ページ1に含まれる内容の要旨
®
INSTALLATION AND
OPERATING INSTRUCTIONS
REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION
RM2652 RM2852
Contents:
Page
Installation 4
Operating Instructions 8
Maintenance & Service 12
Pour votre sécurité
FOR YOUR SAFETY
Si vous sentez une odeur de gaz:
If you smell gas:
1. Ouvrez les fenêtres.
1. Open windows.
2. Ne touchez à aucun interrupteur.
2. Don’t touch electrical switches.
3. Éteignez toute flamme nue.
3. Extinguish any open flame.
4. Avertissez immédiatement votre fournis-
4. Immedia
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Heater Cover, Reigniter Flue baffle Power module cover Protection cover 12V DC Screw for protection cover 12 volt Terminal block FIG. 1 Burner jet Drain water hose Manual gas Flexible cord shutoff valve Inlet fitting Refrigerator control panel AB ON AUTO CHECK AUTOMATIC REFRIGERATOR TEMPERATURE CONTROL 12 OFF GAS LEGEND C 1. Main Power Button ON/OFF 2. AUTO/GAS Mode Selector Button A. AUTO Mode Indicator Lamp B. CHECK Indicator Lamp (GAS Mode Only) C. Climate Control Switch FIG. 2 3
ページ4に含まれる内容の要旨
The lower side vent is fitted with a panel, which provides INSTALLATION an adequate access opening for ready serviceability of the burner and control manifold of the refrigerator. This GENERAL INSTRUCTION should be centered on the back of the refrigerator. This appliance is designed for storage of foods and storage of frozen foods and making ice. GAS CONNECTION Hook up to the gas supply line is accomplished at the This appliance is certified under the latest edition of manual gas valve, which is
ページ5に含まれる内容の要旨
12 Volts DC Connection This refrigerator model is not designed for 12 volt DC operation of the cooling system; however, a continuous 12 volt DC must be supplied to the refrigerator to oper- ate the controls. Use a minimum of a 14 gauge wire between the battery and refrigerator to supply the con- trol voltage. The connection is made to the positive (+) and negative (-) terminals located at the rear of the refrigerator. (See FIG. 1). Correct polarity must be observed when connecting to the DC supp
ページ6に含まれる内容の要旨
3 Hole for drain water hose FIG. 8 FIG. 6 Any space between the counter, storage area or ceiling 2. Once the lower front strip is slipped under the and top of the refrigerator greater than 1-1/2 inches hinge, the part is possible to swing into place as should be blocked. The heat produced at the rear of the shown in FIG. 6. refrigerator will become trapped in this space, making 3. Secure the refrigerator and the lower front strip with the top of the refrigerator hot and reduce the efficiency two
ページ7に含まれる内容の要旨
CERTIFIED INSTALLATION G Certified installations require one roof vent and one lower side vent. For “Certified Vent System Kits” see page 15. For further information contact your dealer or distributor. KK NOTE: The upper vent should be centered over the condenser coil at the back of the refrigerator. L FIG. 10 NOTE: Wood Strip Minimum MUST be in place ventilation height N Condenser M CLEARANCES Minimum clearances in inches to combustible materials are: FIG. 9 G: Top 0 K: Side 0 L: Bottom 0 M: Re
ページ8に含まれる内容の要旨
Side view View from above C D D HW A B FIG. 11 Overall Recess Refrigerator Dimensions Dimensions Model Height Width Depth Height Width Depth AB C H W D inch 54-21/32 24-7/8 26-1/32 53-3/4 23-11/16 24 RM2652 mm 1388 632 661 1365 602 610 inch 60-51/64 24-7/8 26-1/32 59-15/16 23-11/16 24 RM2852 mm 1544 632 661 1522 602 610 This method of installation and these clearances will give you adequate space for service and proper installation. When the vehicle is moving, the leveling is not critical, as OP
ページ9に含まれる内容の要旨
Refrigerator control panel A B ON AUTO CHECK AUTOMATIC REFRIGERATOR TEMPERATURE CONTROL 12 OFF GAS START UP INSTRUCTIONS GAS MODE A. A continuous 12 volt DC supply must be available 1. Move the AUTO/GAS mode selector button (2) to the for the electronic control to function. UP position. The AUTO mode indicator lamp (A) will go off. Within 45 seconds the burner should be ignited B. Press the main power ON/OFF button (1) to the and operating normally. DOWN position. 2. If the CHECK indicator lamp
ページ10に含まれる内容の要旨
Refrigerator control panel A B ON AUTO CHECK AUTOMATIC REFRIGERATOR TEMPERATURE CONTROL 12 OFF GAS DESCRIPTION OF OPERATING MODES LIMP MODE OF OPERATION This control system contains a feature where it will con- AUTO MODE tinue to operate the cooling system in event of a failure When operating in the AUTO mode, the AUTO mode of a major operating component. indicator lamp (A) will illuminate. If the control cannot read the temperature sensor and The control system will automatically select between
ページ11に含まれる内容の要旨
When all the frost has melted, dry the interior of the re- HOW TO USE THE REFRIGERATOR frigerator with a clean cloth. Replace all food and turn your refrigerator back on. FOOD STORAGE COMPARTMENT The food storage compartment is completely closed and CLEANING unventilated, which is necessary to maintain the required Cleaning the refrigerator is usually done after it is defrosted low temperature for food storage. Consequently, foods or put into storage. To clean the interior liner of the re- havin
ページ12に含まれる内容の要旨
GAS EQUIPMENT ASSEMBLY NUT SOLENOID VALVE . THERMOCOUPLE INLET FITTING MANUAL SHUTOFF VALVE . Shown in open position SPARK ELECTRODE PRESSURE TEST PORT . BURNER TUBE FIG. 12 BURNER JET . BURNER MOUNTING SCREW ELECTRIC EQUIPMENT MAINTENANCE & SERVICE The user should be aware of service that must be CARTRIDGE HEATER done on a regular schedule to keep the refrigerator The heat necessary for the operation of an absorption operating properly. The service should only be per- cooling unit is supplie
ページ13に含まれる内容の要旨
B. Check all connections in the LP gas system (at the ! WARNING back of the refrigerator) for gas leaks. The LP gas supply must be turned on. Apply a non-corrosive DO NOT use a wire or pin when cleaning the burner bubble solution to all LP gas connections. jet as damage can occur to the precision opening. The appearance of bubbles indicates a leak and This can cause damage to the refrigerator or create should be repaired immediately by a QUALIFIED a fire hazard. SERVICEMAN WHO IS FAMILIAR WITH G
ページ14に含まれる内容の要旨
H. Burner not located properly under flue tube. PANEL DIMENSIONS Relocate. MAX. THICKNESS 5/32" (4 mm) I. Burner damaged. Replace. REFR. MODELS HEIGHT WIDTH J. Odor from fumes. TYPE MAX. MIN. MAX. MIN. 1. Dislocated burner RM2652 2. Damaged burner upper mm 403 401 527 524 3. Dirty flue tube inch 15-27/32 15-25/32 20-3/4 20-5/8 lower mm 827 825 527 524 K. FUSES inch 32-9/16 32-1/2 20-3/4 20-5/8 1. Refrigerator AC Supply 2. Refrigerator control system RM2852 upper mm 403 401 527 524 See page 12, p
ページ15に含まれる内容の要旨
1 1 1 2 3 3 1 1 1 4 5 CERTIFIED VENT SYSTEM KITS REFRIGERATOR KIT MODEL NO. COMPONENTS PART NO. RM2652 4A Roof Base 3103633.XXX* RM2852 Roof Cover 3103634.XXX* Lower Side Vent 3109350.XXX* * Fill in “XXX” with color code numbers. For color codes, contact your supplier. For further information contact your dealer or distributor. 15
ページ16に含まれる内容の要旨
Positioning of shelves Put a screwdriver into the slot of the shelf lock. Insert the ends of the wire shelf on the left-hand Turn the screwdriver counterclockwise. side at the desired position. Remove the shelf locks from the wire shelf. Slide the wire shelf to the left. Slide the shelf into the holes on the right-hand The right-hand side of the shelf will come loose. side. Lower the right-hand side of the wire shelf and Slide the plastic plugs into the holes of the wall. let the left-hand side
ページ17に含まれる内容の要旨
RM2652, RM2852 17
ページ18に含まれる内容の要旨
18
ページ19に含まれる内容の要旨
19
ページ20に含まれる内容の要旨
MO-FO 0327 20
