility The appliance is supplied with the door opening to the right. For door opening in the opposite direction, perform the following actions prior to installation 1. Unscrew the upper pin and remove the spacer 2. Remove the door. 3. Unscrew the lower pin and remove the spacer; replace them on the opposite side. 4. Reinsert the door and screw the pin and the spacer back in place on the opposite side.
Instructions for totally built-in appliances Recess dimensi
ページ16に含まれる内容の要旨
Drill the unit using a Ø 2.5 mm drill (10 mm max. penetration); Fix the square fitting to the appliance. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). Fasten the appliance with 4 screws provided in the
ページ17に含まれる内容の要旨
Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge cover (E) into
position. Separate parts Ha, Hb, Hc, Hd as shown in the figure. Place guide (Ha) on the inside part of the furniture door, as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. Fix cover (Hc) on guide (Ha) until it clips into place 17
ページ18に含まれる内容の要旨
Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
w ww ww w..e elle ec cttrro ollu ux x..c co om m www.electrolux.co.uk © Electrolux plc 2007
