Dacor EF36LNFSSの取扱説明書

ページ1に含まれる内容の要旨

REFRIGERATOR MODELS: EF36LNFSS and EF36RNFSS
Preference™ Handle Kit, INSTALLATION
PN AFP36H2 INSTRUCTIONS
Tools Required
• 3/32” Allen wrench (not supplied)
• T20 Torx driver (EF36BNFSS Only)
Parts Included
Plastic Washers (4) Preference Style Handles (1 large, 1 small)
Installation Preparation:
Model EF36RNFSS shown
STEP 1: Using a T20 Torx driver, remove the four (4)
handle mounting studs from the front of the
refrigerator. Retain the mounting screws and
studs.
Existing handle
mountin

ページ2に含まれる内容の要旨

Refrigerator Handle Kit Installation Instructions STEP 2: Reinstall the the screws and studs removed in step 1, inserting the provided plastic wash- ers between the base of the studs and the refrigerator doors as shown. Model EF36RNFSS shown Plastic Washer Screw Mounting Stud Handle Mounting Stud Locations Bottom (Freezer) Handle Installation STEP 3: Find the smallest of the two handles in the kit box. STEP 4: Mount the handle to the bottom drawer by sliding the holes on the back over t

ページ3に含まれる内容の要旨

Refrigerator Handle Kit Installation Instructions Top Handle Installation STEP 7: Mount the handle to the top door by sliding the holes on the back over the handle mounting studs on the right door. Make sure the set screw holes face away from the center of the refrigerator. Loosen Set Screw Handle Mounting the set screws if necessary to al- Holes Studs low the handle to slide into place. STEP 8: Carefully tighten the set screws into place using the 3/32” Allen wrench. Be careful not

ページ4に含まれる内容の要旨

Dacor ● 1440 Bridge Gate Drive, Diamond Bar , CA 91765 ● T el: (800) 793-0093 ● F AX: (626) 403-3130 ● www .Dacor .com